0224-01 - BAE DIGAR Support -DID DI-NDTI-80809B.pdf

This is a Data Item Description (DID) document that specifies the format and content requirements for test/inspection reports used in federal contracting.

The DID, identified as DI-NDTI-80809B and approved by the F/AFMC-DOP office, establishes standardized preparation instructions for test/inspection reports that document results, findings, and analyses of system compliance with government or contracting agency requirements. The document is applicable to engineering tasks including developmental, preliminary qualification, qualification, and acceptance testing. Reports must include a cover page with report date, number, contractor information, contract details, and security classification; a table of contents with major sections and illustrations; an introduction containing test objectives and item identification; test/inspection requirements linked to contractual specifications; and a detailed summary of significant results, observations, conclusions, and recommendations. The report body requires test equipment identification with nomenclature, model and serial numbers, manufacturer information, and calibration status; facility installation and setup descriptions with location, orientation, and settings of equipment and sensors; complete test procedures including item selection verification and step-by-step testing sequences; and comprehensive results and analysis including recorded data, matrices comparing achievements against objectives, calculations, and discussion of anomalies and deviations. Authentication certifications must include statements that test/inspection was performed in accordance with plans and procedures, validation of prior test results, and acceptability determinations, each signed by authorized contractor personnel and government witnesses. Appendices should contain detailed test data, drawings, photographs, and referenced documentation not previously provided by the government.