PRODUCT ENGINEERING REQUIREMENTS (Attachment 0003).pdf

PRODUCT ENGINEERING REQUIREMENTS

The following Item Description, Drawing(s) and/or Specification(s) represent minimum

Government requirements and are applicable to this Procurement.

National Stock Number (NSN): 5180-01-677-6455

Tool Kit, Carpenter’s

In accordance with Army Technical Data Package List (TDPL) 0414A0000:59678, dated 4 June

2019.

With the following exceptions:

Army Drawing 0414B0000, Rev “-“, dated 2018-10-04, Page 2, Zone D3-4 and C3-4, Note 10, REMOVE:

WATER ENTRY RESISTANCE:

WHEN CLOSED AND FASTENED, THE CHEST SHALL WITHSTAND IMMERSION IN WATER,

WITHOUT WATER ENTRY, TO A DEPTH OF NO LESS THAN I METER (3.28 FEETI TO THE

UPPERMOST SURFACE OF THE CHEST FOR NO LESS THAN 30 MINUTES WHEN TESTED IN

ACCORDANCE WITH TEST METHOD 512.6 OF MIL-STD-810 THE CHEST SHALL BE

CONDITIONED SO THAT ITS TEMPERATURE IS NO LESS THAN 27'C (80.6'FI ABOVE THE

WATER TEMPERATURE PRIOR TO IMMERSION. THE CHEST SHALL BE TIED DOWN USING

THE HANDLES, THE TIE DOWN POINTS OR WEIGHTED WITH OTHER LOADED CHESTS

STACKED UPON THE TEST ITEM. PRIOR TO CONDITIONING AND TESTING, THE CHEST

SHALL HAVE BEEN UNLATCHED, OPENED, CLOSED AND RE-LATCHED NO FEWER THAN 10

TIMES. IF A RUBBERIZED SEAL IS USED TO MEET THE REQUIREMENTS, THEN IT SHALL BE

EASILY REPLACED WHEN DAMAGED IN THE FIELD.

And REPLACE WITH:

WATER ENTRY RESISTANCE:

WITH THE TOOL CASE IN A SHUT AND SEALED CONFIGURATION, TAKE A SOURCE OF

WATER FLOWING THROUGH A 0.75” UNRESTRICTED FLEXIBLE LINE (GARDEN HOSE) WITH

A PRESSURE NO LESS THAN 35 POUNDS PER SQUARE INCH AND RUN OVER ALL SEAMS

AND OPENINGS. RUN THE HOSE 12” ± 6” FROM THE TOOL CASE, DIRECTLY INTO THE

SEAMS AND INTO ANY OTHER POSSIBLE LEAK AREAS (E.G. THE HANDLES, WHEELS OR

RIVETS IF PRESENT). RUN THE HOSE OVER THE SEAMS AT A MODERATE SPEED. WIPE

DOWN THE EXTERIOR OF THE TOOL CASE, TO REMOVE ANY EXCESS WATER THAT HAS

POOLED BECAUSE OF THE TEST. EXAMINE THE INTERIOR OF THE TOOL CASE AND

CONFIRM THAT NO WATER HAS ENTERED. WATER ON THE GASKET MATERIAL AND

SEALS IS EXPECTED.

Army Drawing 0414A0001, Rev “-“, dated 2018-10-04, Page 1, Zone C3, END ITEM NSN: 5180-01-499-3548

END ITEM NSN: 5180-01-677-6455

Army Drawing 0414A0001, Rev “-“, dated 2018-10-04, Page 1, Zone C1-2, END ITEM NSN: 5180-01-499-3546

END ITEM NSN: 5180-01-677-6455

Army Drawing 0414A0001, Rev “-“, dated 2018-10-04, Page 1, Zone C1-2, Specification Data: ARDEC TDP 0414A0000:59678

Specification Data: 0414A0000:59678

Army Drawing 0414A0001, Rev “-“, dated 2018-10-04, Page 1, Zone B3-4, Specification Data: ARDEC TDP 0414A0000:59678

Specification Data: 0414A0000:59678