DWG 2200264-A.pdf

CAGE CODE 0WY55 DWG NO. 2200264 SHEET 1 OF 3

APPLICATION

NHA USED ON LTR DATE ECO ECP REVISION DESCRIPTION APVD

2320208 2320211

WSR-88D A 070322 ECP 0232

ECO A03268 INITIAL RELEASE C.W.F.

VENDOR ITEM CONTROL DRAWING

DISTRIBUTION STATEMENT A: APPROVED FOR PUBLIC RELEASE; DISTRIBUTION IS UNLIMITED.

UNLESS OTHERWISE SPECIFIED

DIMENSIONS ARE IN INCHES

TOLERANCES ON:

WSR-88D RADAR OPERATIONS CENTER

3200 MARSHALL AVENUE

NORMAN, OKLAHOMA 73072-8032

NOMENCLATURE

MILLIMETERS

1 PL ±

2 PL ±

ANGLES ± 2°

INCHES

2 PL ± .02

3 PL ± .005

APPROVALS

DWN JCK 070320 RMT JWG 070322

CHK AWB 070322 DOC ARC 070322

ENGR CWF 070322 CM

QA ROC CMJ 070322

THUMBSCREW, CAPTIVE

SIZE CAGE CODE DWG NO. REV

A 0WY55 2200264 A

SCALE: NONE SHEET 1 OF 3

CAGE CODE 0WY55 DWG NO. 2200264 SHEET 2 OF 3

GENERAL NOTES:

1. INTERPRET THIS DRAWING IN ACCORDANCE WITH ASME Y14.100.

1.1. IDENTIFICATION OF ANY SUGGESTED SOURCE OF SUPPLY (MANUFACTURER) CONTAINED IN THIS

SPECIFICATION IS NOT TO BE CONSTRUED AS A GUARANTEE OF PRESENT OR FUTURE AVAILABILITY

AS A SOURCE OF SUPPLY FOR THE ITEM(S).

1.2. THE USE OF A DIFFERENT PART FROM A LISTED SUGGESTED SOURCE OF SUPPLY OR A PART FROM A

NON-LISTED SUGGESTED SOURCE OF SUPPLY WHICH MEETS THE SPECIFICATIONS HEREIN SHALL OCCUR ONLY AFTER REVIEW/CONCURRENCE AND A FIRST ARTICLE QUALIFICATION BY THE WSR- 88D RADAR OPERATIONS CENTER (ROC) AS WELL AS ACCEPTANCE INSPECTION BY THE NATIONAL

RECONDITIONING CENTER (NRC).

2. REQUIREMENTS:

2.1. THUMBSCREW, STEEL FOR CABLE CONNECTOR.

2.2. MATERIAL: STEEL, STAINLESS, 18-8 WITH NO ADDITIONAL FINISH.

2.3. THREAD: PER FIGURE 1.

2.4. THUMBSCREW MAY BE SLOTTED FOR USE WITH A FLATHEAD SCREWDRIVER.

2.5. THUMBSCREW IS KNURLED OVER AT LEAST 0.50 INCHES AS SHOWN IN FIGURE 1.

2.6. OUTLINE: PER FIGURE 1.

2.7. PART IDENTIFICATION:

2.7.1. VENDOR IDENTIFICATION AND VENDOR PART NUMBER TO BE APPLIED BY VENDOR.

3. PROCURING AGENCY:

3.1.1. THE PROCUREMENT AGENCY RESERVES THE RIGHT TO PERFORM ANY INSPECTION DEEMED

NECESSARY TO BE ASSURED THE PARTS CONFORM TO THE SPECIFIED REQUIREMENTS.

4. THE PART NUMBER IS THE DRAWING NUMBER SUFFIXED WITH THE APPLICABLE DASH NUMBER

SHOWN IN TABLE II.

5. SUGGESTED SOURCE(S) OF SUPPLY (MANUFACTURER(S)):

DATA ACCESS (CAGE CODE 0YW95)

PARAMUS, NJ

PART NO.: PER TABLE II

TABLE II

DASH

NO.

MFR.

PART NO.

201 RD0035

SCALE: NONE SHEET 2 OF 3

CAGE CODE 0WY55 DWG NO. 2200264 SHEET 3 OF 3

6. FIGURES AND DIAGRAMS

SCALE: NONE SHEET 3 OF 3