17 technical specif. Library.pdf

TECHNICAL SPECIFICATION . NUMBER 17

1.1 Product number Library 1.20 m x 0.50 m

1.2 Reference image and descrip on

1. Surface in high-pressure laminate plated in Formica

2. Sides in high-pressure laminate plated in Formica

3. Door in high-pressure laminate veneered in Formica

4. Skirting board in high-pressure laminate plated in Formica

5. Handle

6. Raw glass plus packaging

7. Round sheet in module A and module B.

NOTE: As there are two independent modules, module A (wardrobe) can vary (left right depending on the design).

1.3 Minimum specifica ons

1.3.1 Surface

Supply and installation of a library made of high-pressure laminate plated in Formica, composed of two (2) independent sections as follows:

A wardrobe-type module of 1.80 high x 0.30 wide x 0.50 deep with roller or bar to hang the robes of magistrates and judges with door, includes a handle and small chest of drawers & o A mixed library module of 0.90 width x 1.80 height x 0.50 which is composed of a top of

1.10 height x 0.35 depth x 0.90 width, with 2 internal shelves of 0.35 m depth x 12 mm thick duly supported and the lower part of a low type of furniture of 0.90 width x 0.74 height x 0.50 depth (includes plinth) with internal division to form two useful spaces, with an internal shelf of 0.48m deep x 25mm thick, duly supported and properly supported and 2 wing doors includes handle and lock. (The wardrobe-type module will be independent since depending on the design it can be located left or right). The color will be defined by the supervisor.

The surfaces will be made of 30 mm high-pressure laminate wood (NEMA standard), veneered at the top in Formica F-8 high-pressure laminate, with F-8 Balance-Backer at the bottom.

Perimeter with 2mm thick thermo cast rigid edge. Similar color to the work surface.

All edges shall be coated with flat edges thermo cast in high-pressure polymer, firmly and industrially adhered with hot melt glue.

Surfaces shall ensure abrasion resistance of 6000 cycles.

The high-pressure laminate type wood used shall be Moisture Resistant. (RH)

1.3.2 Structure

If welding is necessary, MIG type or similar shall be used.

The structure shall be insulated from the floor by means of anti-noise levelers, which in turn prevent marks or scratches on the floor and protect the furniture from moisture.

Levelers on both sides, it will also have a reinforcement of 5cm per access face to the module in agglomerate plated in high-pressure

Formica f(8).

Levelers should have a latch or stud of sufficient length to decrease the risk of loss. This will have a bristol-type anchoring system.

The elements connecting the structure and surface must ensure that the whole is consolidated and that it behaves monolithically.

The structure shall be completely independent of surfaces, shall not be solidary with each other and shall not depend on their stability.

1.4 Quality regula ons

Nevertheless, the above minimum specifications, the product must comply with the following quality standards as it relates to the product:

NEMA-LD3: National Electrical Manufacturers Association- High- Pressure Decorative Laminates NTC 1805: Metal Shelving, Physical Quality Requirements