B-27266 Exhibit C-1 Specification for 32P Commercial Transit Bus 091222.docx

State of Illinois Department of Central Management Services Exhibit C-1

Specifications for a 32 Passenger Commercial Transit Bus

The following specifications describe the minimum requirements for a 32-passenger commercial transit bus.

1. For a hybrid-engine coupled with a gas or diesel engine, the vehicle shall be new, of current design and manufacture and a production model. Any additions, deletions or variations from these specifications must be noted for review/approval by the State or the vehicle may be rejected. Any standard items appearing in the manufacturer’s regular published specifications shall be included unless otherwise optioned.

2. For an electric engine, the vehicle shall be new, of current design and manufacture and a production model. Any additions, deletions or variations from these specifications must be noted for review/approval by the State or the vehicle may be rejected. Any standard items appearing in the manufacturer’s regular published specifications shall be included unless otherwise optioned.

a. Provide Level 3 fast charging options.

3. For a gas or diesel engine, the vehicle shall be new, of current design and manufacture and a production model. Any additions, deletions or variations from these specifications must be noted for review/approval by the State or the vehicle may be rejected. Any standard items appearing in the manufacturer’s regular published specifications shall be included unless otherwise optioned.

Parts and service for the commercial transit bus should be readily available in the State of Illinois.

Unless otherwise specified, the proposed equipment shall be complete in all parts and options ready for immediate use upon delivery.

Make:

Model:

Fuel Type:

Manufacturer(s):

The State reserves the right to waive minor informalities, deficiencies, or technical variance which by their nature are restrictive to a given manufacturer, if in its judgement, it would be in the best interest of the State. Commercial transit buses must conform to the Federal Motor Vehicle Safety Standards and the Illinois requirements.

Specifications:

1. All standard equipment, no deletions

2. Wheelbase: 177 inches minimum

3. Gross Vehicle Weight Rating of 14,200 pounds minimum

4. Front axle: 4,600 pounds minimum

5. Rear axle: 9,500 pounds minimum

6. Front springs: 4,600 pounds minimum

7. Rear springs: 9,500 pound minimum

8. Battery: dual 600 CCA (minimum 1,200 CCA)

9. Engine 6.0-liter gasoline/diesel minimum, Hybrid, or Electric Engine

10. Engine oil cooler (not required on Electric engine)

11. Heavy duty radiator (not required on Electric engine)

12. Automatic transmission with overdrive

13. Driveshaft guards

14. Front and rear shock absorbers

15. Front and rear stabilizer bar

16. 4-wheel disc brakes with anti-lock system

17. 220 AMP alternator minimum (not required on Electric engine)

18. Dual rear wheels

19. Tires: LT225/75R16 all season radials

20. 33-gallon fuel tank (approximate—not required for Electric Engine)

21. Power steering

22. Intermittent windshield wipers with electric washers

23. In-dash heater and defroster

24. Temperature, oil pressure and coolant gauges

25. Voltmeter

26. Driver’s high back seat with lap and shoulder harness

27. Driver’s sun visor

28. Driver’s storage console with 12V power point

29. Driver’s side air bag

30. Driver’s cup holder

31. Driver’s seat air suspension with arms

32. OEM in-dash air conditioning

33. Tinted windshield and driver’s door glass

34. Aluminum or galvanized steel body construction

35. 1 ½ inch fiberglass or equal insulation in roof, side, and rear quarter panels

36. Bus body to be completely undercoated

37. 73-inch minimum interior headroom

38. Aluminized interior side panels below the windows

39. One-piece rub rails with weep holes to prevent condensation

40. Double out, panic free, manual control entrance door

41. Wrap-around anti-ride rear bumper

42. Rear fender extensions

43. Front and rear mudflaps

44. Snow rail at lower skirt

45. Roof mounted strobe light

46. Front crossing gate control with one-time interrupt switch; shall meet FMVSS and Illinois minimum requirements for commercial transit buses

47. Electric stop arm with flashing lights

48. Armored side turn signal lights—yellow side turn lamps

49. Rear turn signals—yellow turn lamps

50. Stop signals—red stop lamps

51. Minimum 7-inch x 10-inch flat with 7-inch x 4-inch convex rearview mirrors

52. Fender mounted cross-view mirrors

53. Rear emergency door with upper and lower glass

54. Two-step stepwell with light

55. Stainless steel grab handle at entrance steps

56. Minimum 4-inch header bumper pads over entrance and emergency doors

57. Minimum ½ inch minimum exterior grade plywood subfloor

58. Minimum 1/8-inch minimum rubber floor covering

59. Minimum 3/16-inch minimum rubber in aisle and on entrance steps

60. High back passenger seats and barriers

61. Seat belts in all passenger seats

62. Aisle molding in floor

63. Static roof vent

64. Standard manufacturer’s interior paint

65. Reflective striping around all emergency exits

66. Split sash side windows with 12-inch clear opening, minimally

67. Window stop decals

68. Tinted side and rear windows

69. Tinted rear ¼ glass

70. Curb side safety window

71. Circuit control board for all body circuits mounted in an accessible location

72. Body circuit relay disconnect

73. Accessory switch panel located to the right of the driver for easy access

74. Overhead driver’s storage compartment with swinging door

75. Minimum four (4) dome lights for passengers

76. Driver’s dome light on separate switch

77. ½ inch emergency door warning light and buzzer for driver

78. Back up alarm

79. Eight lamp warning system

80. Noise suppression switch

81. Rear air conditioning, minimum 55,000 BTU tie-in system with side mounted condenser, may be dealer installed

82. Rear heater of 50,000 BTU minimum

83. Heater shut-off valves

84. Heater bleed valves

85. Minimum 6-inch x 16-inch interior mirror

86. Certificate holder

87. AM/FM stereo with front and rear speakers

88. LED lighting package for interior and exterior

89. Rear vandal lock with starter interrupt switch

90. Body protecting circuit breakers

91. Exterior color: commercial transit bus yellow with white roof; bumpers, warning lamp background and rub rails to be painted black

92. First Aid Kit

93. Fire Extinguisher—dry chemical type

94. Warning devices

95. Reflectors—front, left side, right side, rear

96. Fuel sender inspection plate (not required for Electric Engine)

97. Decals and/or lettering may include, but not be limited to: window stop, alternative fuel, report erratic driving, vehicle length, emergency exit, capacity, and all other required decals

98. New Illinois Inspection sticker

99. All required lettering and bus numbers. Bus To Be Delivered with New Illinois Inspection Sticker and All Required Commercial Transit Bus Lettering and Bus Numbers.

Options may include, but not be limited to:

Stop signal arm panels may be added at ordering entity’s request on the left side of the bus and operate in conjunction with the required panel, if available Tow hooks Cruise control Driver clipboard holder mounted stand Removable seat cushions Floor heaters located in the front, middle and rear with separate controls on driver’s dash Two (2) electric fans for front windows Heated mirrors Heated fuel and water separator, if available Storage under both sides of bus; water and weather-proof with security/locking feature Roll out battery tray Air suspension Buses to be safety belt ready with belts supplied but not installed Light test check system Heavy duty crossing arm with wind deflectors installed No child left behind system—child check system Emergency roof hatch GPS installed on each bus Three (3) camera system installed on each bus with docking station and software, hook-up signals and speed readings Tilt or telescoping steering wheel column Engine block heater (not required on Electric engine)

Illinois Administrative Code for Type I School Buses https://www.ilga.gov/commission/jcar/admincode/092/09200440sections.html Illinois Administrative Code for Type II School Buses (title 92, Chapter I, Subchapter e, Part 442) https://www.ilga.gov/commission/jcar/admincode/092/09200442sections.html Illinois Administrative Code for Multifunction School Activity Buses (Title 92, Chapter I, Subchapter d, Part 435) https://www.ilga.gov/commission/jcar/admincode/092/09200435sections.html Illinois Administrative Code for Special Education Transport https://www.ilga.gov/commission/jcar/admincode/092/09200444sections.html Illinois Administrative Code for Alternate Fuel System for School Buses https://www.ilga.gov/commission/jcar/admincode/092/09200449sections.html Federal Motor Vehicle Safety Standards https://www.ecfr.gov/current/title-49/subtitle-B/chapter-V/part-571