Attachment 61 - Section J.61 General Air Products Tank and Pump System for FEMA - Alarm Bar Installation Addendum - 1-24-17 Revision BB_005.pdf

Attachment 61 Section J.61

General Air Products Tank and Pump System for FEMA

– Alarm Bar Installation Addendum – 1/24/17, Revision

BB_005

Tank & Pump System for FEMA

Alarm Bar Installation Addendum – 1/24/17

Revision BB_005

For Technical Support, Call 1-800-345-8207

3.5.1.4 Install the Alarm Bar (shipped inside the TPS) to the outside wall opposite door.

NOTE: This operation takes one person and a ladder to install correctly.

Alarm Bar after Installation and Power is ON:

3.5.1.4.1A Hang the Alarm Bar on the center tabs as shown below. This step is temporary and allows you install the alarm bar without assistance.

3.5.1.4.1B Connect the yellow cord assembly. Align the connector and push together.

Ensure the two yellow connectors are fully connected. Then screw the black connectors together to secure the two yellow cords.

3.5.4.1.2 After you have securely connected the yellow cord, hook the top of the alarm bar to the pre-installed metal hooks located on the rear outside wall. After you hook the Alarm Bar to the two hooks, let the bottom section rest against the TPS wall.

3.5.4.1.3 Fasten the Alarm Bar bottom section to the wall using the tamper resistant screw installed in the threaded hole in the wall. You will need to use the supplied tool to remove the screw first, then secure the bottom section to the wall using the screw just removed.

Note: Green Power On light will not illuminate until power is turned on to the TPS. An illuminated green light is an indicator that that Alarm Bar is connected correctly.

For Technical Support, Call 1-800-345-8207