SOW_Insulation_CGC Resolute (1).docx

STATEMENT OF WORK (SOW)

FOR

USCGC RESOLUTE INSULATION RENEWAL

BACKGROUND

USCGC RESOLUTE has degraded piping and compartment insulation in multiple compartments. Contractor work is required to complete the project, including the removal of old insulation and installation of new. Contractor will need an escort on board Coast Guard Sector Saint Petersburg South Moorings.

PUBLICATIONS

SFLC STD Spec 0000, General Requirements SFLC STD Spec 6310, Requirements for Preservation of Ship Structures SFLC TS508, Thermal Insulation for Piping and Machinery SFLC TS635, Thermal, Fire, and Acoustic Insulation Design Standards ASTMF683, Standard Practice for Selection and Application of Thermal Insulation for Piping and Machinery

COAST GUARD DRAWINGS

DWG 627-WMEC_635_004, Sheathing and Insulation Hull, Galley, Scullery, and Ventilation Duct Details 627WMEC_635_002, Sheathing & Insulation 627-WMEC_514_1, Diagram: Heating and Chilled Water System 627-WMEC_514_2, Arrangement of Chilled and Hot Water System IMS 627-WMEC_514_3, Arrangement of Chilled and Hot Water OMS 627-WMEC_516_5, Diagram of Refrigeration System

SECURITY REQUIREMENTS

All contractor personnel requiring access to the place of performance to conduct work under this contract must possess a valid state-issued REAL ID compliant driver’s license or identification card, or an acceptable alternative form of identification as defined by the Department of Homeland Security (DHS) [https://www.dhs.gov/real-id]. It is the contractor’s responsibility to ensure that all personnel are properly credentialed to gain base access. Failure to comply with access requirements may result in delays with performance and will not constitute an excusable delay.

SCOPE

This work item includes removing existing and installing new of approximately 250 LF of anti-sweat piping insulation and of approximately 250 SF of bulkhead and overhead insulation. Table 1 identifies the locations for the Contractor to renew designated insulation on piping and Table 2 identifies the same on bulkheads/overheads. The contractor will work in berthing spaces, passageways and machinery spaces. Contractor is responsible for cleanup and disposal of insulation debris.

GENERAL INFORMATION

Government Furnished Items and Services:

The Government must provide the facilities, equipment, materials, and services listed here at no cost to the contractor: Potable Water and Single-Phase Electricity (120 Volt). The Government must provide the following material: None.

Contractor Furnished Items and Services:

Except for those items, services, or commodities specifically stated above as Government Furnished, the contractor must furnish everything needed to perform this contract.

Mold and Mildew:

If mold or mildew is discovered the contractor shall sanitize the material with bleach and remove in accordance with the Manual of Naval Preventative Medicine Chapter 2: Sanitization of Living Areas before continuing.

Coatings:

The contractor is also responsible for properly coating all insulation in accordance with SFLC TS 635 to prevent sweating. All work performed will be in accordance with the attached work specifications.

REQUIREMENTS

Complete work IAW with WORK ITEM 1: Piping Insulation, Renew, WORK ITEM 2: Compartment Insulation, Renew, and WORK ITEM 3: Ventilation Duct Insulation, Renew.

OTHER APPLICABLE CONDITIONS

Period and Time of Performance:

This work shall commence NLT May 25, 2026 and concludes NLT June 5, 2026.

The contractor must work between the following hours: Monday through Friday between 08:00 am and 20:00 pm unless other time is specified and approved by Unit POC.

Place of Performance:

1301 Beach Dr SE St Petersburg, FL 33701 POC: CGC Resolute/LT Logan Sullivan

Site Visit:

A site visit should be scheduled with the unit POC to provide interested parties with an opportunity to gain a better understanding of the requirements. Site visits must be scheduled and completed prior to 01May. To schedule, please contact LT Logan Sullivan. While participation in a site visit is not mandatory for the submission of a proposal, it is highly encouraged to ensure a comprehensive understanding of the project and its requirements.

Point of Contact (POC):

LT Logan Sullivan

(209) 662-4230 Logan.K.Sullivan@uscg.mil Table 1.

Linear Feet (approx.)

TOTALS (LF)

Table 2.

COMPARTMENT