Attachment 0022a.2 - PDRS Support information for integration task.pptx

Critical Design Review (CDR) for the C-5 – US Army Passive Identification Friend or Foe (PIFF) System

January 28, 2020 Post CDR Updates

W31P4Q-20-R-0015 ATTACHMENT 0022a.2 www.telephonics.com

COVER DISCLAIMER

PROPRIETARY INFORMATION

Data contained in, revealed by, or shown in this document is proprietary as marked and belongs to Telephonics Corporation, A Griffon Company. Data marked as Proprietary shall not be used, duplicated, or disclosed in whole or in part without the prior written authorization of Telephonics Corporation.

Note 1:

LIMITED RIGHTS

Contract No.: W15QKN-17-9-5555/CS-18-0043 Contractor Name: Telephonics Corporation Contractor Address: 815 Broad Hollow Road, Farmingdale, New York 11735 The Government's rights to use, modify, reproduce, release, perform, display, or disclose these technical data are restricted by paragraph (b)(3) of the Rights in Technical Data--Noncommercial Items clause contained in the above identified contract. Any reproduction of technical data or portions thereof marked with this legend must also reproduce the markings. Any person, other than the Government, who has been provided access to such data must promptly notify the above named Contractor..

EXPORT WARNING (ITAR)

These items are controlled by the U.S. Government and authorized for export only to the country of ultimate destination for use by the ultimate consignee or end-user(s) herein identified. They may not be resold, transferred, or otherwise disposed of, to any other country or to any person other than the authorized ultimate consignee or end-user(s), either in their original form or after being incorporated into other items, without first obtaining approval from the U.S. government or as otherwise authorized by U.S. law and regulations. USML Category: XI(d)

10/7/2020

System Block/Interface Diagram

SEP PDRS Intermediate Cable

Block Diagram Proposed PDRS Intermediate Cable for the ADAM Shelter To be installed in existing Separation Panel (SEP)

IBCS Shelter

SEP

PDRS

PDRS Antenna 748-1201-XXX Cable 748-1201-XXX Cable Intermediate Cable P S S P P S S

P

Telephonics PDRS Turnkey Solution

Dual-Band (1090/978MHz) 6-Channel Antenna and Integrated GPS/SAASM Receiver Command, Control and Report Rugged Work Station

PDRS/KIV-77

978 MHz UAT 1090 Extended Squitter Mode 5 Level 2/Level 2B Rugged 3U VPX Chassis

Complete Antenna/Display System Cable Set (Lengths to Order)

Fixed/Telescoping Antenna Tower Options

PDRS Radio

Without shock insulator tray With shock insulator tray

Shock isolating base not required for an isolated cabinet. If mounted without base, the PDRS will fit into current rack with 0.92 in. clearance. However, some method for securing is needed.

SEP PDRS Intermediate Cable (cont.)

Connector PDRS Intermediate Cable will utilize connector P/N D38999/20WJ8** (Wall Mount type) Due to limited space available in the SEP and on the connector mounting panels Appropriate EMI backshells will be used on both connectors This connector will be used for both entrance and exit interfaces of the SEP

Cable Exit Location 10/7/2020 Current SEP Configuration (Outside View) Proposed PDRS SEP Intermediate

Cable Exit Location (cont.)

The existing connector must move down from its current location Necessary to allow for required RF cable bend radius Current connector is depicted in green

The existing connector must move down from its current location Necessary to allow for required RF cable bend radius Current connector is depicted in green

Cable Exit Location (Alternate Location) 10/7/2020 Current SEP Configuration (Outside View)

The existing connector must move down and over from its current location Necessary to allow for required RF cable bend radius Current connector is depicted in gold Allows intermediate cable to rub up the side of the enclosure Minimal or no interference with other SEP cables

Cable Entrance Location 10/7/2020 Current SEP Configuration (Inside View)

Cable Entrance Location

Cable Entrance Location (cont.)

The RF connector mounts to the current removable top panel SEP PDRS Intermediate Cable (cont.)

Cable Entrance Location (cont.)

Side view SEP PDRS Intermediate Cable (cont.)

Shelter Installation (cont.)

IBCS Shelter Installation During Telephonics site visit to NGC, the location and installation of the PDRS within the IBCS Shelter was discussed PDRS Mounting PDRS is to be mounted on an available rack shelf within the IBCS shelter The rack to be used for the PDRS mounting location is mid-cabin on the right side of the shelter Available space on rack shelf: 10.50 in. H x 19.00 in. D PDRS requires 10.59 in. minimum height

9.65 in. PDRS max height

0.79 in. Mounting Tray max height

0.15 in. Minimum clearance for J-hook clamps Additional height must be provided in the IBCS rack to allow for the required height of the PDRS and mounting tray When using PDRS Mounting Tray, existing shelf must be modified to allow clearance for J-hook clamps

IBCS Shelter Installation (cont.)

PDRS Cables PDRS Internal Cable Length: 16 ft.

From right side rack to IBCS patch panel on the rear of the shelter Point-to-point, including bend radius and internal rack routing Additional length may be required Rack shelf pulls out for access, requiring additional cable length for service loop Recommend D38999/24 Jam Nut connector for patch panel feed through PDRS Power Cable Telephonics to provide a 10 ft. power cable From power block to PDRS, including rack routing IBCS wire termination is TBD Option 1: Telephonics to supply PDRS power connector, NGC attaches connector to existing IBCS CAS power cable Option 2: NGC builds PDRS power cable complete

IBCS Shelter Installation (cont.)

PDRS External Cable Length: Estimated to be 84 ft.

100 ft. maximum length for all RF cabling Less 16 ft. for internal cable Option 1 Mount PDRS antenna where CASS antenna is mounted Use standard 6 ft. PDRS RF cable length Option 2 Mount PDRS antenna on top of Trilos pole 18 ft. (6 m) PDRS RF cable length Option 3 Mount PDRS antenna to Blue Sky Mast 45 ft. (15 m) maximum PDRS RF cable length image2.jpeg image4.png image5.png image6.png image7.jpeg image8.png image3.jpeg image9.png image10.png image11.png image12.png image13.png image14.png image15.png image16.png image17.png image18.png image19.png image20.png image21.png image22.png image23.png image24.png image25.png image26.png image27.png image28.png image29.png image30.png image1.jpeg