Attachment_0003___Additional_Solicitation_Contract_Requirements.docx

ATTACHMENT 0003 - ADDITIONAL SOLICITATION/CONTRACT REQUIREMENTS

This Attachment is to document Additional Contract Requirements for the M739A1 Point Detonating/Delay (PD/DLY) Fuze.

Note: The below narratives replace the previous local clauses that were imbedded within the solicitation. Each narrative is noted with the omitted local clause and replaced with the below narrative.

1) EXPLOSIVE MATERIAL HANDLING (Formally within Section C, 52.223-4005) The Contractor shall comply with the requirements of the Department of the Army Pamphlet 385-64, Safety, Ammunition and Explosives Safety Program, in effect on the date of the solicitation for this contract.

2) SAFETY REQUIREMENTS FOR HAZARDOUS ITEMS (Formally within Section H, 52.223-4002)

a) The contractor shall use the safety data provided in the Hazardous Component Safety Data Sheets (HCSDS) to insure the safe handling of the energetic material. The HCSDS are in Section J of the contract.

b) The contractor shall comply with Paragraph F, Chapter 1 of DOD 4146.26M, DOD Contractor's Safety Manual for Ammunition and Explosives. This requires the contractor to submit all site and construction plans through the local Defense Contract Management District Safety Office to the Contracting Officer for approval. The contractor must also submit changes for approval. Contractors will assure that their subcontractors follow the same procedures.

c) Whenever the contractor uses a government facility, he shall comply with the local safety requirements of that facility.

d) The contractor must obtain written approval from the Contracting Officer before the award of a subcontract involving explosives, propellants or pyrotechnic materials. When the contractor requests the Contracting Officer's approval, the Contracting Officer will arrange a Defense Logistics Agency pre-award safety survey for each subcontractor.

e) The contractor is responsible for decontaminating all facilities/equipment at the end of the contract unless the contractor intends to continue using the facilities/equipment for similar purposes. Any associated costs must be included as part of the contractor’s proposal. The contractor must provide the Contracting Officer with a certification that all contaminated facilities/equipment have been decontaminated.

f) The contractor is responsible for properly disposing of hazardous materials during this contract. If disposal is done on the subcontractor's site, the contractor must note this in his site plan per paragraph b, above. The Contracting Officer must approve a subcontractor prior to him performing disposal per paragraph d, above.

g) The contractor will provide reports of accidents/incidents as required by Data Item DI-SAFT-81563. The government reserves the right to investigate any accident/incident under Chapter 2, Paragraphs F and G of DOD 4145.26M, DOD Contractor's Safety Manual for Ammunition and Explosives.

3) RELEASE OF INFORMATION RESEARCH AND DEVELOPMENT (Formally within Section H, 52.224-4000)

a) Classified Contracts - The DOD Security Agreement (DD Form 441) and DOD Contract Security Classification Specification (DD Form 254) apply.

b) Unclassified Contracts-Restricted Release - Obtain the Contracting Officer's approval before releasing information received during this contract or generated from this contract, except if a college, university or laboratory receives the award and conducts the research on campus.

c) Unclassified Contracts-Unrestricted Release - You may release information received during the contract or developed from the contract without Contracting Officer's approval if:

1. you are a college, university/laboratory; and

2. you conduct the research on campus.

But, obtain approval before releasing the information if there is a high likelihood of revealing abilities of military systems or information concerning manufacturing technologies unique and critical to defense.

NOTE: Section J provides instructions for clearing technical material for release to the public and a sample clearance form (INME-PIC-IM Form 3002).