DOR_RiverGageMonitoringandObservation.pdf

Description of Requirement Atmospheric and River Elevation monitoring Equipment Purchase

May 2022

The Geotechnical and Structures Laboratory (GSL) of the U.S. Army Engineer Research and Development Center (ERDC) at Waterways Experiment Station requires highly accurate, reliable measurements and observations of the river water levels and atmospheric conditions. GSL requires ability to purchase additional equipment as an option when determined necessary.

The monitoring equipment necessary for this project includes the ability to measure water surface elevation from a given datum, camera for visual monitoring, lighting in support of the camera and existing staff gage, datalogger, and weather station. The equipment needs to be mounted on a bridge above a river channel on Marine Corps Air Station (MCAS) Camp Pendleton, California. A software package is needed for data retrieval and monitoring of equipment health. Technical support in the form of initial programming and installation incidental at the site is needed. The contractor will need to install the gage at MCAS Camp Pendleton. The vendor must be able to provide long-term technical support through the system’s design life.

Basic equipment and ancillary components required are as follows (components in the base requirement denoted with an asterisk will be delivered to MCAS Camp Pendleton):

Requirement:

Measurement Components

• *QTY 1: Wind Monitor 15ft cable per sensor (PW w/pre-wire connector)

• *QTY 1: 1x1 inch Nu-Rail Crossover Fitting

• *QTY 1: Texas Electronics Rain Gage 0.01 inch, tip w/6 inch orifice 15ft cable per sensor -PW w/prewire connector

• *QTY 1: CM270: TE525, TE525MM, or TE525WS Rain Gage Mounting Kit

• *QTY 1: CSL Digital Temperature/RH Sensor, w/M12 Connector, 17 w/17ft per sensor, PW w/Pre-wire Connector

• *QTY 1: METSPEC 10-Plate Solar Radiation Shield for Large Sensors

• *QTY 1: CSC Outdoor Observation & Surveillance Field Camera (-40 to 60 deg C), R2 w/RS-

232 comms

• *QTY 1: CC Camera or PWD22 mounting kit

• *QTY 1: CCFC Power & I/O Cable 15ft per cable, PW w/Pre-wire connector

• *QTY 1: Radar Water Level Sensor, 114.8 ft max distance (-40 to +80 deg C) 25ft cable per sensor, PW w/pre-wire connector

• *QTY 1: Ground wire 14 AWG PVC stranded green w/yellow stripe 600V

• QTY 2: CLIMAVUE50-17-PT, Compact digital SDI-12 Weather Sensor, w/ 17ft cable per sensor, w/ tinned wires

• QTY 4: SoilVUE10-U-L125-PT-10: TDR Soil Moisture Profile Sensor w/ user defined 125ft cable per sensor w/ tinned wires, 1m length w/ 9 depths

• QTY 4: SoilVUE10-U-L225-PT-10: TDR Soil Moisture Profile Sensor w/ user defined 225ft cable per sensor w/ tinned wires, 1m length w/ 9 depths

Data Logging and Control Components

• *QTY 1: CR1000X Measurement & Control Datalogger, -40 to +70 deg C, SW standard 3yr warranty, Calibration

• QTY 3: CR1000X Measurement & Control Datalogger, -40 to +70 deg C, SW standard 3yr warranty, Calibration

• *QTY 1: 2GB microSD Flash SLC Memory Card

• *QTY 1: SPST Single-Channel Solid State Relay, CRYDOM D1D07

• QTY 3: GRANITE Series 8-Channel Dynamic Vibrating Wire Analyzer, VWIRE305-SD

• QTY 16: SDI-12 Terminal Bus Kit, 33815

Communications Components

• *QTY 1: 4G LTE Cat1 Cellular Module for Verizon (-40 to +80 deg C), 5G 5GB/Mon Data Plan for 1 Years

• *QTY 1: 4G/3G Omni 2dBD Antenna w/Type N female & CSI mounting hardware

• *QTY 1: Bulkhead Surge Protection Installed in Enclosure, Type N to SMA, 700-2700 MHz, 18 inches

• *QTY 1: Antenna Cable RG8 w/2 Type N Male Connectors 10ft per antenna cable

Power Components

• *QTY 1: 84 Ah Power Supply with 14 X 16 in. Enclosure, SC 1 Conduit for Cables, CR CH200

Regulator, MM Tripod Mast Mounting

• *QTY 1: Enclosure Desiccant & Document Holder Installed in Enclosure Lid

• *QTY 1: 90W Solar Panel 25 ft cable per SP90, PW w/Pre-wire connector

Enclosures and Mounting Components

• *QTY 1: Pre-wired Enclosure, 14 X 16 inches, 7 connectors per ENC, 1P One 9-Pin Port, SC 1

Conduit, NE No Cable Entry Seal, MM Tripod Mast Mounting

• *QTY 1: 10 ft Tower w/adjustable Mast and grounding kit, J w/J-Bolt kit

• *QTY 2: Sensor Crossarm w/one CM 210 Mounting Kit, 4 ft

• *QTY 2: Crossarm Brace Kit, NF no special finish

• *QTY 2: Crossarm-to-pole mounting kit

• QTY 2: ClimaVUE50, Mounting pipe kit 17387

Software and Installation Components

• *QTY 1: Real time monitor & control software, Professional Version

• *QTY 1: Admin Datalogger Support Software (server and clients)

• *QTY 8: Datalogger Programing (components with asterisks)

• *QTY 1: Installation (components with asterisks)

Measurement Components

• QTY 1: Single Sensor Terminal Case, Vented w/ Desiccant 5ft per cable -PW w/Pre-Wire

Connector

• QTY 10: Watermark Soil Matric Potential Block for Multiplexer, 253-L33, 33ft cable per sensor

• QTY 1: Texas Electronics Rain Gage 0.01 inch (0.254mm) Tip w/6 inch Orifice 33ft cable per sensor -PT w/Tinned Wires

• QTY 2: HFP01SC-L33-PT: Hukseflux Self Calibrating Soil Heat Flux Plate 33ft cable

• QTY 10: 105E-L33 Type E Thermocouple Burial Probe, 33ft cable per probe

• QTY 10: CS655 12 cm Water Content Probe, w/ 33Ft cable per probe, PT W/Tinned Wires, DS

SDI-12 Address=0

• QTY 2: CLIMAVUE50-17-PT, Compact digital SDI-12 Weather Sensor, w/ 10ft cable per sensor, w/ tinned wires

• QTY 2: ClimaVUE50, Mounting pipe kit 17387

• QTY 4: SoilVUE10-U-L125-PT-10: TDR Soil Moisture Profile Sensor w/ user defined 125ft cable per sensor w/ tinned wires, 1m length w/ 9 depths

• QTY 4: SoilVUE10-U-L225-PT-10: TDR Soil Moisture Profile Sensor w/ user defined 225ft cable per sensor w/ tinned wires, 1m length w/ 9 depths

• QTY 4: SOILVUE10-17-PT-10, TDR Soil Moisture Profile Sensor, 17ft cable per sensor, PT, 1m length w/ 9 depths

Data Logging and Control Components

• QTY 2: VOLT16-SD: GRANITE Series 16- or 32- Channel 5V Analog Input Module, SD

Standard Duty

• QTY 4: GRANITE Series 8-Channel Dynamic Vibrating Wire Analyzer, VWIRE305-SD

• QTY 2: SC-CPI-ST-SW: Datalogger Serial to CPI Interface

• QTY 16: SDI-12 Terminal Bus Kit, 33815

• QTY 4: CR1000X Data Logger, Calibration, ST -40 to +70C

• QTY 6: RS-232 SC32B Converter

• QTY 3: AM16/32B, Multiplexer AM16/32B, ST -25 to +50C

• QTY 3: CR6-NA-ST0SW-CC, Measurement and Control Datalogger, options: Temperature ST -

40 to +70C

• QTY 6: CPI/RS-232 Data Cable, RJ45 to DB9 Male

• QTY 6: RJ45 Male to Terminal Dongle Data Cable

• QTY 3: Hinged Enclosure Stack Mounting Kit

• QTY 1: AM25T, Multiplexer

• QTY 1: LoggerNet support software

• QTY 1: CR1000X-NA-STSW-CC, Measurement & Control Datalogger, NA, ST -40 to +70C

• QTY 1: 12V Charging Regulator (-40 to +60C)

• QTY 1: 10A External Battery Cable for CH150

Enclosures & Mounting Components

• QTY 2: CM204: Sensor Crossarm w/one CM210 Mounting Kit, 4ft

• QTY 2: CMB200-NF: Crossarm Brace Kit, NF

• QTY 2: CM202: Sensor Crossarm w/ one CM210 Mounting Kit, 2ft

• QTY 2: QST6-C: 6ft Quick-Setup Tripod for Temporary Installations w/Hard Carrying Case

• QTY 2: 33834: QST Guy kit

• QTY 2: 35356: QST6 9-Inch T-Handle Screw Anchor Kit (Qty 3)

• QTY 2: DAQCASE15: Data Acquisition (DAQ) Laboratory & Field Case, 10 x 15 Inches

• QTY 2: 29370: CPI Network Kit

Communications Components

• QTY 2: 4G LTE Cat1 Cellular Module for Verizon (-40 to +80 deg C), 5G 5GB/Mon Data Plan for 1 Years

• QTY 2: 4G/3G Omni 2dBD Antenna w/Type N female & CSI mounting hardware

• QTY 2: Bulkhead Surge Protection Installed in Enclosure, Type N to SMA, 700-2700 MHz, 18 inches

• QTY 2: Antenna Cable RG8 w/2 Type N Male Connectors 10ft per antenna cable

Quotes must include unit pricing for all items and must include FOB shipping.

The items denoted with an asterisk will need to be shipped as follows:

MCAS Camp Pendleton Environmental Department

Building 23171, Second Deck, ATTN: Diane Walsh Camp Pendleton, CA 92055-5151

All other items should be shipped to:

Engineer Research and Development Center Geotechnical and Structures Laboratory 3909 Halls Ferry Rd.

Vicksburg, MS 39180