Y22-7013_Part_H_Technical_Provisions.pdf

PART H

TECHNICAL PROVISIONS

TP 603 – Signalization

H-1 Revised 05/16/22

SIGNALIZATION

The signalization shown on the plans shall be constructed in accordance with Sections 603, 632, 633, 634, 641, 646, 650, 653, 660, 663, 665, 670, 671, 682, and 700 of the “Standard

Specifications”, except where noted on the plans and indicated by the following Technical

Provisions. All traffic signal equipment shall be listed on the Florida Department of

Transportation's Approved Products List.

SHOP DRAWINGS

The Contractor shall provide shop drawings for all signalization equipment and installation. These shop drawings will be reviewed and approved by the Engineer prior to the

Contractor placing orders for the signalization equipment and beginning construction.

SIGNAL CABLE

Signal Cable shall conform to the requirements of Section 632 of the “Standard

Specifications” except payment will be included in the lump sum price for signalization.

SPAN WIRE ASSEMBLIES

Span wire assemblies shall be furnished and installed according to Section 634 of the

"Standard Specifications" except payment will be included in the lump sum price for signalization.

PRESTRESSED CONCRETE POLES

Prestressed concrete poles shall be furnished and installed according to Section 641 of the

"Standard Specifications" except payment will be included in the lump sum price for signalization.

ALUMINUM POLES, PEDESTALS AND POSTS

Aluminum poles, pedestals and posts shall be furnished and installed according to Section

646 of the "Standard Specifications" except payment will be included in the lump sum price for signalization.

VEHICULAR TRAFFIC SIGNAL ASSEMBLIES

Vehicular traffic signal assemblies shall conform to Section 650 of the “Standard

Specifications” except payment will be included in the lump sum price for signalization.

Orangewood Blvd. & Gateway Ave.

TP 603

TP 603 – Signalization

H-2 Revised 05/16/22

PEDESTRIAN SIGNAL ASSEMBLIES

Pedestrian signal assemblies shall conform to Section 653 of the “Standard Specifications” except payment will be included in the lump sum price for signalization.

VEHICLE DETECTION SYSTEM

Vehicle detection systems shall be furnished and installed according to Section 660 of the

“Standard Specifications” except payment will be included in the lump sum price for signalization.

Each loop assembly shall include loop lead-in cable to connect the loop to the loop detector in the controller cabinet.

SIGNAL PRIORITY AND PRE-EMPTION SYSTEMS

Signal priority and pre-emption systems shall conform to Section 663 of the “Standard

Specifications” except payment will be included in the lump sum price for signalization.

PEDESTRIAN DETECTOR ASSEMBLIES

Pedestrian detector assemblies shall be furnished and installed according to Section 665 of the “Standard Specifications” except payment will be included in the lump sum price for signalization.

TRAFFIC CONTROLLERS

Traffic Controllers shall conform to the requirements of Sections 670 and 671 of the

“Standard Specifications” except payment will be included in the lump sum price for signalization.

VIDEO EQUIPMENT

Video equipment shall conform to Section 682 of the “Standard Specifications” except payment will be included in the lump sum price for signalization.

HIGHWAY SIGNING

Highway signing shall conform to Section 700 of the “Standard Specifications” except highway signing shown on the traffic signal plans will be paid as part of the lump sum price for signalization.

Orangewood Blvd. & Gateway Ave.

TP 603

TP 603 – Signalization

Orangewood Blvd. & Gateway Ave.

TP 603

H-3 Revised 05/16/22

METHOD OF MEASUREMENT

Quantities measured for payment under this Section shall be in lump sum for each complete traffic control signal system installed at an intersection.

BASIS OF PAYMENT

Signalization will be paid for at the contract lump sum prices for each traffic control signal system installed at an intersection, completed and accepted. The cost of the signal communication system between signals shall be included in the contract price for each intersection signalization.

Payment shall constitute full compensation for all work described herein and shown in the plans.

Payment shall be made under:

ITEM NO. 603-1 SIGNALIZATION LUMP SUM (LS)

TP 700 - Highway Signing

Orangewood Blvd. & Gateway Ave.

TP 700

H-4

HIGHWAY SIGNING

The furnishing and installing of all Highway Signing as shown on the plans shall conform to the requirements of Section 700 of the Standard Specifications, except as amended herein or as directed by the Engineer. All highway signs shall be of the type specified and installed at the locations shown on the plans.

The materials and methods shall comply with Sections 700-3 through 700-6 of the Standard Specifications and shall be accepted by the Orange County Traffic Engineering Division prior to installation.

Sign posts for single column signs shall be a minimum of 14 gauge 2”x2” square welded steel with 3/8” knockouts on 1” centers on al four sides. The posts shall be listed on the FDOT’s Qualified Products List and shall be galvanized and sealed with a polymer topcoat.

Method of Measurement

The quantities measured for payment under this Section shall be in accordance with Article 700-2.3 of the Standard Specifications.

Basis of Payment

Payment for furnishing and installing highway signs shall be in accordance with Section 700-

2.4 of the Standard Specifications.

Payment shall be made under:

Pay Item:

700-1-11 Single Post Sign, F&I Ground Mount, up to 12 SF AS 700-1-50 Single Post Sign, Relocate AS 700-1-60 Single Post Sign, Remove AS

TP 900-1- As Built Plans

Orangewood Blvd. & Gateway Ave.

TP 900-1

H-5

AS-BUILT PLANS

The As-Built Plans shall incorporate all the changes made to the red line As-Built plans. They shall show locations and elevations of paving, swales, ditches, pipe inverts and structures constructed and all relocated or reset property corners, section corners and 1/4 section corners.

Upon the completion of the project, the Contractor shall submit to the County one

(1) set of 24”x36” paper Full Size Drawings with Statement of Certifications, certifying that the project was constructed according to the Construction Plans and Specifications, and that the AS BUILT PLANS are correct representation of what was constructed. The plans shall delineate all red line information contained on the As-Built Plans.

The Contractor shall include the Statement of Certification on either the cover sheet certifying all of the sheets or certify each individual sheet. The Statement of Certifications shall be signed and sealed by a Professional Engineer and/or a Professional Surveyor and

Mapper, both registered in the State of Florida.

Basis of Payment

As-Built Plans will be paid for at the contract lump sum price, completed and accepted.

Payment shall be made under:

Pay Item:

900-1 As-Built Plans Lump Sum

TP 900-2 Indemnification

Orangewood Blvd. & Gateway Ave.

TP 900-2

H-6 Revised 05/16/22

INDEMNIFICATION

The Contractor shall indemnify, defend, and hold harmless the COUNTY and all its officers, agents, and employees, from all claims, losses, damages, costs, charges, or expenses arising out of any acts, action, neglect, or omission by the Contractor during the performance of the Contract, whether direct or indirect, and whether to any person or property to which the COUNTY or said parties may be subject, except that neither the Contractor nor any of its subcontractors are liable under this Section for damages arising out of the injury or damage to persons or property directly caused or resulting from the sole negligence of the COUNTY or any of its officers, agents, or employees.

Payment shall be made under:

Pay Item:

900-2 Indemnification Lump Sum ($100.00)