0.010in-Shim_MITR.pdf
PDF 56 KB Posted
- Attached to
- HIP CAN Study
- Solicitation number
- 0000963801
- Issued by
-
Department of Energy
About this file
This is an engineering drawing for a mitred plate shim component. The part is manufactured from 1018 steel and measures 40.095±.005 inches in length by 6.07±.005 inches in width, with a 0.010-inch thickness. Four radius corners of R1.49 are specified, and all sharp edges must be broken. The part weighs 0.69 pounds and is identified by SAP number C67T01V0.
The drawing specifies four manufacturing and finishing requirements: (1) spray Neolube 1.1 lubricant on all surfaces per manufacturer's instructions and bake accordingly; (2) individually vacuum seal each part in 5-mil mylar bags or buyer-approved equivalent; (3) apply a 1x3 harsh environment thermal transfer label to each sealed bag containing the SAP number and serial number; and (4) electrochemically etch or laser engrave each part with the SAP number, lot number, and serial number in 0.13-inch-high characters with a depth not exceeding 0.002 inches, using the specified format (10-digit SAP number-5-digit lot number-8-digit serial number). Standard tolerances apply with angular tolerances of ±0.5 degrees and surface finish of 63 RMS microinches. The drawing was created by Fiona Gailey, reviewed by Dustin Clelland, and approved by Taylor Mason, with revision 0 dated 08/06/2026.
View the file
Other files
Show all 21
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
THIRD ANGLE PROJECTION
40.095±.005
6.07±.005
4x R1.49
.0100 REF
1. SPRAY NEOLUBE 1.1 ON ALL SURFACES UNLESS OTHERWISE NOTED PER MANUFACTURER’S DIRECTIONS, BAKE ALL PARTS PER MANUFACTURER’S INSTRUCTIONS.
2. INDIVIDUALLY VACUUM SEAL PARTS INDIVIDUALLY IN 5MIL MYLAR BAGS OR BUYER APPROVED EQUAL.
3. ADD SAP NUMBER AND SERIAL NUMBER TO EACH SEALED BAG WITH A 1 X 3 HARSH ENVIRONMENT THERMAL
TRANSFER LABEL OR BUYER APPROVED EQUAL.
4. ELECTROCHEMICALLY ETCH OR LASER ENGRAVE PARTS WITH SAP NUMBER, LOT, AND SERIAL NUMBER 0.13” HIGH AND NO MORE THAN 0.002" DEEP. FORMAT IS: 10 DIGIT SAP NUMBER - 5 DIGIT LOT NUMBER-8 DIGIT
SERIAL NUMBER (XXXXXXXXXX-XXXXX-XXXXXXXX) OR BUYER APPROVED EQUAL
0.010" THICKNESS - SHIM
MITR PLATE
C67T01V0
A A
B B
1018 Steel
ANGULAR ± 0.5
SURFACE FINISH
RMS
µ in
LENGTH
.0 = ±.1
.00 = ±.01 .000 = ±.005
.0000 = ±.005
PROJECT:
MATERIAL:
UNLESS OTHERWISE SPECIFED:
ALL DIMENSIONS ARE INCHES
STANDARD TOLERANCES: INCHES
NOTE: BREAK ALL SHARP EDGES
SHEET 1 OF 1SCALE: 1:5
0.69 lb
DRAWN BY: Fiona Gailey
TITLE:
APRROVED BY: Taylor Mason
REVIEWED BY: Dustin Clelland
DATE
REV.
SIZE
B
08/06/2026
SAP NUMBER:PART NUMBER:
XXXXX
WEIGHT:
08/06/2026
06/11/2026
| Sheet1 |
| Top |
| Front |
| ISO Veiw |
File details come from the government source that posted it. Updated .