Attachment_0018__STATEMENT_OF_WORK_FOR_INERT_PROPELLING_CHARGES.pdf

08 March 2017

STATEMENT OF WORK FOR

INERT 60MM, 81MM, and 120MM PROPELLING CHARGES

1. OBJECTIVE

The objective of this Inert 60mm, 81mm, and 120mm Propelling Charge Statement of Work is to enable the USG to purchase INERT propelling charges in support of the ongoing Load, Assemble and Pack (LAP) IDIQ contracts being awarded. A deliverable under the LAP IDIQ contracts will be INERT end item charges as part of CLINs XXXX, XXXX, XXXX, and XXXX.

2. BACKGROUND

The USG requires inert 60mm, 81mm, and 120mm mortar propelling charges for use in inert propelling charge models that will be built as a requirement under the Propelling Charge IDIQ contract being awarded.

3. APPLICABLE DOCUMENTS

3.1 DRAWINGS

Drawings for the following components TDP’s are applicable for this SOW. The Drawing Numbers for the necessary required components are as follows:

Caliber Propelling Charge Drawing Number 60mm M204,M235,M236 9312698,12982841,13008610 81mm M218,M219,M220 9300234,9378134,9381510 120mm M234A1 13038372

3.2 MILITARY SPECIFICATIONS AND STANDARDS

MIL-DTL-32276 – CHARGE PROPELLING, M204/M235/M236 LOADING,

ASSEMBLING, AND PACKING, FOR THE 60MM PROPELLING CHARGE

MIL-DTL-70545A - CHARGE PROPELLING, M218/M219/M220 LOADING,

ASSEMBLING, AND PACKING, FOR THE 81MM PROPELLING CHARGE

DTL12977282 – CHARGE PROPELLING, M233/M234/M234A1 LOADING,

ASSEMBLING, AND PACKING, FOR THE 120MM PROPELLING CHARGE

MIL-DTL-32274 – CHARGE PROPELLING, 60/81/120mm, PARTS AND

CONTAINER ASSEMBLY

Attachment 0018

4. REQUIREMENTS

The quantity and delivery schedule for the inert ignition cartridges will be provided to the contractor upon award of the LAP Propelling Charge IDIQ contract by the USG. The 60mm, 81mm, and 120mm inert propelling charges are to be composed of the following components: 1 inert container assembly, 1 inert closure tab, and an inert propellant loaded to the nominal charge weight of each propelling charge specification. The 60mm, 81mm, and 120mm inert propelling charges shall be assembled as per their respective specification with the following exceptions: they shall be free of all energetic materials and therefore the final propelling charges are considered inert.

In place of the energetic materials, a simulant should be used for inert propellant in the propelling charges. The materials used for inert parts must be representative of the energetic materials in terms of weight and dimensions, as per their respective specification. Each propelling charge should be labeled with its respective propelling charge nomenclature and be labeled “INERT” along the top half of the propelling charge.

5. GFM:

GFM will not be provided during the performance of this SOW.

6. SHIPPING INSTRUCTIONS:

When quantities of each propelling charge are requested, items shall be shipped to the following address or other address provided at the time of awarding the quantities:

U.S. Army – SFAE-AMO-CAS ATTN: Kevin McDonnell / SFAE-AMO-CAS / Bldg 162 / Picatinny Arsenal Picatinny, NJ 07806-5000

Technical POC for this SOW is Kevin McDonnell, phone 973-724-1400.