A02 DOR_RiverGageMonitoringandObservation V1(revised).pdf

Description of Requirement Atmospheric and River Elevation monitoring Equipment Purchase

The Geotechnical and Structures Laboratory (GSL) of the U.S. Army Engineer Research and Development Center (ERDC) at Waterways Experiment Station requires highly accurate, reliable measurements and observations of river water levels and atmospheric conditions of the Santa Margarita River at the Marine Corps Air Station (MCAS) Camp Pendleton, CA. To accomplish this, the following is required:

1. Equipment/Software: The monitoring equipment necessary for this project includes the ability to measure water surface elevation from a given datum, camera for visual monitoring, lighting in support of the camera and existing staff gage, datalogger, and weather station. A software package is required for data retrieval and monitoring of equipment health. The data will be generated by the datalogger and sensors and communicated by the cell modem. Additionally, A physical gage was painted on the bridge pier recently, therefore a video and light are requested so the physical gauge can be seen at night (See Figure 1).

2. Initial Programming and Installation: The contractor is responsible for initial programming and installation of the equipment. The weather station and radar sensor are to be installed on a bridge that runs over the Santa Margarita River at MCAS Camp Pendleton, CA. ERDC personnel will be available during installation.

3. Technical Support: The contractor is required to provide technical support through the system’s design life. This includes telephonic and/or virtual technical assistance if needed to ensure equipment is fully operational.

Basic equipment and ancillary components necessary to meet the above requirements are as follows (components denoted with an asterisk will be delivered to MCAS Camp Pendleton):

Measurement Components

• *QTY 1: Wind Monitor 15ft cable per sensor (PW w/pre-wire connector)

• *QTY 1: 1x1 inch Nu-Rail Crossover Fitting

• *QTY 1: Texas Electronics Rain Gage 0.01 inch, tip w/6 inch orifice 15ft cable per sensor -PW w/prewire connector

• *QTY 1: CM270: TE525, TE525MM, or TE525WS Rain Gage Mounting Kit

• *QTY 1: CSL Digital Temperature/RH Sensor, w/M12 Connector, 17 w/17ft per sensor, PW w/Pre-wire Connector

• *QTY 1: METSPEC 10-Plate Solar Radiation Shield for Large Sensors

• *QTY 1: CSC Outdoor Observation & Surveillance Field Camera (-40 to 60 deg C), R2 w/RS-

232 comms

• *QTY 1: CC Camera or PWD22 mounting kit

• *QTY 1: CCFC Power & I/O Cable 15ft per cable, PW w/Pre-wire connector

• *QTY 1: Radar Water Level Sensor, 114.8 ft max distance (-40 to +80 deg C) 25ft cable per sensor, PW w/pre-wire connector

• *QTY 1: Ground wire 14 AWG PVC stranded green w/yellow stripe 600V

• QTY 2: CLIMAVUE50-17-PT, Compact digital SDI-12 Weather Sensor, w/ 17ft cable per sensor, w/ tinned wires

• QTY 4: SoilVUE10-U-L125-PT-10: TDR Soil Moisture Profile Sensor w/ user defined 125ft cable per sensor w/ tinned wires, 1m length w/ 9 depths

• QTY 4: SoilVUE10-U-L225-PT-10: TDR Soil Moisture Profile Sensor w/ user defined 225ft cable per sensor w/ tinned wires, 1m length w/ 9 depths

Data Logging and Control Components

• *QTY 1: CR1000X Measurement & Control Datalogger, -40 to +70 deg C, SW standard 3yr warranty, Calibration

• QTY 3: CR1000X Measurement & Control Datalogger, -40 to +70 deg C, SW standard 3yr warranty, Calibration

• *QTY 1: 2GB microSD Flash SLC Memory Card

• *QTY 1: SPST Single-Channel Solid State Relay, CRYDOM D1D07

• QTY 3: GRANITE Series 8-Channel Dynamic Vibrating Wire Analyzer, VWIRE305-SD

• QTY 16: SDI-12 Terminal Bus Kit, 33815

Communications Components

• *QTY 1: 4G LTE Cat1 Cellular Module for Verizon (-40 to +80 deg C), 5G 5GB/Mon Data Plan for 1 Years

• *QTY 1: 4G/3G Omni 2dBD Antenna w/Type N female & CSI mounting hardware

• *QTY 1: Bulkhead Surge Protection Installed in Enclosure, Type N to SMA, 700-2700 MHz, 18 inches

• *QTY 1: Antenna Cable RG8 w/2 Type N Male Connectors 10ft per antenna cable

Power Components

• *QTY 1: 84 Ah Power Supply with 14 X 16 in. Enclosure, SC 1 Conduit for Cables, CR CH200

Regulator, MM Tripod Mast Mounting

• *QTY 1: Enclosure Desiccant & Document Holder Installed in Enclosure Lid

• *QTY 1: 90W Solar Panel 25 ft cable per SP90, PW w/Pre-wire connector

Enclosures and Mounting Components

• *QTY 1: Pre-wired Enclosure, 14 X 16 inches, 7 connectors per ENC, 1P One 9-Pin Port, SC 1

Conduit, NE No Cable Entry Seal, MM Tripod Mast Mounting

• *QTY 1: 10 ft Tower w/adjustable Mast and grounding kit, J w/J-Bolt kit

• *QTY 2: Sensor Crossarm w/one CM 210 Mounting Kit, 4 ft

• *QTY 2: Crossarm Brace Kit, NF no special finish

• *QTY 2: Crossarm-to-pole mounting kit

• QTY 2: ClimaVUE50, Mounting pipe kit 17387

Software and Installation Components

• *QTY 1: Real time monitor & control software, Professional Version

• *QTY 1: Admin Datalogger Support Software (server and clients)

• *QTY 8: Datalogger Programing (components with asterisks)

• *QTY 1: Installation (components with asterisks)

Measurement Components

• QTY 1: Single Sensor Terminal Case, Vented w/ Desiccant 5ft per cable -PW w/Pre-Wire

Connector

• QTY 10: Watermark Soil Matric Potential Block for Multiplexer, 253-L33, 33ft cable per sensor

• QTY 1: Texas Electronics Rain Gage 0.01 inch (0.254mm) Tip w/6 inch Orifice 33ft cable per sensor -PT w/Tinned Wires

• QTY 2: HFP01SC-L33-PT: Hukseflux Self Calibrating Soil Heat Flux Plate 33ft cable

• QTY 10: 105E-L33 Type E Thermocouple Burial Probe, 33ft cable per probe

• QTY 10: CS655 12 cm Water Content Probe, w/ 33Ft cable per probe, PT W/Tinned Wires, DS

SDI-12 Address=0

• QTY 2: CLIMAVUE50-17-PT, Compact digital SDI-12 Weather Sensor, w/ 10ft cable per sensor, w/ tinned wires

• QTY 2: ClimaVUE50, Mounting pipe kit 17387

• QTY 4: SoilVUE10-U-L125-PT-10: TDR Soil Moisture Profile Sensor w/ user defined 125ft cable per sensor w/ tinned wires, 1m length w/ 9 depths

• QTY 4: SoilVUE10-U-L225-PT-10: TDR Soil Moisture Profile Sensor w/ user defined 225ft cable per sensor w/ tinned wires, 1m length w/ 9 depths

• QTY 4: SOILVUE10-17-PT-10, TDR Soil Moisture Profile Sensor, 17ft cable per sensor, PT, 1m length w/ 9 depths

Data Logging and Control Components

• QTY 2: VOLT16-SD: GRANITE Series 16- or 32- Channel 5V Analog Input Module, SD

Standard Duty

• QTY 4: GRANITE Series 8-Channel Dynamic Vibrating Wire Analyzer, VWIRE305-SD

• QTY 2: SC-CPI-ST-SW: Datalogger Serial to CPI Interface

• QTY 16: SDI-12 Terminal Bus Kit, 33815

• QTY 4: CR1000X Data Logger, Calibration, ST -40 to +70C

• QTY 6: RS-232 SC32B Converter

• QTY 3: AM16/32B, Multiplexer AM16/32B, ST -25 to +50C

• QTY 3: CR6-NA-ST0SW-CC, Measurement and Control Datalogger, options: Temperature ST -

40 to +70C

• QTY 6: CPI/RS-232 Data Cable, RJ45 to DB9 Male

• QTY 6: RJ45 Male to Terminal Dongle Data Cable

• QTY 3: Hinged Enclosure Stack Mounting Kit

• QTY 1: AM25T, Multiplexer

• QTY 1: LoggerNet support software

• QTY 1: CR1000X-NA-STSW-CC, Measurement & Control Datalogger, NA, ST -40 to +70C

• QTY 1: 12V Charging Regulator (-40 to +60C)

• QTY 1: 10A External Battery Cable for CH150

Enclosures & Mounting Components

• QTY 2: CM204: Sensor Crossarm w/one CM210 Mounting Kit, 4ft

• QTY 2: CMB200-NF: Crossarm Brace Kit, NF

• QTY 2: CM202: Sensor Crossarm w/ one CM210 Mounting Kit, 2ft

• QTY 2: QST6-C: 6ft Quick-Setup Tripod for Temporary Installations w/Hard Carrying Case

• QTY 2: 33834: QST Guy kit

• QTY 2: 35356: QST6 9-Inch T-Handle Screw Anchor Kit (Qty 3)

• QTY 2: DAQCASE15: Data Acquisition (DAQ) Laboratory & Field Case, 10 x 15 Inches

• QTY 2: 29370: CPI Network Kit

Communications Components

• QTY 2: 4G LTE Cat1 Cellular Module for Verizon (-40 to +80 deg C), 5G 5GB/Mon Data Plan for 1 Years

• QTY 2: 4G/3G Omni 2dBD Antenna w/Type N female & CSI mounting hardware

• QTY 2: Bulkhead Surge Protection Installed in Enclosure, Type N to SMA, 700-2700 MHz, 18 inches

• QTY 2: Antenna Cable RG8 w/2 Type N Male Connectors 10ft per antenna cable

The items denoted with an asterisk shall be delivered to:

MCAS Camp Pendleton Environmental Department Building 23171, Second Deck, ATTN: Diane Walsh Camp Pendleton, CA 92055-5151

All other equipment shall be delivered to:

Engineer Research and Development Center Geotechnical and Structures Laboratory ATTN: Lucas Walshire 3909 Halls Ferry Rd.

Vicksburg, MS 39180

Quotes shall include unit pricing for all items and must include FOB shipping. The offeror shall also provide a schedule for delivery and installation of the required system. All equipment shall be installed and fully operational for acceptance by the Government by 31 December 2022.

Figure 1. Red line indicates where physical gage is located.

Approximate Location of New System