Antenna Modification/Radio Cabling

Added: Feb 04, 2016 9:39 am Install Forest Service supplied 20' tower section (does not include bolt hardware or climbing pegs) to top of existing erected 100' tower. Correct misaligned climbing pegs with the fall protection cable, fall protection cable will require replacement to the full height. Install contractor supplied ice bridge between tower and shelter. Install six (6) antennas, and associated RF (AVA5) cables. Relocate existing antenna to side arm mount using existing feedline and lowered as needed to accommodate the construction of the top section.

There is an existing 24 pair communication cable that terminates in the vehicle garage, from this point install new conduit to cross overhead of garage and down opposite wall existing wall and then going underground to communication shelter near the tower. Run cabling from existing 24 pair cable for 10 pairs to shelter in new conduit run, terminate cable in a coil inside the shelter equipment rack.

In the existing 3 phase 60 Amp breaker panel located in the vehicle garage install new breaker. Install new conduit and feed to cross overhead of garage and down opposite wall existing wall and then going underground to the communications shelter. Connect power to the existing 100 Amp 120/240VAC shelter main breaker.

Building has four coiled grounding conductors that need to routed thru existing wall penetrations in each corner and properly grounded.