06402.doc

SECTION 06402

DIVISION 6

FINISH CARPENRTY AND MILLWORK

SECTION 06402

DIVISION 6

FINISH CARPENRTY AND MILLWORK

PART 1

GENERAL

a.

Scope: Furnish and install all millwork and finish carpentry shown on the drawings and specified herein.

b.

The Quality Standards of the Architectural Woodwork Institute (AWI) shall apply to all work covered by this section.

c.

Millwork fabricator shall submit detailed shop drawings to be approved by the architect before fabrication.

PART 2

PRODUCTS

a.

Exposed Cabinet Surfaces: ¾” laminate clad medium density fiber board.

b.

Semi-Exposed Cabinet Surfaces: ¾” laminate clad medium density fiber board.

c. Concealed Cabinet Shelving: ¾” laminate clad medium density fiber board.

d.

Storage Shelving: ¾” laminate clad medium density fiber board.

e.

Hardware:

(1) Pulls: Stanley 4483, Haffle, EPCO or approved equal

(2) Cabinet Hinges: Blum "Modul", 120 degree, Mepla, Grass or equal

(3) Finish: US 26D

f. Counter Tops:

(1) Counter tops shall be plastic laminate clad, 3/4" medium density fiber board with .02" laminate backer sheet.

g.

Plastic laminates shall be as manufactured by Wilson Art, Formica or Nevamar, 1/16" thick standard grade solid colors, unless noted otherwise, as selected by architect. Matte finish. Installation per all manufacturer's requirements. Front desk laminate may be from all available finishes and manufacturers (no premium textures).

PART 3

EXECUTION

a.

Details and Special Conditions: All cabinet work shall be flush overlay construction, Section 400G-2, AWI quality standards. No exposed substrate edges. Where details and methods of construction are not specifically shown on the drawings, contractor shall request clarification from the architect.

b.

Work assembled at mill as far as practical and delivered ready for installation. This contractor responsible for measurements taken at job allowing for cutting and fitting. Doors and drawers shall be aligned and flush, 1/8" maximum space between, Section 400A-T-1, AWI quality standards.

c.

All cabinet work shall be custom grade in accordance with the latest edition of The Architectural Woodwork Institute (AWI).

d.

Face frame shall be scribed where cabinet work abuts walls.

e.

This contractor shall install all finish hardware.

f.

Laminate application sequence:

Counter tops: Apply laminate to self edge first, then top surface with top surface overlapping self edge seam.

Doors: Apply edge band to all edges first then laminate each face with faces overlapping edge band.

END OF SECTION

06402 - 2 H:\8348\8348003.23\Docs\B-3 Specs\Division 6\06402.doc November 1, 2005 06402 - 1 H:\8348\8348003.23\Docs\B-3 Specs\Division 6\06402.doc November 1, 2005