09225.doc

SECTION 09225

PART 1

GENERAL

1.1 Include all labor, materials and equipment necessary for a complete installation as shown or specified.

1.2 Install all materials in accordance with manufacturer's requirements.

PART 2

PRODUCTS

2.1 Manufacturer: Milcor, Keene, Western Metal, or approved equal.

2.2 Wall track at ceiling and floor shall be 20 gauge with not less than 1-1/4" flanges and of proper width for studs selected.

2.3 Studs shall be 20 gauge. Contractor shall consult manufacturer's limiting height tables and shall adjust gauge as necessary to be in conformance therewith.

2.4 1-3/8" metal stud furring.

2.5 1 ½ x 16 gauge cold rolled channels.

2.6 7/8” furring channels.

2.7 Screws: 3/8" Type S, self drilling, self tapping, pan head.

2.8 9 gauge suspension wire (galvanized.)

2.9 Additional accessories, clips, braces, etc. as may be required by the manufacturer.

PART 3

EXECUTION

3.1 Attach framing securely to building structure. Fasten partition track at 2'-0" o.c. in accordance with manufacturer's requirements. Use fasteners suitable for material track is fastened to.

3.2 Provide double 20 gauge studs at all openings. Extend to structure above and integrally reinforce.

3.3 Coordinate with other trades for provisions for blocking, metal backing plates, special anchors, etc.

3.4 Install all components and accessories in strict accordance with the manufacturer's recommendations. Provide horizontal bridging at 48” o.c. vertical in all walls.

3.5 Provide for expansion and deflection of the building structure as recommended by the manufacturer.

END OF SECTION

09225 - 1 H:\8348\8348003.23\Docs\B-3 Specs\Division 9\09225.doc November 1, 2005