224112 Chain Link Fence- SOW- REVISED.pdf

DIRECTORATE OF PUBLIC WORKS

CAMP BLANDING JOINT TRAINING CENTER

FLORIDA ARMY NATIONAL GUARD

5629 STATE ROAD 16 WEST, BUILDING 2300

STARKE, FLORIDA 32091-9703

CBJTC-DPW 21 January 2026

MEMORANDUM FOR: Environmental Review

SUBJECT: SCOPE OF WORK 224112 CBJTC SR 16 Chain Link Fence Replacement

Remove and replace approximately 5,784 LF of chain-link fencing, terminal post, line post, barbed wire, and (2) 30’ ft. manually operated cantilever gates.

New fencing will be installed in accordance with USACE FE6-TR-72 Chain-Link Security Fence specifications and CBJTC Fencing Standards.

• The new fencing and gates will be black vinyl, 6’-0” high with 1’-0” of barb wire with black vinyl coating above fence.

• All gates to be replaced with the same configuration as existing.

• All gates will be manually operated.

• All fence post will be set in concrete

• Fencing to have horizontal cross bar at top and tension wire at the bottom.

ABI 1 - The new fencing and gates will be black vinyl, 7’-0” high with 1’-0” of barb wire with black vinyl coating above fence.

Design services were not utilized for this project.

Suzanne D. McRee Project Manager

Attachments:

•USACE FE6-TR-72 Chain-Link Security Fence specifications •CBJTC Design and Construction Standards •Project Site Map •Project Utility Map

5,784 LF Chain Link Fencing

LEGEND

(2) 30’ Cantilever Gates

224112 CBJTC SR 16 Chain Link Fence Replacement

CAMP BLANDING

FACILITIES DESIGN

AND

CONSTRUCTION

STANDARDS

DEPARTMENT OF PUBLIC WORKS

CAMP BLANDING JOINT TRAINING CENTER

FLORIDA ARMY NATIONAL GUARD

5629 STATE ROAD 16 WEST

BUILDING 2067

STARKE, FLORIDA 32091

APRIL 2021

CAMP BLANDING FACILITIES DESIGN AND CONSTRUCTION STANDARDS

DIVISION 2 - SITE WORK

SECTION 02444 - CHAIN-LINK FENCING AND GATES

1. MATERIALS / INSTALLATION

A. Construction Fencing: Construction fencing is not required on post. Site and materials security is the sole responsibility of the Contractor. If desired, the Contractor may provide eight foot tall temporary chain-link fencing with secured post and lockable gates around all construction sites and storage areas. The fencing shall be installed plumb, level and secured to avoid the top of the fencing from leaning outward into pedestrian circulation paths. All exposed sharp edges shall be folded over to avoid the potential for inflicting injury.

B. Movable temporary chain-link fence panels are allowed to be used during construction with approval of the CBJTC Project Manager. When using movable panels, care must be taken to avoid protrusion and tripping hazards presented by the “Feet” of the fence support panels.

C. Fencing: When used on Post, chain-link fencing shall have hot dipped galvanized schedule 40 tubular steel framing, a top rail and bottom tension wire. The terminal post shall be a minimum of 2-1/2” outside diameter. The line post shall be a minimum of 2” outside diameter. The gate post shall be a minimum of 3” outside diameter. The top rails and bracing shall be a minimum of 1-1/2” outside diameter. All gate post and line post shall be installed in concrete with the top of the concrete being level with grade and crowned for drainage. The chain-link fabric shall be galvanized/black vinyl coated 2” mesh with tension wire at bottom. Mesh will be attached to posts and rails with 9 gage steel wire. All accessories shall be provided for a complete operation and as required for reinforcement. In general, fencing shall slope to follow the ground plane.

D. High-Security Chain Link Fencing: Security-type fence must be at least 6 feet high, galvanized/black vinyl coated nine gauge, chain-link metal fabric with twelve inch high, three-strand four-point barbed wire 45 degree anti-climbers to enclose the secure areas.

Vehicle gate(s) may be swinging or rolling. The following areas should be provided with security fencing: military vehicle parking; fuel storage and dispensing systems; service and access aprons; aircraft parking; wash platforms; lubrication and inspection racks;

covered, unheated storage; cannibalization areas; and loading ramps. Fencing should be located no more than five feet from the edge of the paved areas unless safety or security demands a greater distance.

E. Gates: Where required, gates will be installed to accommodate passage of vehicles and/or personnel. Gates shall be sized to allow access by CBJTC Maintenance equipment and military vehicles. Coordinate gate sizes with CBJTC-DPW. Gates shall be constructed in the same manner as surrounding fencing unless otherwise directed by

CBJTC.

END OF SECTION 02444

CHAIN-LINK FENCING AND GATES 02444-1

1626755697.NFG

Highlight

1626755697.NFG

Highlight

D

C

TRUSS ROD ANO BAND

A

BAA8EO-WIRE APRON Or.I

EXTEHSION AAMS

10°-0" MAXIMUM

CHAIN-LINK SECURITY FENCE DETAIL

<-::l),..�, I""'\,''""°" ...

�CAARIAGE80t.l

BRACE RAIL CLAMP DETAILS_

'2!!;.

P�OC 81tQC[ PANEL WHENE\'CR STIIAICHT RUNS CXCEEO 500 rccr.

ENO OR GATE POST DETAIL_

TENSION BAND OEfAIL_

FASTENING DETAlLS.

��cw, � srru CAOUND

GROUNDING DETAIL

rtNCE POSl f8 AWC SOlJO COPPER

\\1RE

MOLOEO [XOTH[RM•C WELD

OR APPROVED ClAW'-TYPE FIT!INC or COPPER

9-0AG£Slttl.Tl[ WIR[S

(2·-0• O.C. MAX.}

9-GAGE STEt:� TlE WIRE (l!t O.C.

W.X. ANO WITH:N

-4" FROM TOP ANO

80TT0t.l or rASRIC)

UNE PQ§T ATTACHMENT§

EXTENSION ARM DETAILS_

ND SCAlE

USEAtfJSECTION

COANCR, ENO & PUU. POSTS

STEELPOSTOCHEDULE

MINIMLN OIJTStDEDIMENSIONS (NOMINAL)

FABRIC LESS 'THAN 7T FABRIC 7Z' TO 915" FABRIC OVER 98"

TUBULAR - ROUNO 2,J7S" 0,0. 2.87!)"0.0,

2.50" so.

J.50" X 3.50"

4.00" 0.0.

J.oo· so. TUBULAR - SOUAFI£ 2.ocr so.

C-S[CTION (ROLL-FOAM[O) J,50" X .l.50"

H-SCCTION

C-SECTION (ROU.-FORMEO)

TOP. BOTTOM & BRACE AALS

Tl.leUI.AR - ROONO TUBULAA -Sou..RC

N-SCCTION

C-SECTION (ROU.-FOAMEO)

9-(;AG[ STCCl TI[

�!'.(1!1"0.C. MAX.

A."10 WITHIN 4" HIOM

TOP ANO 90TTOM

Of'FAEIRICJ

1.90" o.o.

2.2s·x1.10· l.87S"Xl.625"

2.J75" 0.0.

2.2s·x1.10· 2.2s·x1.10·

1.66" o.o.

1.so· o.o.

1.e2s·x1,so• 1,62S"X1.2!'.i"

2.875"0.0.

2.2s·x10·

I. 0£T�LS SHOWN AR[ TO CLARIFY R[OUIREM[NTS ANO AR[ NOT INTENO[O TO

UMIT 0Tt£R TYPES OF' FENCE SECTIONS � M[lllOOS Of' INSTAU.AllON.

2. WIR[ TIES. RAC;, POSTS. ANO CRi.CES SWJ.L 8[ CONSTRVCTECI ON TH[ S[CUR[ SIi)[ or THE FENCE AUCNMEHT. CHAIN-UNI( FABRIC SHAlL BE PLACED ON THE

�POSIT[ SID[ OF THC SECURE ARE,\.

3. UNLESS SF'E:�ICM.I.Y SHOWN OR SPcc.-ico. ALL FE6 FENCE SHALL HAYE 1'N APRON EXTENOEO OUTWARO FROM THE ARCA BEINC PROT[Cl[O.

4. C-SECTION POSTS SHAU. BE INSTAU.£0 SO THAT TH[ \()10 INSIOE TH£ POST

IS COMPLETO..Y ALLEO WITH CONCRETE UP TO THE TOP or TH[ rouNOATION.

FENCE I EGENP·

Tl'P[ res - CI-WN-LINI( ftNC[ WITHOUT 8AR8E0-Wfi[ APRON TYPE f[6 - CHAIN-LINI< r[MC[ W/8ARBE0-WIR[ ON SINCL[ OUTRICCt:R TYPE rE7 - CHAIN-UNI< FENCE W/8AABEO WIRE ON OOU8L[ OUTRICCCR Wf'[ F[8 - CHAIN-UNI< FfNC[ W/8AR8[0-WIRC ANO 8AA8E0-TAP[ ON OOUBl[

OVTRICCER

TR - FENCE WITH TOP RAIL MIO TENSION WIR[ AT BOTTOr.l TER - FENCE WITH TOP NfO BOTTOM RNlS TW8 - TtHSION -.,1RE TOP ANO BOTI'OM TWBR r FENCE WITH TOP TENSION WIRE ANO BOTTOM RAIL FINAL NUVO(R IS FABRIC YIIOTtl IN !NCH[S.

E.�ES

FE6-TR-72 - CHAIN-UNI< SCCURITY FENCE WITH l!AABEO-WIRE ON SINCL[

OUTRIGCER. TOP RM.. A"IO 72 INCH FA8R1C WIDTH .

H5-TY,1:1-48 - Ct'.AIN-UNIC SECURITY FENCE WITH NO PPROH, TOP ,oNO BOTTOM TENSION WIR[. ANO 48 INCH r,oaRIC WIDTH, $$ -THINK VALUE ENGINEERING-$$

U.S.-lk»NeutOISl'RICT CO!l"Of'IENGINESl8

D

C

' A STANDARD oeTAILSFORCHAlf4.LINK

SECURITY FeNCES

AND FARM STYLE R:NCES

FES CHAIN-LINK

SECURITY FENCE DETAILS

1511372883.NFG

Highlight

*GATE LENGTH AND SIZE COULD CHANGE PER PROJECT