15450.doc

96-620

00-32 07-733 07-743

SECTION 15450 - PLUMBING FIXTURES AND TRIM

PART 1 GENERAL

1.1

WORK INCLUDED

A.

Furnish and install all plumbing fixtures noted on the drawings or described herein.

B.

Provide and install all traps, stops, supply risers, etc., to laboratory equipment except where these accessories are furnished as part of the laboratory equipment.

1.2

SUBMITTAL DATA

A.

See SECTION 15000 for general submittal requirements.

B.

Provide submittal data for any materials or equipment specified in this Section as listed on the Submittal Schedule (see SECTION 15000) and any special or additional data as requested by the Contracting Officer.

C.

Submit complete manufacturer's literature for all fixtures, trim, stops, carriers and other accessories.

1.3

COORDINATION

A.

Cooperate in the installation of all fixtures with the General Contractor so that provisions can be made for required cutting and patching, solid backing for mounting fixtures, chair carriers, shower units, drains, etc., and proper elevation for setting roof and floor drains.

B.

Provide the necessary drawings, dimensions and instructions for proper installation of all fixtures and trim.

1.4

COMPLIANCE

A.

Fixtures and their installation shall comply with applicable plumbing codes, A.N.S.I. standards and A.D.A. requirements.

PART 2 PRODUCTS

2.1

MATERIALS

A.

Fixtures and their trim shall be complete in every respect, including such items as escutcheons, hanger plates, bolts, supplies, stops, traps, etc.

B.

See the "Plumbing Fixture Schedule" on the drawings or notes on the drawings for fixture types.

C.

Equivalent items of manufacturers listed herein may be used in lieu of items of the manufacturer specified if approved by the Contracting Officer. Contractor must list all variations and exceptions between specified items and substitute manufacturer's items on the shop drawings. Substitute items must be equal or superior in quality to that specified.

1.

Floor drains: Josam, J.R. Smith, Wade, Zurn.

PART 3 EXECUTION

3.1

INSTALLATION

A.

All fixtures shall be installed to meet manufacturer's recommendations and local codes.

B.

Set floor and roof drains in place, level and at proper elevation for drainage specified. Set grate flush with floor so water can drain to fixture.

C.

Indirect waste piping shall be securely mounted and supported.

END OF SECTION 15450

PACKAGE M OUTBUILDING RENOVATION NIH-NIAID RML HAMILTON, MT

PLUMBING FIXTURES AND TRIM 15450-2

RML AUTOCLAVE REPLACEMENT ( NIH-NIAID RML ( HAMILTON, MT

PLUMBING FIXTURES AND TRIM 15450-1