Attachment 0007 MEOB3066.pdf

MAINTENANCE ENGINEERING ORDER

(AMCOM Reg. 750-2)

MEO NO.

DATE PAGE 1 of

TITLE Tolerances Unless otherwise noted, dimensions are in inches and tolerances are:

Fractional ………………… ± 1/32 Decimal ………………... ± 0.010 Angular ………………… ± ½°

APPLICABILITY CSI Critical Characteristic Affected?

Impact Statement Attached?

REFERENCES FOR RDECOM USE ONLY

DOCUMENT(S) AFFECTED

PURPOSE OR PROBLEM

PROJECT ENGINEER ENGINEERING REVIEW ENGINEERING RELEASE

MED FORM 5-DEC-09 1401-R-E

AR 70-62 •11 May 2016 B 3066

Apr 9, 2018 1

Update of T700 White Light Inspection Requirement (T700, T401, T401C, T701C, T701D)

Technical

INTERIM USE OF THIS MEO IS AUTHORIZED

UNTIL AFFECTED DOCUMENT IS UPDATED.

MEO CHANGE TYPE

4) Normal - Can be implemented with normal priorityPRIORITY IMPLEMENTATION CATEGORY

T700 DAX

DMWR 1-2840-248-2 dtd 30 September 2014 TN 181775

MEC B334335, RLTA 201801664

DOCUMENT CHANGE IS REQUIRED Verification: Hands-On Table-Top None

To update the T700 white light inspection procedure to take into account modern lighting technologies such as incandescent, LED and fluorescent light sources.

PELTIER.JARED.

RYAN.152335277

Digitally signed by

PELTIER.JARED.RYAN.1523352772

DN: c=US, o=U.S. Government, ou=DoD, ou=PKI, ou=USA, cn=PELTIER.JARED.RYAN.1523352772 Date: 2018.03.21 16:36:18 -05'00'

MCCORD.MATT

HEW.KIRKLAND.

1275198800

Digitally signed by

MCCORD.MATTHEW.KIRKLAND.1275198800

DN: c=US, o=U.S. Government, ou=DoD, ou=PKI, ou=CONTRACTOR, cn=MCCORD.MATTHEW.KIRKLAND.1275198 Date: 2018.03.21 09:15:31 -05'00'

Matthew K. McCord

HORN.REINHOL

D.J.1087783495

Digitally signed by

HORN.REINHOLD.J.1087783

Date: 2018.03.21 17:34:59 -05'00'

Jared R. Peltier Reinhold J. Horn PUBLICATION CHANGE REQUEST: REQUEST THAT THE FOLLOWING DATA BE INCLUDED IN THE NEXT

CHANGE OR REVISION TO THE PUBLICATION IDENTIFIED ABOVE.

WP NO. PAGE

NO.

PARA-

GRAPH

FIGURE/

TABLE

NO.

CHANGES

(EXACT WORDING OF CHANGES MUST BE GIVEN)

3-532 3-63.b.

CHANGE paragraph b. to read as follows:

"Inspect the part for cracks under a bright white light utilizing a 150 watt standard spotlight or 40 watt high intensity spotlight or equivalent to acquire necessary illumination. The light source shall produce 100 foot-candles minimum luminance on the inspected surface."

Distribution Statement D:- Distribution authorized to Department of Defense and U.S. DoD contractors only to protect critical technology effective as of 26 June 2014. Other requests for this document must be referred to U.S. Army Aviation and Missile Research, Development and Engineering Center, ATTN: RDMR -AEM , Corpus Christi, TX 78419-5211

MED FORM 04 APR 2017