RFPAttachment17(SampleTask).doc

Attachment 17

SAMPLE TASK

W9124J-12-R-0015

We require a 30’ x 50’ metal building to be used as a classroom. The building design shall meet all applicable construction and safety codes and design standards. The following is all the information on the sample project that will be provided [see Section L, Technical/Management Approach, Subfactor 1E entitled Acceptable Comprehension of Requirements].

The contractor’s proposal shall identify major design considerations (e.g., foundation cross section and piers, electrical loading and subsequent panel / service entrance sizes, etc.), and, assuming the design has been approved, provide a resultant proposed major item quantity take-offs. The final part of the proposal will be the cost proposal pulling cost line items from 2012 RS MEANS cost data and applying a fictitious coefficient of 1.10. For the purposes of this exercise, P.E. prepared documentation is not required.

The following are the requirements:

Pre-engineered metal building. 30’ x 50’, 26 gauge metal walls and roof, 12 ft. eave height, roof live load 30 psf, 20 psf snow load, and 2 psf dead load. Wind speed 100 MPH. 4 to 12 roof pitch, insulated building concrete floor, reinforced, over compacted gravel base.

2 personnel doors 3’ x 7’ Std. Panic hardware, locksets, and trim, one door at each end of the building finishes:

walls- drywall and painted doors and frames - metal and painted floors – VCT w/ 4” vinyl wall base

6 insulated windows, DH operable 2’x 3’

Suspended lay-in ceiling with 2x2 fluorescent lighting for classroom use

1 unisex latrine with standard accessories (handicap accessible) i.e. sink, mirror, toilet paper dispenser, etc.

heated and A/C all utilities are within 50’ of the building