CDRLs A001 DI-MGMT-80368AT Certificate.pdf

CONTRACT DATA REQUIREMENTS LIST

(1 Data Item)

Form Approved OMB No. 0704-0188

The public reporting burden for this collection of information is estimated to average 110 hours per response, including the time for reviewing instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing the burden, to the Department of Defense, Executive Services Directorate (0704-0188). Respondents should be aware that notwithstanding any other provision of law, no person shall be subject to any penalty for failing to comply with a collection of information if it does not display a currently valid OMB control number. Please do not return your form to the above organization. Send completed form to the Government Issuing Contracting Officer for the Contract/PR No. listed in Block E.

A. CONTRACT LINE ITEM NO. B. EXHIBIT C. CATEGORY:

TDP TM OTHER __X__

E. CONTRACT/PR NO. F. CONTRACTOR

1. DATA ITEM NO. 2. TITLE OF DATA ITEM 3. SUBTITLE

4. AUTHORITY (Data Acquisition Document No.)

DI-MISC-80508B/T

5. WSCONTRACT

PD 1.4.1.5

6. REQUIRING OFFICE

402 CMXG/MXDEF

7. DD 250 REQ

NO

9. DIST

STATEMENT

REQUIRED

A

10. FREQUENCY

SEE BLK 16

12. DATE OF 1ST SUBMISSION

SEE BLK 16

14. DISTRIBUTION

a. ADDRESSEE

b. COPIES

8. APP CODE

N/A

11. AS OF DATE

SEE BLK 16

13. DATE OF SUBSEQUENT

SUBMISSION

SEE BLK 16

Draft

Final

Reg Repro

15. TOTAL 0 1 0

J. DATE

DD Form 1423-1, FEB 2001 PREVIOUS EDITION MAY BE USED Page _ _ of __Pages

18. ESTIMATED

TOTAL PRICE

17. PRICE

GROUP

D. SYSTEM/ITEM

Die & Mold

1 1

DATE

A001 Technical Report

16. REMARKS

Blocks 11, 12, 13: Data shall be provided in contractor format no later than date of PDR and CDR.

The Contractor has the discretion of using their proprietary simulation software. Some other examples of commercial simulation software include SimuFact (MSC), Pam-Stamp (ESI Group), AutoForm or others recommended by Quintus (Manufacturer of the fluid cell equipment). The Contractor’s simulation software shall perform analysis using the 3D model geometry during the design simulation. The simulation pass/fail entails providing reports of the analysis results. The reports shall be provided using word documents or equivalent, that include items, i.e., color charts showing stress or strain results, deflections, displacements, etc. that were generated. These results will substantiate progress during preliminary design review (PDR) and critical design review (CDR)

E-Mail:

Technical POC cited on each Call.

SEE BLK 16

ELECTRONIC 0 1 0

I

A

P

P

R

O

V

E

D

B

Y

C r i s t i n e

L l a r k

Christine L. Clark Christine L. Clark31 May 2021 31 May 2021