0.001in-Shim_MITR.pdf
PDF 56 KB Posted
- Attached to
- HIP CAN Study
- Solicitation number
- 0000963801
- Issued by
-
Department of Energy
About this file
This is an engineering drawing for a mitered steel plate component designated as part number C67T04V0. The part is a 0.001-inch thickness shim fabricated from 1018 steel, measuring 40.095±0.005 inches in length and 6.07±0.005 inches in width, with four radius corners of 1.49 inches each. The component weighs 0.07 pounds and is drawn at a 1:5 scale on a single sheet.
The drawing specifies four critical manufacturing and finishing requirements. First, all surfaces must be sprayed with Neolube 1.1 lubricant and baked according to manufacturer's instructions. Second, individual parts must be vacuum sealed in 5-mil mylar bags or buyer-approved equivalent. Third, each sealed bag requires labeling with SAP number and serial number using a 1x3 harsh environment thermal transfer label. Fourth, parts must be electrochemically etched or laser engraved with identification markings in 0.13-inch height text format (10-digit SAP number, 5-digit lot number, and 8-digit serial number) with depth not exceeding 0.002 inches. Standard dimensional tolerances apply: ±0.1 inches for single decimal places, ±0.01 for two decimals, and ±0.005 for three or more decimals. All sharp edges must be broken, and surface finish is specified at 63 RMS microinches.
View the file
Other files
Show all 15
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
THIRD ANGLE PROJECTION
40.095±.005
6.07±.005
4x R1.49
.0010 REF
1. SPRAY NEOLUBE 1.1 ON ALL SURFACES UNLESS OTHERWISE NOTED PER MANUFACTURER’S DIRECTIONS, BAKE ALL PARTS PER MANUFACTURER’S INSTRUCTIONS.
2. INDIVIDUALLY VACUUM SEAL PARTS INDIVIDUALLY IN 5MIL MYLAR BAGS OR BUYER APPROVED EQUAL.
3. ADD SAP NUMBER AND SERIAL NUMBER TO EACH SEALED BAG WITH A 1 X 3 HARSH ENVIRONMENT THERMAL
TRANSFER LABEL OR BUYER APPROVED EQUAL.
4. ELECTROCHEMICALLY ETCH OR LASER ENGRAVE PARTS WITH SAP NUMBER, LOT, AND SERIAL NUMBER 0.13” HIGH AND NO MORE THAN 0.002" DEEP. FORMAT IS: 10 DIGIT SAP NUMBER - 5 DIGIT LOT NUMBER-8 DIGIT
SERIAL NUMBER (XXXXXXXXXX-XXXXX-XXXXXXXX) OR BUYER APPROVED EQUAL
C67T04V0
MITR PLATE
0.001" THICKNESS - SHIM
A A
B B
1018 Steel
ANGULAR ± 0.5
SURFACE FINISH
RMS
µ in
LENGTH
.0 = ±.1
.00 = ±.01 .000 = ±.005
.0000 = ±.005
PROJECT:
MATERIAL:
UNLESS OTHERWISE SPECIFED:
ALL DIMENSIONS ARE INCHES
STANDARD TOLERANCES: INCHES
NOTE: BREAK ALL SHARP EDGES
SHEET 1 OF 1SCALE: 1:5
0.07 lb
DRAWN BY: Fiona Gailey
TITLE:
APRROVED BY: Taylor Mason
REVIEWED BY: Dustin Clelland
DATE
REV.
SIZE
B
08/06/2026
SAP NUMBER:
XXXXX
WEIGHT:
08/06/2026
06/29/2026
PART NUMBER:
| Sheet1 |
| Drawing View1 |
| Drawing View2 |
| Drawing View4 |
File details come from the government source that posted it. Updated .