Attachment_0003__M870_Performance_Requirements_Matrix_SDQ_30_JUL_15.xlsx
XLSX spreadsheet 24 KB Posted
- Attached to
- M870A4 Semitrailer
- Solicitation number
- W56HZV16R0001
View the file
Other files
Show all 46
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
Sheet1
| Attachment 0003 - Performance Requirements Matrix | ||||
| Technical Subfactors | PD Paragraph | PD Requirement | Offerors Proposed Level of Performance | |
| Subfactor 1 | ||||
| Payload | 3.11, 3.11.3.1, 3.11.3.2 | 3.11.1 Payload. The M870A4 shall be capable of transporting the rated payload of 80,000 lbs. (T) and 85,000 lbs. (O). Payloads shall not cause any permanent deformation in the frame, gooseneck, or any other part. The M870A4 shall be suitable for the concentrated pin point, and localized stresses caused by mobile loads being loaded onto the M870A4 by tracks, track-pads, wheels, and any other non-evenly distributed loads that would be imparted onto the M870A4 by the equipment listed in Annex A. The M870A4 shall be capable of loading, transporting, and off-loading the equipment listed in Annex A. | Rated payload capacity : _______________ pounds |
| Subfactor 2 | ||
| Trailer Ride Quality | 3.11.4 | 3.11.4 Trailer ride quality. The M870A4 shall transmit no more than 4g’s vertical acceleration measured at the payload deck above the center axle, while negotiating the Root Mean Square (RMS) courses at the speeds shown in Table III. The M870A4 shall meet the trailer ride quality requirement at GVW and with tires at cross country pressure (if applicable). |
Table III
| Completely fill out Attachment 0019 - Trailer Vehicle Dynamics Data Sheets. | |||
| Subfactor 3 | |||
| Rear Loading | 3.11.3.2 | 3.11.3.2 Rear loading. The M870A4 shall have two rear loading ramps capable of loading and off-loading of the Engineering Construction Equipment (ECE) in Annex A with the exception of the High Speed Compactor, Asphalt Paving Machine, Type I Vibratory Roller, Type II Vibratory Roller, Dual Steel-Wheeled Roller, and the Type I HYEX, Type II HYEX and Type III HYEX (T), all the ECE in Annex A (O). The rear loading ramps shall be capable of withstanding the applied portion of the load during loading and off-loading the ECE in Annex A without permanent deformation. The ramps shall be attached to the trailer on hinges that allow the ramps to be swung up for storage and travel. The rear loading ramps shall be adjustable to accommodate the loading and off-loading of the equipment listed in Annex A. Adjustment of width of stowed and deployed ramps shall be possible by not more than two soldiers. | Identify ECE, if any, from Annex A that cannot be loaded and off-loaded using the rear ramps. |
| Subfactor 4 | |||
| Overall width | 3.4 | Overall width with outrigger brackets stowed: 102 inches maximum (T), 96 inches maximum (O) | Overall width with outrigger brackets stowed: __________ inches |
image1.png
File details come from the government source that posted it. Updated .