High speed runway sweeper

The purchase of One (1) high speed runway sweeper.  Salient Characteristics are as follows:

****ANY ITEM QUOTED BELOW NOT AS SPECIFIED SHALL BE NOTED AS SUBSITITUTE****

HIGH SPEED RUNWAY SWEEPER

VEHICLE –CHASSIS

• NAVISTAR MV-607 CHASSIS 2-SPEED W/ ALLISONM 2500 RDS-P TRANSMISSION
• CHASSIS HIGH ALTITUDE PACKAGE MIN 240HP/560 TORQUE
• 31,000 GVW CHASSIS
• DIESEL FUELED
• DUAL STEERING/DUAL GAUGE WITH DUAL AIR SUSPENSION SEATS
• BACK UP ALARM AND REAR FLOODLIGHTS, AIR HORN
• BRAKE AIR DRYER
• AIR CONDITIONING
• AM/FM STEREO
• ELECTRIC HEATED MIRRORS
• FULLY INTERGATED CONTROL SYSTEM TO CONTROL ALL FUNCTIONS FROM WITHIN CAB
• SINGLE RIGHT GUTTER BROOM WITH FLOODLIGHTS, PARABOLIC MIRRORS
• IN CAB HYDRAULIC GUTTER BROOM TILT RIGHT
• BACK LIT CONTROL CONSOLE & SEVERE WEATHER WIRING PACKAGE
• AUXILIARY FUSE PANEL - FOR LIGHTING ONLY
• SPARK RESISTANT SKIDS
• BACKUP AND HEAD CAMERA SYSTEM WITH COLOR MONITOR – 2 CAMERAS
• VARIABLE SPEED GUTTER BROOMS WITH HYDRAULIC SPEED CONTROL
• BATTERY DISCONNECT SWITCH- AT BATTERY BOX
• AUTO SWEEP INTERRUPT SYSTEM – IN REVERSE
• OPERATOR TRAINING DVD, PARTS, SERVICE & OPERATOR MANUAL

AUXILLARY ENGINE

• LO NOISE TURBO CHARGED ENGINE TIER 4F 99HP MINIMUM
• FUEL TANK SHARED WITH CHASSIS
• HD AIR CLEANER WITH TURBO PRE CLEANER/FILTER MINDER
• AUTO SHUTDDWN FOR LOW OIL AND HIGH TEMPERATURE AND LOW COOLANT

SWEEPER MODULE

SWEEPER HEAD SHALL BE A HIGH SPEED RUNWAY TYPE HEAD USING AIR ONLY AND SHALL BE CAPABLE OF SWEEPING BETWEEN 15-25 MPH AND SHALL PASS THE MILITARY RUNWAY SWEEP TEST USING AIR ONLY.  LATERAL AIR FLOW NOZZLE MOUNTED ON LEFT SIDE (REPLACES LEFT GUTTER BROOM)

              BLOWER:

• HIGH VOLUME

• NITRONIC STAINLESS STEEL
• RUBBER LINED BLOWER WITH NOISE REDUCTION

              DUST CONTROL SYSTEM:

• CENTRIFUGAL DUST SEPARATOR SYSTEM
• SEPARATE HOLDING FOR FINE PARTICLES
• DUST CONTROL SYSTEM W/330 GALLON TANK W/ IN CAB LEVEL GAUGE
• AIR OPERATED DIAPHRAGM PUMP WITH HIGH VOLUME WASH DOWN HOSE
• HIGH OUTPUT WATER SYSTEM W/EXTRA NOZZLES FOR EXTREME DUST CONTROL

              HOPPER:

• STAINLESS STEEL HOPPER
• CAPACITY- 7 CU YARDS MINIMUM
• HOPPER SUCTION THROAT LINER WITH INLET WEAR FLANGE
• HOPPER LOAD INDICATOR W/ IN CAB WARNING
• DUAL HOPPER INSPECTION DOORS W/ IN CAB DUMP SWITCH
• STAINLESS STEEL SCREEN, WIRE WOVEN 1/4" MESH CHIP SCREEN SPLIT TYPE
• 36” MINIMUM DUMP HEIGHT
• AMBER STROBE W/LIMB GUARD AND FLASHERS ON REAR
• HIGH OUTPUT WATER SYSTEM AND DUAL HOPPER WATER
• AIR PURGE ON WATER SYSTEM
• HOPPER DELUGE CLEAN OUT SYSTEM WITH MINIMUM OF FOUR (4) NOZZLES & HYDRANT HOOKUP
• LEAF PRESSURE BLEEDER
• ABRASION PROTECTION PACKAGE WITH BOLT IN RUBBER LINERS
• AUXILIARY 8" SUCTION HOSE WITH HYDRAULIC ASSIST BOOM
• AUX HAND HOSE SHALL INCLUDE A WIRELESS REMOTE CONTROL ATTACHED TO THE HAND HOSE WITH ENGINE START/STOP, THROTTLE CONTROL, HYDRAULIC UP/DOWN CONTROLS. 
• ADDITIONAL KEY FOB WIRELESS CONTROL WITH THE SAME FUNCTIONS SHALL BE INCLUDED.

WARRANTIES –

CHASSIS

• 24 Months and Unlimited Mileage
• Engine Coverage is 36 Months and Unlimited Mileage
• Drive Train Coverage is 36 Months and Unlimited mileage
• Frame Coverage is 60 Months and Unlimited Mileage
• Cab Corrosion Coverage is 60 Months and Unlimited Mileage
• Towing 12 Months
• Warranty Coverage is 100% Parts and Labor

SWEEPER MODULE ENGINE

• BASIC WARRANTY IS 24 MONTHS OR 2,000 HOURS
• EXTENDED WARRANTY IS 60 MONTHS OR 5,000 HOURS.
• WARRANTY COVERAGE IS 100% PARTS AND LABOR

SWEEPER MODULE

• 12 Months or 1,000 Hours
• Warranty Coverage is 100% Parts and Labor

REPAIR/MAINTENANCE – Facilities must be certified by the manufacturer and within 150 miles of Dugway Proving Grounds.

The Requiring Activity for this procurement is the West Desert Test Center, BLDG 4223, Dugway Proving Ground.  The Buy American Act is in effect.  Shipping shall be through traceable means.  FOB: Destination.