Marine Construction - West Bulkhead Replacement at the Cape Cod Canal East Boat Basin in Sandwich, MA
Closed Pre-Solicitation Posted
This opportunity was awarded. See the award notice from , or the latest solicitation from .
- Solicitation number
- W912WJ24B0013
- Agency
-
ENDIST New England
US Army Corps of Engineers, Department of Defense
- Responses due
- Set-aside
- No set-aside
Opportunity facts
- NAICS code
- 237990 Other Heavy and Civil Engineering Construction
- Place of performance
- Sandwich, Massachusetts, United States
- Points of contact
Notice details come from SAM.gov. Updated .
About this opportunity
Paragraph 1:
The Department of the Army Corps of Engineers Engineering District New England is seeking contractors to replace the west sheet pile bulkhead at the East Boat Basin in Sandwich, Massachusetts. The project will involve installing approximately 440 linear feet of new steel sheet piles, concrete deadmen, tie rods, and whalers, as well as replacing lighting, bollards, cleats, fencing, sidewalks, and storm drains. Key requirements include raising the bulkhead by 18 inches, installing temporary bike paths, and restoring the area upon completion. Interested parties must access the solicitation documents through the Procurement Integrated Enterprise Environment (PIEE) website, and any questions can be directed to the Contract Specialist.
Paragraph 2:
This contract opportunity is not set-aside for any specific business size or type. There is no information provided about any current or incumbent contractors. The notice does not specify an estimated contract value or budget range. The only numerical details provided are the approximate length of the new bulkhead and the requirement to raise it by 18 inches.
Notice text
The East Boat Basin is a small sheltered harbor for small craft located near the east end of the Cape Cod Canal on the Cape side in Sandwich, Massachusetts. On both sides of the entrance to the harbor, facing the canal, are sheet pile bulkheads. This project will replace the west sheet pile bulkhead with a completely new bulkhead. The existing west bulkhead is approximately 300 feet long with two 60 foot long returns. Behind the bulkhead is a restaurant, a fish unloading station, a parking lot, and open space for public recreation with picnic tables, benches, etc.
The existing sheet pile bulkhead, installed in the mid 1980's, is significantly corroded with section loss and damage to structural supports. The existing steel sheet piles were installed five feet in front of an older sheet pile bulkhead, age unknown. The older sheet piles were then cut off about 10 feet below grade. The piles are connected via steel tie rods to a series of concrete dead men located about 50 feet back from the piles. The dead men and portions of the steel tie rods predate the 1980's work.
Specific works tasks include, but are not limited to, the following:
a. Install new temporary bike path to divert pedestrians around project area. Restore area to original condition upon completing of bulkhead installation.
b. Install approximately 440 linear feet of steel sheet piles with interior whalers to create a new bulkhead about five feet in front of the existing bulkhead sheets. Bulkhead top shall be 18 inches higher than existing bulkhead top. Install a system of wood fender piles to protect against ships and boats.
c. Install new concrete dead men, tie rods and waler connected to new PZ40 sheet piles.
d. Cut off the existing steel sheet piles about 10 feet below grade. Backfill the space between old and new sheet piles with crushed stone.
e. Replace light system and existing conduits and protect existing associated power supply system.
f. Install new bollards, cleats and concrete foundation for crane davit to replace existing.
g. Install a new fence, sidewalk and curb along the entire length of the bulkhead.
h. Install new driveway and gate for truck loading at the bulkhead.
i. Install new concrete pads for picnic tables and other park features.
j. Repair/replace storm drains disrupted by the construction.
k. Install new timber bumper piles at corners of the new bulkhead.
l. Replace rip-rap as needed near the two returns.
This is not an invitation for bids at this time. The solicitation requirements and contract documents to include instructions for submission (which may include definitive responsibility criterion) and the response date will be available on or about June 24, 2024. Neither telephonic, mailed nor fax requests for hard copies will be accepted. The solicitation will only be available online; in order to view the solicitation offerors must access the System for Award Management website (www.sam.gov). To download the solicitation, offerors must access the Procurement Integrated Enterprise Environment (https://piee.eb.mil/), solicitation module. Amendments, if any, to the solicitation will be made available at the PIEE website. Registrants are responsible for the accuracy of the information on the SAM.gov Registration List. All responsible sources may submit a bid which shall be considered by the New England District. Additional questions may be emailed to the Contract Specialist at tyler.s.maryak@usace.army.mil. This notice does not commit the U.S. Government to contract for any supply or service.
Notice history
| Notice | Type | Posted |
|---|---|---|
| Marine Construction - West Bulkhead Replacement at the Cape Cod Canal East Boat Basin in Sandwich, MA | Award Notice | |
| Marine Construction - West Bulkhead Replacement at the Cape Cod Canal East Boat Basin in Sandwich, MA | Solicitation | |
| This notice | Pre-Solicitation | |
| Marine Construction - West Bulkhead Replacement at the Cape Cod Canal East Boat Basin in Sandwich, MA | Pre-Solicitation |
Similar open opportunities
| Opportunity | Agency | Set-aside | Responses due |
|---|---|---|---|
| JP Murtha Float Mooring Bitts Retrofit | ENDIST Pittsburgh | No set-aside |
On GovTribe
Work this opportunity
- Track it in your pipeline
- Find teaming partners
- Similar opportunities
- Ask GovTribe AI about this opportunity