N4523A18R1054_RFC_004.pdf

REQUEST FOR SPECIFICATION CLARIFICATION

DATE OF REQUEST: 21MAY2018 QUESTION NO: 004

REQUIREMENT: N/A REQUISITION NO.: N4523A18R1054

ITEM NO: N/A

TITLE: HATCH REPAIRS

ISSUING OFFICE POC (CODE 440.22):

Brittany Chartier: (360) 476-5708 Brittany.chartier@navy.mil

PARA. NO: 3.4.10 PAGE NO: 34, SOW CONTRACTOR:

PLANNER’S NAME: ATTACH. NO: CONTRACTOR POC & PHONE:

CONTRACTOR QUESTION:

1. Gaskets for replacement under table 4 are incorrect. Reference DWG 100-4470023, Rev-D, SH 2.

(3)Hatches (QTY 4) are manufacture gaskets form-fitted to the equipment from Nashville Bridge Co.

P/N: DF-174.

Contractor recommends changing Para 3.4.10 to state: // Remove existing and install new gaskets IAW drawing 100-4470023 Rev-D SH 2, item (3) gasket only with like same gaskets from manufacture for locations on table 4. //

Gaskets are a one piece install. No cutting required. The proceeding Paragraphs are good.

DO NOT WRITE BELOW THIS LINE

SPEC CHG: Y DWG/REF CHG. N RQMTS CHG: Y MAT'L CHG: Y

TECHNICAL REVIEW: E. Baxter SERIAL NO: 004

3.4.10 Hatch Repairs: Remove existing and install new rubber gaskets at each location listed in TABLE 4 using drawing 100-4470023 (Item 3) Rev D sheet 2 for guidance. Gasket ends shall be cut square in lieu of mitered, as applicable. Via ERRATA ONE

ERRATA ONE updated Statement of Work (Attachment J-1) is included in Amendment 0003 of the solicitation posted to FBO.GOV.

ALL REQUESTS FOR CLARIFICATION MUST BE RECEIVED BY THE ISSUING OFFICE POC NO

LATER THAN THE DATE & TIME IDENTIFIED IN THE REQUEST FOR PROPOSAL.