Question_&_Answers_Part_3.docx
DOCX document 14 KB Posted
- Attached to
- F-22 Horizontal Stabilizer Fixtures Federal contract opportunity
- Solicitation number
- FA8224-19-R-A002
About this file
Additional questions and answers
View the file
Other files for this federal contract opportunity
| File | Type | Posted |
|---|---|---|
| Questions_&_Answers_Part_7.docx | DOCX document | |
| Questions_&_Answers_Part_6.docx | DOCX document | |
| Questions_&_Answers_Part_5.docx | DOCX document | |
| CDRL_A001.pdf | ||
| Question_&_Answers_Part_4.docx | DOCX document | |
| Statement_of_Work_updated.pdf | ||
| Question_&_Answers_Part_2.docx | DOCX document | |
| CDRL_A003.pdf | ||
| CDRL_A002.pdf | ||
| CDRL_A001.pdf | ||
| AFMAN91-203.pdf | ||
| Statement_of_Work.pdf | ||
| Question_&_Answers.docx | DOCX document | |
| Section_L_Past_Performance_Information.docx | DOCX document | |
| FA822419RA002_updated.pdf | ||
| Tab_12_Section_M.pdf | ||
| CDRL_A002.pdf | ||
| Tab_12_Statement_of_Work.pdf | ||
| Tab_12_Section_L.pdf | ||
| CDRL_A001.pdf | ||
| Tab_12_FA822419RA002.pdf | ||
| CDRL_A003.pdf |
Show all 22
On GovTribe
Work with this file on GovTribe
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
F-22 HORIZONTAL STABILIZER FIXTURES
FA8224-19-R-A002
QUESTIONS & ANSWERS PART 3
Question:
Within the Maintenance facility and/or the location where the F-22 Horizontal Stabilizer Fixture will be utilized,
a) Is there an air source available? If so, what is the PSI rating?
b) What is the electrical power voltage rating required for electrical equipment used in the fixture design?
c) Are extension cords allowable if power is required? If not, what is the minimum cord length from fixture location to power outlet?
Answer:
(a) Yes, approximately 100 psi.
(b) 125 VAC 60Hz
(c) No, 50 ft
Per SOW 5.7.1, “Models shall be delivered in a format that is compatible with SolidWorks 2017.” Please further define what formats are compatible with SolidWorks 2017
Answer:
It is the contractor’s responsibility to check the compatibility of their formats with SolidWorks 2017. There is no preference from the government as to which format is used, so long as it is compatible.
What height should the towing lunette be set at?
Answer:
A range between 10-21 inches above the surface.
File details come from the government source that posted it.