A-10 Wing Setup & Milling IDIQ

The 309th Commodities Maintenance Group (CMXG) has a requirement for a follow-on service contract for A-10 110 Splice Fitting Milling. The milling services shall be performed at the contractor's facility in support of the 533rd A-10 wing shop located at Hill Air Force Base, Utah. The milling services shall be performed in accordance with (IAW) applicable Air Force technical data and engineering drawings, and shall be completed by the contractor within five (5) business days. The wing sets (each consisting of two (2) Outer Wings and one (1) Center Wing) require a minimum of four (4) machining setups by the contractor, two (2) for each Center Wing and one (1) for each Outer Wing.

The contractor shall provide the determination of datum's and the machining of A-10 110 splice fittings for both left and right outer wings, and the two sides of the center wing. The contractor shall inspect the wings for damage and, if found, report those findings to Hill Air Force Base within 24 hours. The contractor shall establish a datum reference, establish a "Best-fit" plane, and verify that the milling of surface will meet dimensional requirements. The contractor shall then mill the splice fitting surfaces and verify final dimensions. The contractor shall provide all management, tools, supplies, equipment, and labor necessary to perform milling services for the 110 splice fitting of the A-10.

Please see the Combined Synopsis/Solicitation for more information.

.