10500.doc

SECTION 10500

PART 1

seq level2 \h \r0 GENERAL

1.1 Furnish and install metal lockers at the locations shown on the drawings.

1.2 Submittals: In accordance with Division 1. Manufacturer shall submit detailed elevation and layout drawings for review by the Contracting Officer.

PART 2

seq level2 \h \r0 PRODUCTS

2.1 Acceptable Manufacturers:

(a) Lyon

(b) Deborg

(c) Artmetal

2.2seq level3 \h \r0 Construction of Cabinets:

Formed 16 gauge cabinets - tops, bottoms, shelves, and tier dividers shall be constructed of solid 16 gauge sheet steel. Tops and tier dividers shall be constructed to form a continuous vandal resistant top strike of not less than 1/2".

(b) Side and intermediate partitions of 16 gauge formed cabinets shall be perforated with Diamond punching.

(c) Angle Iron Frame Cabinet - Frame to be 1"x1"x1/8" pickled steel angle iron.

(d) Side and Intermediate Partitions - 16 gauge solid sheet steel used for intermediate partitions and sides, welded to the 1"x1"x1/8" pickle steel angle iron frame.

2.3seq level3 \h \r0 Construction of Backs:

Backs shall be fabricated from 18 gauge sheet steel.

2.4seq level3 \h \r0 Construction of Doors:

14 gauge, one-piece doors constructed with double return on all sides.

2.5seq level3 \h \r0 Latching:

Magnetic or mechanical latching mechanism with recessed handle.

2.6seq level3 \h \r0 Hinges:

Full length 16 gauge piano hinge is welded to the locker door and riveted to the frame and door. When hinge is riveted to frame, steel rivets are not to exceed 4" center to center. Hinge crimped at every fifth knuckle to eliminate possibility of hinge pin being removed.

2.7seq level3 \h \r0 Number Plates:

Aluminum plates with 3/8" etched numerals shall be provided for each locker. Number sequence as directed.

2.8seq level3 \h \r0 Hooks:

Provide two single wall hooks and one double ceiling hook in each locker opening.

2.9seq level3 \h \r0 Sloped Tops:

Slope tops shall be constructed of solid 16 gauge sheet steel and shall be an integral, welded member of main locker unit. Sloping tops that are riveted or bolted to main locker unit are not acceptable. (NO SUBSTITUTION).

PART 3

seq level2 \h \r0 seq level3 \h \r0 EXECUTION

3.1 Install all lockers in accordance with manufacturer's requirements and approved shop drawings.

3.2 All units shall be to plumb and level.

3.3 Touch up all surfaces damaged during shipment or installation with factory supplied touch-up paint.

END OF SECTION

10500 - 1 H:\8348\8348003.23\Docs\B-3 Specs\Division 10\10500.doc November 1, 2005