1427_Statement_of_Work.pdf

CONTRACT REQUIREMENTS STATEMENT OF WORK

7 July 2016

Project Number, Title: VGLZ 162030 INSTALL CARPET AND EPOXY FLOOR HANGAR 1427.

The contract specifications and Selfridge Vision 2020 Standards (supplied with solicitation package) apply to this requirement. The work shall be in strict compliance with those specifications and the requirements identified in this

Statement of Work (SOW) and its attachments. Sections of this requirement may supersede the requirements of any generic specifications, in which case the more stringent / higher quality requirements shall apply.

1. This requirement provides for, but is not limited to:

A. Installation of epoxy floor and base molding shall be installed in the indicated green colored areas highlighted on the attached drawings including the stairs and landings. Epoxy floor color is to be either white or gray. The excluded areas will be areas called out in the drawings as “Not in Contract” (N.I.C.).

Epoxy floor square footage for this project is to be 2058 sq. ft.

B. Installation of new carpet and base molding shall be installed in the indicated blue colored areas highlighted on the attached drawings. Carpet color selections to be supplied by contractor and chosen by government. Carpet square yardage is to be 534 sq. yd.’s. for this project.

C. The contractor is responsible for all floor preparation and repairs to the floor prior to the carpet and epoxy floor installation. The use of floor stone and / or tile is acceptable.

D. Skilled craftsman shall do all work in a careful and workman like manner. The installation of carpet tiles shall be in accordance with the Manufacturers recommendation and utilizing the best, current method of the trade.

E. Carpet tile shall be directly glued down using commercial grade glue as per manufacturer recommendations, Doubled glue. Seam / edge sealer to be used on all cut edges.

F. Carpet to be 100% commercial grade. Carpet shall be 28 oz...

G. Dimension and layout of area’s to be carpeted and epoxy floor are for informational purpose only, and are not to be used as a pattern for cutting and fitting. The contractor shall take their own on site measurements for exact SY / SF and LF of carpet, epoxy floor and base to be installed. This will be performed during scheduled site visit.

H. Carpet is to be measured, cut, and installed by the contractor.

I. Four-inch wide vinyl / rubber cove base molding to be installed by the contractor after the carpet and the epoxy floor is installed. Molding shall be 1/8 in. thick commercial grade and be the color to match / accent carpet and epoxy floor color. All exposed edges to be shielded with a protecting vinyl / metal strip. Color selections to be supplied by contractor and chosen by government. Cove base molding is to be 2018 linear feet for this project.

J. It shall be the contractor’s responsibility to field verifies the square feet / linear feet dimensions of material needed to complete this project. This will be accomplished by interested contractors during the scheduled site visit.

2. The following options shall be used in lieu of the options listed in the generic Selfridge construction contract specifications:

A. N/A

3. Additional specifications for materials or requirements not included in the specifications:

A. PATCRAFT COMMERCIAL GRADE CARPET 28 oz. or approved substitute.

B. REZSTONE EPOXY FLOOR or equal.

CONTRACT REQUIREMENTS STATEMENT OF WORK

4. The following attachments are included in this requirement:

A. 1 DRAWING DATED