Attachment_4_Training.docx

TRAINING REQUIREMENTS

I. Firearms (Handgun) Training:

Contractor-provided firearms training to all newly assigned personnel upon initial hiring and annual re-certifications are required before assuming duties. Provided below are the FPS Practical Pistol Course requirements.

Firearm: Contractor-authorized duty handgun Equipment: Belt, holster and magazine holders Ammunition: 75 Rounds of type (semi-automatic service pistol used by Contractor) ammunition for target qualifications and training

Target: Trans-II, NRA B-27 silhouette or ICE target (determined by Contractor)

Commands: Range commands shall be determined by the range officer and/or the firearm instructor. Contractor must maintain and provide per request of the COR proof of certification for the Firearms Instructor.

Consideration shall be given to the available physical facilities, i.e., facing targets, light signals, audible by either by a voice or whistle, etc. All stages will be fired as a hot range. Once prepared for duty carry, the shooter will be responsible for maintaining full magazines throughout the course of fire, reloading on command and/or when otherwise necessary.

Marksmanship Ratings:

A total of fifty (50) rounds will be fired with a maximum possible score of two hundred fifty (250) points. Minimum qualification score is two hundred (200) out of two hundred fifty (250) for eighty (80%) percent.

Marksmanship Ratings: 220-230 = Marksman 231-240 = Sharpshooter 241-249 = Expert 250 = Distinguished Expert.

three (3) seconds, and re-holster. Draw and fire three (3) rounds in three (3) seconds to the chest, perform a reload (emergency, tactical or magazine exchange) and re- holster.

(1) round to the head of the target in five (5) seconds and assume a high search position. From high search, move to an aimed in position and fire two

(2) rounds to the chest of the target and one (1) round to the head of the target in four (4) seconds. At the end of this stage, the two (2) headshot rounds must be in the five ring head area for each to count as five (5) points. The head area outside the five ring is worth two (2) points. Shooters with a magazine capacity of less than twelve (12) rounds will have to conduct a tactical reload or magazine exchange at the end of this stage of fire to be prepared for stage four.

Draw and fire three (3) rounds, using both hands, then transfer the weapon to the weak hand only and fire three (3) rounds in ten (10) seconds, and re-holster

Shooters with a magazine capacity of less than twelve

(12) rounds will have to conduct a tactical reload or magazine exchange at the end of this stage to be prepared for stage six (6).

SEMI AUTOMATIC

(Demonstrate the following) Pick up the weapon – The security guard will pick up the weapon, physically and visually check and say that the weapon is clear. (The only time during the test that the security guard’s finger should be on the trigger is when he/she is ready to pull the trigger)

Load the weapon and holster - The security guard will insert the magazine securely, pull the slide to the rear and release to chamber a round, and holster, ensure the weapon is pointed down range from that moment forward while the weapon is out of the holster until the weapon is unloaded.

Demonstrate immediate action - The security guard will tap the magazine to ensure that it’s seated properly, rack the slide to remove any defective rounds, and reassess the threat to fire if necessary.

Demonstrate secondary immediate action - Only the task identified below will be accepted for the safety test purposes when performing secondary immediate action. The company instructor will insert a dummy round into the barrel of the weapon, then insert a loaded magazine. Once the magazine is locked in place, the slide is to be released creating a double feed. The weapon will then be given back to the security guard to demonstrate the proper secondary immediate action clearing procedure.

The procedure to clear the magazine involves the security guard pushing in the magazine release while he/she rips the magazine from the weapon, working the slide several times to ensure that the weapon is cleared. Then he/she inserts a new magazine, racks the slide to chamber a round, and reassesses the threat to fire, if necessary.

Unload the weapon - The security guard will remove the magazine, rack the slide several times to remove the chambered round, check and say the weapon is clear.

Bench a safe weapon - The security guard will place the weapon on the table with the slide locked to the rear.

Range rules

1. All stages of fire will be timed. Instructors must have a stopwatch, whistle and a copy of the course of fire, otherwise the security guards will not be certified, and the range date will be cancelled, because of inadequate equipment.

2. Security guards are allowed only two qualification attempts per range date.

3. Weapons will be snapped in every time the security guard holsters his/her weapon.

4. Security officers will not be allowed to shoot if his/her weapon does not fit into his/her holster.

5. Any violation of safety is grounds for immediate removal from the range.

6. Security officers are not allowed to shoot after the stop whistle (1st violation deduction of 5 points 2nd violation removal from the range for not following range instructions)

7. If the security range instructor is caught cheating or trying to circumvent the rules and procedures the range date will be cancelled, and all scores will be nullified.

8. Alibis will only be given for proper use of immediate or secondary immediate action, no alibi for being slow and not getting rounds off. There are only four (4) accepted alibis as follows:

· A malfunctioning weapon

· Bad ammunition

· Instructor error

· Target malfunction, e.g., target not turning, target falling off carrier

II Initial/Recurring Training Requirements:

All guards shall take the following training:

Initial Orientation * – 40 hours OJT Shadowing trained guards Magnetometer/X-Ray Training* (part of initial orientation) Security Control Center Operations Training* The Security Control Center training will be a variety of topics, Emergency Response, Safety Data Sheet review, Digital Video operation, card access alarms, and fire alarm point monitoring. Getting acquainted with the other posts, and Rover activities First week on duty

Within 10 days after entering on duty and or before assuming x-ray screening duties

Part of initial orientation

DOI Talent ** (Government online training site) Courses include, but are not limited to:

1. EROS Safety Awareness and OEP overview

2. EROS Security Awareness

3. USGS Property Management

4. USGS Records Management

5. Computer Security

6. Ionizing Radiation Initial and annual/as required

* Training provided by the contractor.

**Training provided by the Government.