Attachment 8 - DDWG Tire Rack and Divider Specs.pdf

Tire Rack and Divider Spec Sheet

Tire Stacking Frames: The storage aides are required to store aircraft tires on their tread to prevent damage to the tire side walls. The frames need to stack up to 4 high and have fork pockets for use with a 4K forklift for stacking the frames up to four high in a bulk storage configuration.

Standard Features:

• Tire stacking rack weldments stack together for instant forklift ready storage.

• Locating feet on the top and bottom of the weldment allow the weldments to be stacked one on top of another, minimizing the danger of weldment misalignment

• Units are made of 3” x 3” tube steel in a rigid post and brace structure that provides maximum strength

• Stacks shall be no higher than four levels and then only when floor is level, smooth, load bearing, and in good condition

• Racks shall have two inverted ¼ in angles welded into the frame that serves as the tire shelf for tires to be stored on the tread.

• Individual Rack Dimensions:

o Width: 72" wide, 24” 0 ins. D, 42 ins. H, small size, 3000 lb. capacity, qty. 20 o Width 72” wide, 36” ins. D, 54 ins. H medium size, 3000 lb. capacity, qty. 40 o Width 72” wide, 48” ins. D, 64 ins. H large size, 4000 ls. Capacity, qty 40

Wire Dividers – Pallet Rack, Bay 368 A: The pallet racks in Bay D will have three wire dividers per each of the seven storage levels. The dividers shall be the hanging type, nominal dimensions (40.25”D x 26.25”H, mesh, 4GA, Galvanized (for storage levels 1 through 6) and 40”D x 26”H, mesh, 4 GA, Galvanized Kwik Clip Type for the seventh level. Quantities shall be as follows:

a. Free Standing: 240

b. Kwik Clip Type: 720