QA_Seat_Cushions.docx

Questions & Answers for:

C-17 Seat Production 13 September 2016 Questions:

1. What thickness (2” foam, 4”, etc.) are the seat cushion and seat back required to be? (length and width were provided in the RFP)

a. 4”

2. Will a drawing be provided for fabrication of both the seat cushion and back or is that part of the RFP for winning bid to provide?

a. No, drawing must be provided by vendor and approved by the Government prior to production.

3. Will both an existing cushion and back be provided to the winning bidder for template replication guidance (reference)?

a. No.

4. Does the existing seat back have a pocket required to be duplicated?

a. No.

5. Please verify both cushion and back will be required to have burn certifications provided?

a. Material listed within Statement of Work provides sufficient burn rate.

6. Are you able to provide more technical info such as drawings or photos?

a. No. It is the contractor’s responsibility to create the requirements based off the provided Statement of Work. Also, contractor shall provide drawings prior to production.

7. We do not use the Confor Foam, we do use a memory foam, which we could quote. Would this material be acceptable?

a. No, the Confor Foam is specific to these cushions.

8. Are the cushions just basic rectangles?

a. No, these cushions will be made to conform to the seat and the person sitting in them.