Exhibit K CDRL A011 Preservation and Packing Data.pdf

DD FORM 1423-1, FEB 2001

CONTRACT DATA REQUIREMENTS LIST

(1 Data Item)

PREVIOUS EDITION MAY BE USED.

Form Approved OMB No. 0704-0188

The public reporting burden for this collection of information is estimated to average 110 hours per response, including the time for reviewing instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing the burden, to the Department of Defense, Executive Services Directorate (0704-0188). Respondents should be aware that notwithstanding any other provision of law, no person shall be subject to any penalty for failing to comply with a collection of information if it does not display a currently valid OMB control number. Please do not return your form to the above organization. Send completed form to the Government Issuing Contracting Officer for the Contract/PR No. listed in Block E.

A. CONTRACT LINE ITEM NO. B. EXHIBIT C. CATEGORY:

TDP ________ TM _______ OTHER

D. SYSTEM/ITEM E. CONTRACT/PR NO. F. CONTRACTOR

1. DATA ITEM NO. 2. TITLE OF DATA ITEM 3. SUBTITLE

4. AUTHORITY (Data Acquisition Document No.) 5. CONTRACT REFERENCE 6. REQUIRING OFFICE

7. DD 250 REQ

8. APP CODE

9. DIST STATEMENT

REQUIRED

10. FREQUENCY

11. AS OF DATE

12. DATE OF FIRST SUBMISSION

13. DATE OF SUBSEQUENT

SUBMISSION

14. DISTRIBUTION

a. ADDRESSEE

b. COPIES

Draft Final

Reg Repro

15. TOTAL

16. REMARKS

17. PRICE GROUP

18. ESTIMATED

TOTAL PRICE

G. PREPARED BY H. DATE I. APPROVED BY J. DATE

Page of Pages

CONTRACT DATA REQUIREMENTS LIST

(1 Data Item)

A. CONTRACT LINE ITEM NO. B. EXHIBIT C. CATEGORY:

TDP ________ TM _______ OTHER

D. SYSTEM/ITEM E. CONTRACT/PR NO. F. CONTRACTOR

16. REMARKS (Continued)

DD FORM 1423-1, FEB 2001 Page of Pages

INSTRUCTIONS FOR COMPLETING DD FORM 1423

(See DoD 5010.12-M for detailed instructions.)

FOR GOVERNMENT PERSONNEL

Item A. Self-explanatory.

Item B. Self-explanatory.

Item C. Mark (X) appropriate category: TDP - Technical Data Package;

TM - Technical Manual; Other - other category of data, such as "Provisioning,""Configuration Management," etc.

Item D. Enter name of system/item being acquired that data will support.

Item E. Self-explanatory (to be filled in after contract award).

Item F. Self-explanatory (to be filled in after contract award).

Item G. Signature of preparer of CDRL.

Item H. Date CDRL was prepared.

Item I. Signature of CDRL approval authority.

Item J. Date CDRL was approved.

Item 1. See DoD FAR Supplement Subpart 4.71 for proper numbering.

Item 2. Enter title as it appears on data acquisition document cited in Item 4.

Item 3. Enter subtitle of data item for further definition of data item (optional entry).

Item 4. Enter Data Item Description (DID) number, military specification number, or military standard number listed in DoD 5010.12-L (AMSDL), or one-time DID number, that defines data content and format requirements.

Item 5. Enter reference to tasking in contract that generates requirement for the data item (e.g., Statement of Work paragraph number).

Item 6. Enter technical office responsible for ensuring adequacy of the data item.

Item 7. Specify requirement for inspection/acceptance of the data item by the Government.

Item 8. Specify requirement for approval of a draft before preparation of the final data item.

Item 9. For technical data, specify requirement for contractor to mark the appropriate distribution statement on the data (ref. DoDD 5230.24).

Item 10. Specify number of times data items are to be delivered.

Item 11. Specify as-of date of data item, when applicable.

Item 12. Specify when first submittal is required.

Item 13. Specify when subsequent submittals are required, when applicable.

Item 14. Enter addressees and number of draft/final copies to be delivered to each addressee. Explain reproducible copies in Item 16.

Item 15. Enter total number of draft/final copies to be delivered.

Item 16. Use for additional/clarifying information for Items 1 through 15.

Examples are: Tailoring of documents cited in Item 4; Clarification of submittal dates in Items 12 and 13; Explanation of reproducible copies in Item 14.; Desired medium for delivery of the data item.

FOR THE CONTRACTOR

Item 17. Specify appropriate price group from one of the following groups of effort in developing estimated prices for each data item listed on the DD Form 1423.

a. Group I. Definition - Data which is not otherwise essential to the contractor's performance of the primary contracted effort (production, development, testing, and administration) but which is required by DD Form 1423.

Estimated Price - Costs to be included under Group I are those applicable to preparing and assembling the data item in conformance with Government requirements, and the administration and other expenses related to reproducing and delivering such data items to the Government.

b. Group II. Definition - Data which is essential to the performance of the primary contracted effort but the contractor is required to perform additional work to conform to Government requirements with regard to depth of content, format, frequency of submittal, preparation, control, or quality of the data item.

Estimated Price - Costs to be included under Group II are those incurred over and above the cost of the essential data item without conforming to Government requirements, and the administrative and other expenses related to reproducing and delivering such data item to the Government.

c. Group III. Definition - Data which the contractor must develop for his internal use in performance of the primary contracted effort and does not require any substantial change to conform to Government requirements with regard to depth of content, format, frequency of submittal, preparation, control, and quality of the data item.

Estimated Price - Costs to be included under Group III are the administrative and other expenses related to reproducing and delivering such data item to the Government.

d. Group IV. Definition - Data which is developed by the contractor as part of his normal operating procedures and his effort in supplying these data to the Government is minimal.

Estimated Price - Group IV items should normally be shown on the DD Form 1423 at no cost.

Item 18. For each data item, enter an amount equal to that portion of the total price which is estimated to be attributable to the production or development for the Government of that item of data.

These estimated data prices shall be developed only from those costs which will be incurred as a direct result of the requirement to supply the data, over and above those costs which would otherwise be incurred in performance of the contract if no data were required. The estimated data prices shall not include any amount for rights in data. The Government's right to use the data shall be governed by the pertinent provisions of the contract.

DD FORM 1423-1 (BACK), FEB 2001

a. Items that are determined to be Air Force managed shall have data developed IAW MIL-STD-2073-1E for :

(1) Long Lead and Spares Acquisition Integrated with Production (SAIP) items.

(2) Stock listed items not previously submitted.

(3) Non-stock listed items which are Supportability, Maintenance, & Recoverability (SMR) coded "P".

The procedural requirements of MIL-STD-2073-1E, Appendix E & J shall apply. Format shall be in accordance with DD FORM 2326 and shall be completed as specified in Appendix E. If the packaging cannot be adequately prescribed on the DD FORM 2326; then MIL-STD-2073-1E, Appendix E, E.4.2.7 and DI-PACK-80121C apply.

b. Reusable Containers IAW MIL-STD-2073-1E, Appendix C, C.5 shall be used and selected based on the following order of precedence:

(1) Multi-application/ Fast Pack containers IAW Appendix C, Table C-IV, Multi-application container selection.

(2) Standard fiberboard containers IAW Appendix C, Table C-III, Fiberboard container size limit.

(3) Containers IAW Appendix C, Table C-II that are considered reusable as defined by MIL-STD-2073-1E, paragraph 3.13.

(4) If the size, weight, configuration or fragility ratings exceed the parameters of the multi-application/standard containers and the packaging cannot be adequately prescribed on the DD FORM 2326 then MIL-STD-2073-1E, Appendix E, E.4.2.7 and DI-PACK-80121C apply. If an item is determined to need a specialized container as defined by MIL-STD-2073-1E, paragraph 3.13d, then DI-PACK-80683B & DI-PACK-80684B shall apply.

c. Electrostatic Discharge Sensitive (ESD) items/assemblies as defined by MIL-STD-1686 and Hazardous Materials per CFR 49 shall be identified as such on all data supplied under this exhibit. Material Safety Data Sheets (MSDS) IAW FED-STD-313, Current Revision, (including transportation data) shall be submitted with Preservation and Packaging Data & Letter of Transmittal to the addressee in Block 14. Items defined per CFR 49 as Hazardous Materials shall also include Performance Oriented Packaging (POP) test reports IAW DI-PACK-81059A.

BLOCK 7: The letter of transmittal shall contain the System name, Contract Number, Provisioning Control Code Number (PCCN), Submittal Control Code (SCC), Provisioning List Item Sequence Numbers (PLISNs) covered and Contact Information. The letter shall list each National Stock Number* (NSN) in PLISN order and specify whether submittal is partial, corrected or final. Contractor shall submit final report on DD Form 250 to collectively account for data previously delivered by Letter of Transmittal. Inspection/Acceptance shall be at Prime Air Logistics Center (See Block 14 for symbol and address).

BLOCK(s) 11, 12 & 13: Original submissions shall begin 30 days after completion of the Spares/Provisioning Conference(s) for which the items are covered, but no later than 90 days prior to the scheduled shipment date of each item for which this data is required. Approval of data shall be IAW MIL-STD-2073-1E, Appendix E. Return/Approval of data shall be within 30 days of receipt. Data which is returned for correction/revision shall be resubmitted by the contractor 30 days prior to shipment of material for approval. Data shall be submitted on DD Form 2326 electronically in Adobe .pdf format or in "hard copy" form along with the Letter of Transmittal to the address in Block 14.

a. Electronic delivery media shall be CD +/-R, DVD +/-R (Note: that CD +/-RW and DVD +/-RW are not acceptable). All submittals using electronic media shall be labeled with the System Name, Contract Number, PCCN, SCC and Contact Information. An item's packaging data will be saved in its entirety under one file to be named using the PLISN & NSN*.

b. Hard copy submissions shall include the PLISN on each individual DD FORM 2326.

c. In the event Packaging Data submittals are to be made to a secured program specific electronic site (Contractor or Government), a transmittal notification will be concurrently forwarded to the Prime Packaging Management Office via e-mail at 406SCMS.GULAA@us.af.mil.

*Items which do not have an NSN assigned at time of submission shall be identified using the PLISN & Part Number.