B09_-_Amend_0002_-_Attachment_11_-_Tecco_0002.pdf

This is a system drawing document for the TECCO G65/3 product from Brugg Geobrugg, a erosion control and slope stabilization system. The drawing illustrates the general nail arrangement and cross-section details for installing high-tensile steel mesh (approximately 65 mm × 50 mm) with a maximum 1.0 mm diameter wire rope anchor system on slopes or embankments.

The document presents two primary installation configurations: Cross Section A-A showing standard tension force application on wire rope anchors, and Detail A depicting an optional shear force configuration on nails. The system utilizes TECCO® system spike plates (models P66 and P33), Connection clip T3, Press clue Type 2 clips, and lateral boundary ropes positioned at 10mm intervals with breaking loads of 55 kN or 91 kN. The diagram specifies nail spacing (for example, Ø25 or Ø32mm), vertical and bottom boundary rope placement at 10mm or Ø12mm intervals, and wire rope anchor positioning at 10.5cm or Ø14.5mm. The document is dated 22.02.23 (drawn), 23.02.23 (verified), and 27.02.23 (released) and is designated as revision 1, page 1 of 1, formatted for A3 size printing in English.