SOW_7A11822_WSP_Rev1.docx

Procurement of ASR-9 Single-Pole, Double-Throw Switch Radar Product Division, AJW-L910

STATEMENT OF WORK

Procurement of WSP Single-Pole, Double-Throw Switch P/N 7A11822H01

1. BACKGROUND

Radar Product Division, AJW-L910, currently provides logistics support to 37 operational Weather System Processor (WSP) sites. The single-pole, triple-throw (SPDT) switch, resides in the weather channel between the airport surveillance radar (ASR-9) and the WSP. SPDT switches control the flow of RF to the dedicated WSP Receiver. The SPDT is obsolete and a commercial, off the shelf replacement is not available. The Federal Aviation Administration (FAA) has determined it necessary to replenish the existing stock of the WSP SPDT switch to maintain the long term support of the National Airspace System (NAS).

This Statement of Work describes the procurement of the Waveguide SPDT Switch 7A11822H01, NSN 5985-01-484-1797.

2. CONTRACTING OFFICER’S REPRESENTATIVE (COR):

The COR is formally designated this responsibility by the Contracting Officer to provide direction and Government oversight to the contractor on matters related to this contract. The TCOR is:

Kevin Palmer AJW-L910, Radar Technical and Program Support Branch Phone # 405-954-8083 Email address: kevin.c.palmer@faa.gov

3. SCOPE OF WORK

The contractor must furnish all labor, facilities, equipment, and materials to produce the WSP SPDT Switch for the FAA as outlined in each section that follow.

4. REQUIREMENTS

4.1 Design, Construction, and Testing

The contractor shall design, construct, and test the SPDT switch P/N 7A11822H01 in accordance with (IAW) Source Control Drawing (SCD) 7A11822 and testing procedures T364A77. Switching diodes must meet or exceed performance specifications laid out in SCD 584R574.

4.2 First Article Unit Delivery

Contractor must deliver two verification units with complete test data package illustrating conformance to SCD and 7A11822 and test procedures therein. Delivery shall occur no later than (NLT) 180 days at receipt of order (ARO).

4.3 Verification Unit Analysis

Upon receipt of first article units, FAA shall perform analysis to verify and ensure product conformance to requirements in SCD 645A863 and 7A11822 (mechanical, workmanship, finish, marking). Operational performance shall be evaluated via bench testing and in-system testing in accordance of MCP 1127. Bench tests will adhere to the procedures in T364A77 and PDS22933. System tests shall consist of installing the switch into the WSP waveguide and verifying performance IAW SCD 7A11822. FAA will have 180 days to accept or reject first article.

4.4 Production Units

The FAA may qualify one or more vendors as an approved source of production units upon successful unit acceptance. Delivery of production units shall occur NLT 90 days ARO

5. PREPARATION FOR DELIVERY

5.1 Preservation, packaging and packing

Preservation, packaging and packing shall be IAW Provision 61.