80HQTR27R0006_NPP-3 Attachment E_Contract Data Requirements List.pdf

Attachment E RFP No. 80HQTR27R0006

E-1

Attachment E

CONTRACT DATA REQUIREMENTS LIST

National Aeronautics and Space Administration NASA Headquarters (HQ)

Attachment E RFP No. 80HQTR27R0006

E-2

DOCUMENT CHANGE LOG

DRD

No.

DRD Title Revision Date

Attachment E RFP No. 80HQTR27R0006

E-3

INTRODUCTION

This document defines the requirements for contractual data to be delivered by the contractor to the Government. The data requirements are set forth in each Data Requirements Description (DRD) and must govern that data required by the contract. The contractor must furnish data defined by the DRDs as listed on the Contract Data Requirements List (CDRL) by category of data, attached hereto, and made a part of this contract. Such data must be prepared, maintained, and delivered to NASA in accordance with the requirements set forth within this document. In cases where data requirements are covered by a Federal Acquisition Regulation (FAR) or NASA FAR Supplement (NFS) clause or other term (e.g., requirements statement), that clause or term must take precedence over the DRD.

Contract Data Requirements List (CDRL): Throughout the performance of the contract, the CDRL provides a listing by number, data type, title, and Office of Primary Responsibility (OPR).

Data Requirements Description (DRD): Each DRD included in this CDRL prescribes content, format, and submittal requirements. The DRDs included in this CDRL are ordered sequentially as listed in the CDRL page(s) that precede(s) the actual DRDs.

Data Type Description: Each DRD is classified by data type as defined below:

TYPE DESCRIPTION

1 - All submittals of and interim changes to Type 1 DRDs require written approval from the contracting officer before formal release for use or implementation.

2 - NASA reserves a time-limited right to disapprove in writing any submittal of and interim changes to Type 2 DRDs. The contractor must submit the required data to NASA for review within the time period established in the DRD prior to its release for use or implementation. The contractor must clearly identify the release target date. If the data is unacceptable, the contracting officer will notify the contractor within the time period established in the DRD from the date of submission, regardless of the intended release date. The contractor must resubmit the information for reevaluation if disapproved. The submittal is considered approved if the contractor does not receive disapproval or an extension request from the contracting officer within the time period established in the DRD.

3 – Type 3 DRDs must be delivered as required by the contract and do not require NASA approval.

Attachment E RFP No. 80HQTR27R0006

D-4

STATEMENT OF GENERAL REQUIREMENTS

Subcontractor Data Requirement The prime contractor is responsible for flowing down any specific data requirements that apply to subcontracts and vendor agreements.

Reference to subcontractor data in the contractor’s responses is permissible and a copy of the referenced subcontractor data must be supplied with the response document at time of delivery to NASA.

Data Distribution, Format, and Transmittal Distribution: Distribution recipients and number of copies are identified within each DRD, provided within the contract, or as directed by the Contracting Officer

(CO).

Format Electronic Format: Electronic submission of data deliverables is required.

Electronic deliverables must be printable. Data deliverables must be delivered to NASA in the format specified below unless a specific format is required by a DRD. Data submittals must consist of a single Adobe Acrobat PDF file and the native format electronic file(s). The preferred native formats include Microsoft Word, Excel, or PowerPoint, as appropriate.

Hardcopy Format: Hardcopy of data deliverables is not required unless electronic delivery is not possible.

Transmittal Data must be transmitted to NASA by email.

If email is used to transmit data deliverables, the email size must be 10 megabytes or less to ensure receipt by the NASA email servers. Encrypted email format must be used to transmit data.

Data Transmittal Package: Each data transmittal package must include a transmittal memorandum that specifies the following:

1. Contract number

2. Data Requirements Description (DRD) number

3. DRD data type

4. Submission date or milestone being satisfied

5. Document number and revision

6. Document title

7. File names of all files being delivered; file naming convention must clearly identify the document being delivered

8. NASA Records Retention Schedule (NRRS) number, if applicable (See

NRRS 1441.1, NASA Records Retention Schedules)

Attachment E RFP No. 80HQTR27R0006

D-5

Document Identification: For all data types, the document number, change legend, date, and title constitute the minimum identification of the specific document and must appear on the cover and title page. The contract number must also appear on the cover and title page as separate markings. The originator and organization must be included on the title page. The document number, change legend, and date must appear on each page of the document. All Type 1 documentation must be marked “PRELIMINARY PENDING NASA APPROVAL,” and once approved must be reissued with “APPROVED BY NASA” and the date and approval authority annotated on the cover.

Data Restriction Determination and Marking Requirements: The contractor must properly mark data in accordance with the data rights clause(s) included in the contract. The contractor must make a determination for each individual data deliverable, and must not apply a default or blanket data restriction marking to all data deliverables (e.g., “data may be export restricted”). If NASA does not agree with the contractor applied data restriction, the CO must return the data to the contractor, cancel the markings, or ignore the markings consistent with the procedures set forth in the “data rights” clause(s) contained in the contract.

Reference to Other Documents and Data Deliverables in Data Submittals: All referenced documents must be made readily available to the cognizant NASA organization upon request.

Document Revisions

Revisions of documentation previously submitted may be accomplished either by individual page revision or by a complete reissue of the document.

A document must be completely reissued when, in the opinion of the contractor and/or NASA, the document has been revised to the extent that it is unusable in its present state, or when directed by the CO. When complete reissues are made, the entire contents of the document must be brought up to date and must incorporate revised pages. All revisions must be recorded. A revision log must identify complete reissues except for periodic reports and documents which are complete within themselves as final.

Individual page revisions must be made as deemed necessary by the contractor or as directed by the CO.

Changes of a minor nature to correct obvious typing errors, misspelled words, etc., must only be made when a substantial change is made, unless the accuracy of the document is affected.

All revised pages must be identified by a revision identifier and a new date. Each document must contain a log of revised pages that identify the revision status of

Attachment E RFP No. 80HQTR27R0006

D-6 each page with the revision symbol. This list must follow the table of contents in each document. The line or lines revised on a given page must be designated using vertical line in the margin of the page, and the change authority must be indicated adjacent to the change.

CDRL/DRD MAINTENANCE PROCEDURES

NASA-Initiated Change: New and/or revised data requirements must be incorporated by contract modification to which the new or revised portion must be appended. The contractor must notify the CO in the event a deliverable data requirement is imposed and is not covered by a DRD, or when a DRD is changed by a contract modification and for which no revision is appended.

CDRL or DRD Change Procedures Revisions to the CDRL or DRDs will be identified by NASA in the Document Change Log. The date of the revision, DRD number, title, and revision description will be annotated in the Document Change Log. Revision descriptions will include the modification number, which implements the change, and a brief description of the portions of the CDRL and/or DRD affected within the “Revision” column of the Document Change Log.

Contract Data Requirements List

DRD

No.

DRD

Type

DRD Title OPR

1 1 Security Requirements for Unclassified IT Resources OCIO

2 1 Commercial Super Intelligence Risk and Impact Assessment

(CSIRIA)

OCIO

3 3 Commercial IT Authorization Report (CITAR) OCIO

4 2 Information Technology (IT) Capital Planning and Investment Control (CPIC)

OCIO