08380_DOUBLE SWING DOORS.pdf

Ohio Army National Guard Armed Forces Reserve Center/Field Maintenance Shop

Springfield, Ohio ARNG Project #390169 / 390170

3280-20 DOUBLE SWING DOORS 08380 - 1

SECTION 08380 – DOUBLE SWING DOORS

PART 1 - GENERAL

1.01 SECTION INCLUDES

A. Double Swing Doors.

B. Hardware and accessories.

1.02 SUBMITTALS

A. Submit under provisions of Section 01300.

B. Product Data: Manufacturer’s data sheets on each product to be used, including:

1. Preparation instructions and recommendations.

2. Storage and handling requirements and recommendations.

3. Installation methods.

4. Operation and maintenance data.

C. Shop Drawings: Show fabrication and installation details; include door elevations, head, jamb, and meeting stile details including full or partial gaskets.

1.03 DELIVERY, STORAGE, AND HANDLING

A. Store products in maufacturer’s unopened packaging until ready for installation.

1.04 PROJECT CONDITIONS

A. Maintain environmental conditions (temperature, humidity, and ventilation) within limits recommended by manufacturer for optimum results. Do not install products under environmental conditions outside manufacturer’s absolute limits.

1.05 WARRANTY

A. Manufacturer’s standard two-year warranty that products are free of defects in material and workmanship, guaranteeing to replace (exclusive of feight and labor) parts proven defective within two years after date of shipment to purchaser.

PART 2 - PRODUCTS

2.01 ACCEPTABLE MANUFACTURERS

3280-20 DOUBLE SWING DOORS 08380 - 2

A. Available Manufacturers: Subject to compliance with requirements, manufacturers offering standard food service and double swing doors which may be incorporated in the work include;

but are not limited to, the following:

1. Standard Double Swing Doors:

a. Custom Quality Products, Inc.

b. Chase Doors.

c. Aleco Division E.S. Robbins Corp.

d. Eliason Corp.

2.02 DOUBLE SWING DOORS

A. Double Swing Doors: 16 gauge (2.38 mm) stainless steel, delta formed vertical edges; stainless steel upper hinge covers; mounting screws for flush jambs.

1. Windows: 9 inches wide X 14 inches high.

2. Window Molding: Black rubber molding.

3. Glazing: Clear acrylic.

2.03 HARDWARE AND ACCESSORIES

A. Hinges: Double Action Easy Swing® proprietary hinges or equal.

1. Finish: Zinc coated

PART 3 - EXECUTION

3.01 EXAMINATION

A. Do not begin installation until substrates have been properly prepared.

B. Verify jambs plumb and square.

C. If substrate preparation is the responsibility of another installer, notify Architect of unsatisfactory preparation before proceeding.

3.02 PREPARATION

A. Clean surfaces thoroughly prior to installation.

B. Prepare surfaces using the methods recommended by the manufacturer for achieving the best result for the substrate under the project conditions.

3.03 INSTALLATION

A. Install in accordance of maufacturer’s instructions.

3280-20 DOUBLE SWING DOORS 08380 - 3

B. Minimum jamb construction of double studded 2x4 wood construction or equivalent.

C. Reinforce hollow metal jambs at hardware locations.

D. Steel channel jambs are required for heavy duty double swing doors.

3.02 PROTECTION

A. Protect installed products until completion of project.

B. Touch-up, repair or replace damaged products before Substatial Completion.

C. Final Adjustments: Check and readjust operating hardware items, leaving steel doors and frames undamaged and in complete and proper operating condition.

END OF SECTION 08380