Attach_E_Supplement_to_Specifications.docx

Supplement to Design Documents

1. All references to ‘Engineer’ within the Design Documents do not authorize an individual other than the Contracting Officer or Contracting Officer’s Representative to enter into or terminate this contract, modify any term or condition of this contract, waive any requirement of this contract, or accept nonconforming work. See Section G clause 1452.201-70 Authorities and Delegations.

2. The dates at Specification Section 01 35 00, Part 1.8.A.1 are revised to January 15, 2015 through July 31, 2015.

3. The Design Documents may reference 2 generators in the Endangered Species area that are deleted from the project, referenced are:

a. Well #14 Generator

b. Sanitary Lift Station Generator

4. The Coburn Area Pond drawings may list the sand filter model number as Hayward S180T. The correct model number is Hayward S360T2, as provided in specification section 33 48 00.

5. Question: Section 33-21-13-1.3 B. The desired yield from the well is a minimum 50 GPM however the specified pumps for both wells 18 and 19 are 150 GPM units. A final decision regarding casing diameter will be made after the well is drilled and a blown yield is estimated. For the purpose of bidding, the 6” casing as shown on the detail shall be used.

6. Section 33-21-13-3.8 For the purpose of bidding, assume 20’ of screen will be needed for each well.

7. Division 01 - General Requirements

8. The permitting requirements identified in SECTION 01 35 00 SPECIAL PROCEDURES PART 1 – GENERAL paragraph 1.5 will be performed by the project designer. All approvals and inspections shall be coordinated and performed by the contractor.

G15PS00053

Attachment E Supplement to Design Documents