Minimum_Requirements_For_Aqueous_Parts_Washer.docx

Minimum Requirements for Aqueous Parts Washer

Aqueous Parts washer must be compatible with any of the three cleaning compounds required:

AIR FORCE TO 4W-1-61 and AF DWG 9825019-21 Calla 296

DSF-1

SB 300 LFM

Adequate ventilation must be provided:

Mechanical ventilation systems must meet requirements of AFOSH STD 48-137.

Rinse Required:

Rinse cycle required following clean cycle.

Drying required:

Forced Air drying cycle immediately after rinse cycle.

Minimum weight capacity:

1500 lbs.

Interior minimum dimensions:

Turntable dimensions (dual turntable) - Two vertically stacked 60” W turntables X 30” H working area.

Interior width measurements of washer with door closed need to be provided to ensure clearance between turntable and doors/walls of washer to prevent dragging against wheel surface. Current washer has an interior working dimension of 65” W x 65” L with door closed.

Exterior Maximum Dimensions:

94” L x 94” W x 95” H. This height measurement includes the installation of a ventilation system. Current unit equipped with side mounted ventilation unit. A flexible duct is routed to an installed stationary duct through the wall, and to the exterior of the building.

Door requirement:

The door to the unit must have the hinge on the right side so that the door will open from left to right.

Wall power unit:

Maximum 600V/60AMP. Current unit is a 460V three phase unit.

Removal of old washer:

Required Installation of new washer:

Required Training of personnel on equipment:

Required Options not listed above are not required