Hazmat Briefing 1-27-10.pptx

Albany, California Facility Hazardous Materials Work Presented by: Eloy F. Cisneros, CMC, CAC, CLIA Director of Industrial Hygiene

Notes:

Hazardous Materials:

Asbestos containing materials Lead containing paints and coatings Universal wastes PCB ballasts Mercury tubes

Albany, CA Facility

Hazardous Materials:

Pre-construction submittals Work plan Disposal plan Certifications/licenses

Asbestos Regulations:

The handling, disturbance, removal and disposal of asbestos is regulated by the EPA and OSHA.

EPA:

BAAQMD – NESHAP Regulation CAL-EPA DTSC – Hazardous Waste

OSHA

DOSH (Cal-OSHA) – Construction Standard

Asbestos On-Site:

Identified materials:

Textured Flooring Pipe Insulation Materials 2” to 8” diameter Wallboard and Joint Compound TransiteTM Fume Hoods Cold Room Insulation Coatings (Various) Autoclave Insulation Additional suspect materials in un-surveyed/ un-impacted areas

All construction-impacted materials will be removed.

Asbestos Controls:

Strict Specifications and Strict Enforcement Restricted work areas Signs Barriers Negative-Pressure Containments Glove-bags Decontamination units

Asbestos Work Practices:

Challenge tested H.E.P.A. Filtration Certified Asbestos Workers Competent Person Wet Methods (Surfactants) Prompt Cleanup Continuous Project Oversight and Air Monitoring

Asbestos Monitoring:

Inspect/Smoke Test Containment Verify Negative-Pressure Continually Coordinate with W.R.R.C. Facilities’ Staff Third-Party Oversight of Procedures CAC/SST with “Stop-Work Authority” Daily Perimeter PCM Air Monitoring On-Site Reading of Perimeter Samples Visual Inspection and PCM Clearances

Lead Regulations:

The handling, disturbance, removal and disposal of lead is regulated by the EPA and OSHA.

EPA:

DPH – Lead Hazards CAL-EPA DTSC – Hazardous Waste

OSHA

DOSH (Cal-OSHA) – Construction Standard

Lead On-Site:

All Coatings Tested had Detectable Lead LBP is > 5000 PPM or >1.0mg/cm2 Paint Chip Samples Ranged 114 ppm to 176,000 ppm XRF Samples Ranged from below detectable limit to >9.9 mg/cm2 Additional suspect materials in un-surveyed/ un-impacted areas

All construction-impacted coatings will be removed.

Lead Controls/Work Practices:

Strict Specifications and Strict Enforcement Restricted work areas Signs Barriers Containments Decontamination units Challenge Tested HEPA Filtration Continuous Project Oversight and Monitoring

Lead Monitoring:

Inspect Containment Third-Party Oversight of Procedures DPH I/A or PM with “Stop-Work Authority” Daily Perimeter Monitoring Quick Laboratory Turn-Arounds Visual Inspection and Wipe-Sample Clearances

Thank You !

image1.png image2.png image3.jpeg image4.jpeg image5.jpeg image6.jpeg image7.jpeg