N0010412RL001_0017.pdf

AMENDMENT OF SOLICITATION/MODIFICATION OF CONTRACT I. Contract ID Code I Page of Pages

1 1 2

') AmPnrlm;.:ant/t\/lnr1-if1r-.'.:lt-ir~n 1\Jn '1. HffP·r'ti\IP Tl·.:~tP. A RPnlli'-'11-inn/P\\rrh"AcP RPn t\.1" I" Pr<'ic>rt !\.!"

0017 06 JUNE 2013 N/A N/A

6. Issued By CODE N00104 7. Administered By (If other than Item 6) I NAVSUP Weapon System Support- Mechanicsburg 5450 Carlisle Pike P.O. Hox 2020 Mechanicsburg, P A 17055-0788

ATTN: Charles Splawn 717-605-4262

R. Name and Address of Contractor (No .. Street. Countv. State and ZIP) Code) 9A. Amendment of Solicitation No.

N00104-12-R-L001

X 9B. Dated (Sec Item II)

14 March 2012

I OA.Modification of Contract/Order No.

JOB. Dated (Sec Item 13)

Code jFacility Code

II. THIS ITEM ONLY APPLIES TO AMENDMENTS OF SOLICITATIONS

[X] The above numbered solicitation is amended as set forth in Item 14. The hour and date specified for receipt of OtTers ()is extended. (X ) is not extended. Offers must acknowledge receipt of this amendment prior to the hour and date specified in the solicitation or as amended, by one of the following methods: (a) By Completing Items 8 and 15. and returning 2 copies of the amendment: (b) By acknowledging receipt of this amendment on each copy of the otTer submitted: or (c) By separate letter or telegram which includes a reference to the solicitation and amendment numbers. FAILURE OF YOUR ACKNOWLEDGEMENT TO BE RECEIVED AT THE PLACE DESIGNATED FOR THE RECEIPT OF OFFERS PRIOR TO THE HOUR AND DATE SPECIFIED MAY RESULT IN REJECTION OF YOUR OFFER. If by virtue of this amendment your desire to change an offer already submitted. such change may be made by telegram or letter, provided each telegram or letter makes reference to the solicitation and this amendment. and is

12. ACCOUNTING AND APPROPRIATION DATA (If required)

N/A

N/A

13. THIS ITEM APPLIES ONLY TO MODIFICATIONS OF CONTRACTS/ORDERS,

A. THIS CHANGE ORDER IS ISSUED PURSUANT TO: (Specify Authority) THE CHANGES SET FORTH IN ITEM 14 ARE MADE IN THF l'ONTR Al'T OROFR NO ITFM I ()A

B. THE ABOVE NUMBERED CONTRACT/ORDER IS MODIFIED TO REFLECT THE ADMINISTRATIVE CHANGES (Such as

C. THIS SUPPLEMENTAL AGREEMENT IS ENTERED INTO PURSUANT TO AUTHORITY OF:

D. OTHER (Soecifv tvoe of modification and authority)

E. IMPORTANT: Contractor [ ] is not, [x] is required to sign this document and return .1_ copies to the issuing oflice. Attn: Code 0213.13

14. DESCRIPTION OF AMENDMENT/MODIFICATION (Organized by UCF section headings, including solicitation/contract subject matter where feasible.

The subject solicitation is amended as shown on page two of this amendment.

The time and date specified for receipt of proposals has not changed.

Except as provided herein, all terms and conditions of the document referenced in Item 9A or lOA, as heretofore changed, remains unchanged and

· full force and effect ...

15A. NAME AND TITLE OF SIGNER (Type or print) 16A.NAME AND TITLE OF CONTRACTING OFFICER (Type or print)

158. CONTRACTOR/OFFEROR 15C. DATE SIGNED 168. UNITED STATES OF AMERICA 16C.DATE

SIGNED

(Signature of person authorized to sign) (Signature of Contracting Officer)

N00104-12-R-L001, Amendment 0017

The following changes are made:

1. C.4.2. APPLICABLE DOCUMENTS, Section C.4.2.1 Document references listed below must be obtained by the Contractor, *NA VSEA SSSOO-AG-MAN/P-290 Rev A is corrected to *NA VSEA SS800- AG-MAN-OIO/P-290 Rev A.

2. C.4.3.9.1 Bid Sample, is replaced by the following:

C.4.3.9.1 Bid Sample

C.4.3.9.1 Two (2) inflatable "All-Up" craft, each of which will include the following accessories: two (2) equipment pockets, attachment straps to secure all removable accessories, one (I) paddle bag (six paddle capacity), connected to the boat via fastening clips, one (I) commercial technical manual, six (6) paddles with a dull black matte finish, two (2) manually operated int1ation pumps, each with hose and connectors, and one

(I) fabric covered slatted roll up t1oor, one (I) four leg single point lift, one (I) towing bridle, and one (I) bag for the storage and transportation of the boat when in its rolled up position. The one (I) emergency craft repair kit is to include: conical plugs, patches, clamps, and one (I) factory calibrated pressure gauge metered in PSI.

One rigid t1oor will be provided with each craft.

3. Section C.4.3.2 C, paragraph C.4.3.2.1 is replaced by the following:

C.4.3.2.1. The total weight of the All Up craft, as defined in section C.4.3.ll.l, shall not exceed 420 lbs.

4. Section C.4.3.2 Construction, paragraph C.4.3.3.7. Fittings, is replaced by the following:

C.4.3.3.7. Fittings: The craft shall be equipped with a total of 12 lifting handles (six port, six starboard) each capable of accommodating a gloved hand. A single lifeline of suitable strength muted or dull Black Nylon or Polyester Rope is to be fastened to the periphery of the craft atop the MBT. A minimum of 13 each heavy duty, dull-finished, corrosion resistant steel (CRES) D-rings shall be installed on the inside perimeter of the MBT to be used for securing equipment. Each D-ring is required to be rated for a minimum of I 00 lbs load.

Two (2) equipment pockets arc to be installed. Two "Grab-lines" are required to be securely fastened in the interior of the craft that traverses the interior length.

5. Section C.4.3.11 Craft Accessories, C.4.3.11.1 is replaced by the following:

C.4.3.11.1 The Bare craft manufactured for delivery to the Government is required to include the following accessories: one (I) commercial technical manual, attachment straps to secure all removable accessories, one

(I) four leg single point lift, one (I) towing bridle, one (I) bag for the storage and transportation of the boat when in its rolled up position. The All-Up craft manufactured for delivery to the Government is required to include the following accessories: two (2) equipment pockets, attachment straps to secure all removable accessories, one (I) paddle bag (six paddle capacity), connected to the boat via fastening clips, one (I) commercial technical manual, six (6) paddles with a dull black matte finish, two (2) manually operated inf1ation pumps, each with hose and connectors, and one (I) fabric covered slatted roll up i1oor, one (I) four leg single point lift, one (I) towing bridle, and one (I) bag for the storage and transportation of the boat when in its rolled up position. The one (I) emergency craft repair kit is to include: conical plugs, patches, clamps, and one (I) factory calibrated pressure gauge metered in PSI.