Attachment_1D4_Armstrong_Transmitter_Description_G300B_G1000B_Version_2.0.pdf
PDF 38 KB Posted
- Solicitation number
- EA-133W-17-RP-0101
About this file
SOW Attachment 1D4
View the file
Other files
Show all 30
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
ATTACHMENT 1D4_Ver2.0
ARMSTRONG TRANSMITTER DESCRIPTION FOR G300B AND G1000B
GENERAL
The entire system is delivered pre-wired and installed in a 19-inch rack mount cabinet. Program audio is normally supplied on a leased telephone line: control and monitoring functions are normally achieved with a dial-up telephone line. The Redundant Transmitter Controller (RTC) shares a dial-up line with an optional Remote Off-Air Monitoring System (ROAMS). Installation also requires connections to two primary AC power circuits and an antenna. Remote monitoring and control will require a computer with Armstrong software installed and a modem.
SPECIFICATIONS
Cabinet size: G300B – 23w x 34d x 48h (inches)
G1000B – 23w x 34 d x 54h (inches)
Cabinet size includes the bandpass cavity
Primary power: G300B systems require two 120 or 240 volt ac circuits; G1000B systems require two 208/240 volt ac circuits.
Telephone lines: One dial-up line with tone pad is required for monitor and control.
Operating environment: Temperature: -30°C to +50°C; humidity 10-95%; maximum altitude 12,000 feet.
Control and monitoring: ROAMS monitors and reports system status. Also, a microprocessor-based interface controls the system and monitors power output, SWR, power amplifier voltage and current, audio input level, deviation, primary ac voltage, and other critical parameters. Fault sensing initiates automatic switching of the transmitters.
Computer for remote operation: The minimum recommended computer is a Pentium based processor with 4 Gigabytes of RAM with 250 megabytes of free hard disk space, a serial RS-232C port, and a 56Kbaud modem. The system should run the Windows 7 operating system.
Transmission mode: Narrowband FM
RF frequency range: 162.400 to 162.550 MHz in 25 kHz steps
RF deviation: ±5 kHz
RF frequency stability: 0.00025%, -30°C to +50°C
RF power: G300B, 100-375 watts
G1000B, 300-1250 watts
Power measured with a 50Ω non-reactive load.
Load mismatch protection: Auto-foldback occurs at 3:1 SWR
Output impedance: 50 Ω unbalanced
Audio frequency resp: 200 Hz - 5 kHz, within +1/-3 dB of 6dB per octave pre-emphasis
Audio distortion: Less than 1.0%
FM hum and noise: Better than -40 dB
AM noise: Better than -40 dB
Spurious emission: Better than -74 dB
Power consumption: G300B – less than 750 Watts G1000B – less than 2400 Watts (with one tx in standby mode)
MTBF: Better than 10,000 hours
Audio input: 600Ω balanced
Input level: -20 dBm to +5dBm for ±5 kHz deviation
File details come from the government source that posted it. Updated .