Attachment 7 General Decision Number UT170057.pdf

General Decision Number: UT170057 03/10/2017 UT57

Superseded General Decision Number: UT20160057

State: Utah

Construction Type: Residential

County: Tooele County in Utah.

Note: Under Executive Order (EO) 13658, an hourly minimum wage of $10.20 for calendar year 2017 applies to all contracts subject to the Davis-Bacon Act for which the contract is awarded (and any solicitation was issued) on or after January 1, 2015. If this contract is covered by the EO, the contractor must pay all workers in any classification listed on this wage determination at least $10.20 (or the applicable wage rate listed on this wage determination, if it is higher) for all hours spent performing on the contract in calendar year 2017.

The EO minimum wage rate will be adjusted annually. Additional information on contractor requirements and worker protections under the EO is available at www.dol.gov/whd/govcontracts.

Modification Number Publication Date 0 01/06/2017 1 03/10/2017

ENGI0003-052 07/01/2013

Rates Fringes

OPERATOR: Power Equipment

(1) Mechanic...............$ 27.55 15.65 (2a) Blade/Grader...........$ 25.89 15.65

(3) Backhoe/Excavator, Front End Loader (Over 5

cu. yds. )..................$ 25.37 15.65

(4) Asphalt Paver, Backhoe Loader Combo, Bulldozer, Front End Loader (2 to 5 cu. yds.), Oil Distributor.............$ 24.37 15.65

(5) Asphalt Roller, Front End Loader (Under 2 cu.

yds.).......................$ 23.37 15.65

(6) Screed..................$ 22.41 15.65

(7) Roller (Dirt and Grade Compaction).................$ 21.50 15.65

LABO0295-020 07/01/2012

Rates Fringes

LABORER

Chain/Concrete Saw, Jackhammer and Vibrator.....$ 18.63 6.35

PLAS0568-001 07/01/2016

3/30/2017https://www.wdol.gov/wdol/scafiles/davisbacon/UT57.dvb?v=1

Rates Fringes

CEMENT MASON/CONCRETE FINISHER...$ 24.10 9.90

PLUM0140-016 08/01/2013

Rates Fringes

PLUMBER (Excluding HVAC Pipe Installation)....................$ 25.30 9.98

SFUT0669-002 01/01/2016

Rates Fringes

SPRINKLER FITTER.................$ 31.14 17.70

* TEAM0222-018 07/01/2016

Rates Fringes

TRUCK DRIVER (Articulated).......$ 23.64 11.07 TRUCK DRIVER (Concrete Pumping).........................$ 21.30 11.07 TRUCK DRIVER (Dump Truck, Bottom-end or side) Less than 8 cu. yds.........$ 21.07 11.07 8 cu. yds. to less than 14

cu. yds.....................$ 21.22 11.07 14 cu. yds. to less than 35 cu. yds..................$ 21.37 11.07 35 cu. yds. to less than 55 cu. yds..................$ 21.57 11.07 55 cu. yds. to less than 75 cu. yds..................$ 21.77 11.07 75 cu. yds. to less than 95 cu. yds..................$ 21.97 11.07 95 cu. yds. to less than 105 cu. yds.................$ 22.17 11.07 105 cu. yds. to less than 130 cu. yds.................$ 22.29 11.07 TRUCK DRIVER (Flat Rack, Bulk Cement, Semi-Trailers, Mud/Banding and Paint) Less than 10 tons...........$ 20.97 11.07 10 tons to less than 15 tons........................$ 21.12 11.07 15 tons to less than 20 tons........................$ 21.22 11.07 20 tons and over............$ 21.37 11.07 Pickup Truck................$ 20.90 11.07 TRUCK DRIVER (Lowboy)............$ 24.14 11.07 TRUCK DRIVER (Oil Spreader)......$ 21.77 11.07 TRUCK DRIVER (Tiremen and Greaser).........................$ 21.47 11.07 TRUCK DRIVER (Transit Mix) 0 cu. yds. to 8 cu. yds.....$ 21.30 11.07 Over 8 cu. yds. to 14 cu.

yds.........................$ 21.40 11.07

TRUCK DRIVER (Water, Fuel & Oil Tank) less than 1,200 gal.........$ 20.95 11.07 1,200 gal. to less than 2,500 gal...................$ 21.07 11.07 2,500 gal. to less than 4,000 gal...................$ 21.22 11.07 4,000 gal. to less than 6,000 gal...................$ 21.52 11.07 6,000 gal. to less than 10,000 gal..................$ 21.77 11.07 10,000 gal. to less than 15,000 gal..................$ 22.02 11.07 15,000 gal. to less than 20,000 gal..................$ 22.27 11.07 20,000 gal. to less than 25,000 gal..................$ 22.62 11.07 25,000 gal. and over........$ 22.77 11.07

SUUT2008-051 08/28/2008

Rates Fringes

BRICKLAYER.......................$ 17.92 0.00

CARPENTER, Includes Metal Stud Installation, and Siding Installation (Excludes Drywall Hanging).................$ 15.26 0.00

DRYWALL FINISHER/TAPER...........$ 17.90 1.96

DRYWALL HANGER...................$ 18.82 0.00

ELECTRICIAN......................$ 16.06 1.97

LABORER: Asphalt Raker..........$ 13.00 0.00

LABORER: Asphalt Shoveler.......$ 12.95 0.00

LABORER: Common or General......$ 11.54 3.63

LABORER: Landscape..............$ 10.00 0.19

LABORER: Mason Tender - Cement/Concrete..................$ 12.95 0.00

LABORER: Mason Tender (Brick and Hod).........................$ 12.00 0.00

OPERATOR: Trackhoe..............$ 14.89 0.00

PAINTER: Brush, Roller and Spray, Excludes Drywall Finishing/Taping.................$ 11.23 0.00

ROOFER...........................$ 17.14 0.00

SHEET METAL WORKER, Includes HVAC Duct, Pipe and Unit

Installation.....................$ 15.31 0.00

WELDERS - Receive rate prescribed for craft performing operation to which welding is incidental.

Note: Executive Order (EO) 13706, Establishing Paid Sick Leave for Federal Contractors applies to all contracts subject to the Davis-Bacon Act for which the contract is awarded (and any solicitation was issued) on or after January 1, 2017. If this contract is covered by the EO, the contractor must provide employees with 1 hour of paid sick leave for every 30 hours they work, up to 56 hours of paid sick leave each year.

Employees must be permitted to use paid sick leave for their own illness, injury or other health-related needs, including preventive care; to assist a family member (or person who is like family to the employee) who is ill, injured, or has other health-related needs, including preventive care; or for reasons resulting from, or to assist a family member (or person who is like family to the employee) who is a victim of, domestic violence, sexual assault, or stalking. Additional information on contractor requirements and worker protections under the EO is available at www.dol.gov/whd/govcontracts.

Unlisted classifications needed for work not included within the scope of the classifications listed may be added after award only as provided in the labor standards contract clauses (29CFR 5.5 (a) (1) (ii)).

The body of each wage determination lists the classification and wage rates that have been found to be prevailing for the cited type(s) of construction in the area covered by the wage determination. The classifications are listed in alphabetical order of "identifiers" that indicate whether the particular rate is a union rate (current union negotiated rate for local), a survey rate (weighted average rate) or a union average rate (weighted union average rate).

Union Rate Identifiers

A four letter classification abbreviation identifier enclosed in dotted lines beginning with characters other than "SU" or "UAVG" denotes that the union classification and rate were prevailing for that classification in the survey. Example:

PLUM0198-005 07/01/2014. PLUM is an abbreviation identifier of the union which prevailed in the survey for this classification, which in this example would be Plumbers. 0198 indicates the local union number or district council number where applicable, i.e., Plumbers Local 0198. The next number, 005 in the example, is an internal number used in processing the wage determination. 07/01/2014 is the effective date of the most current negotiated rate, which in this example is July 1, 2014.

Union prevailing wage rates are updated to reflect all rate changes in the collective bargaining agreement (CBA) governing this classification and rate.

Survey Rate Identifiers

Classifications listed under the "SU" identifier indicate that no one rate prevailed for this classification in the survey and the published rate is derived by computing a weighted average rate based on all the rates reported in the survey for that classification. As this weighted average rate includes all rates reported in the survey, it may include both union and non-union rates. Example: SULA2012-007 5/13/2014. SU indicates the rates are survey rates based on a weighted average calculation of rates and are not majority rates. LA indicates the State of Louisiana. 2012 is the year of survey on which these classifications and rates are based. The next number, 007 in the example, is an internal number used in producing the wage determination. 5/13/2014 indicates the survey completion date for the classifications and rates under that identifier.

Survey wage rates are not updated and remain in effect until a new survey is conducted.

Union Average Rate Identifiers

Classification(s) listed under the UAVG identifier indicate that no single majority rate prevailed for those classifications; however, 100% of the data reported for the classifications was union data. EXAMPLE: UAVG-OH-0010 08/29/2014. UAVG indicates that the rate is a weighted union average rate. OH indicates the state. The next number, 0010 in the example, is an internal number used in producing the wage determination. 08/29/2014 indicates the survey completion date for the classifications and rates under that identifier.

A UAVG rate will be updated once a year, usually in January of each year, to reflect a weighted average of the current negotiated/CBA rate of the union locals from which the rate is based.

WAGE DETERMINATION APPEALS PROCESS

1.) Has there been an initial decision in the matter? This can be:

* an existing published wage determination

* a survey underlying a wage determination

* a Wage and Hour Division letter setting forth a position on a wage determination matter

* a conformance (additional classification and rate) ruling

On survey related matters, initial contact, including requests for summaries of surveys, should be with the Wage and Hour Regional Office for the area in which the survey was conducted because those Regional Offices have responsibility for the

Davis-Bacon survey program. If the response from this initial contact is not satisfactory, then the process described in 2.)

and 3.) should be followed.

With regard to any other matter not yet ripe for the formal process described here, initial contact should be with the Branch of Construction Wage Determinations. Write to:

Branch of Construction Wage Determinations Wage and Hour Division U.S. Department of Labor 200 Constitution Avenue, N.W.

Washington, DC 20210

2.) If the answer to the question in 1.) is yes, then an interested party (those affected by the action) can request review and reconsideration from the Wage and Hour Administrator (See 29 CFR Part 1.8 and 29 CFR Part 7). Write to:

Wage and Hour Administrator U.S. Department of Labor 200 Constitution Avenue, N.W.

Washington, DC 20210

The request should be accompanied by a full statement of the interested party's position and by any information (wage payment data, project description, area practice material, etc.) that the requestor considers relevant to the issue.

3.) If the decision of the Administrator is not favorable, an interested party may appeal directly to the Administrative Review Board (formerly the Wage Appeals Board). Write to:

Administrative Review Board U.S. Department of Labor 200 Constitution Avenue, N.W.

Washington, DC 20210

4.) All decisions by the Administrative Review Board are final.

END OF GENERAL DECISION