W911SA22Q3060 Attachment 6 AT_OPSEC CUI.pdf

CONTRACT REQUIREMENTS PACKAGE ANTITERRORISM/

OPERATIONS SECURITY REVIEW COVERSHEET

Section I.

Purpose of cover sheet: To document the review of the requirements package statement of work (SOW), quality assurance surveillance plan, and any applicable source selection evaluation criteria for antiterrorism (AT) and other related protection matters including, but not limited to AT, operations security (OPSEC), information assurance (IA), physical security, law enforcement, intelligence, and foreign disclosure.

Army policy requirement: A signed AT/OPSEC coversheet is required to be included in all requirements packages except for supply contracts under the simplified acquisition level threshold, field ordering officer actions, and Government purchase card purchases. Command policy may require this form for supply contracts under the simplified acquisition-level threshold.

Mandatory review and signatures: The organizational antiterrorism officer (ATO) must review each requirements package prior to submission to the supporting contracting activity to include coordination with other staff review as appropriate per section II below. If the requiring activity does not have an ATO, the first ATO in the chain of command will review the contract for AT considerations. An OPSEC officer review is also mandatory.

Section II.

Standard Contract Language Provision/Contract Clause Text Applicability and/or Additional SOW Language.

a. If the standard contract or clause language found on page 2 (Section IV) of this form is sufficient to meet specific contract request requirements, check "yes" in the blocks below and include this language in the SOW.

b. If standard contractual text (provisions or clauses) or clause language does not apply, check "no."

c. If the standard SOW language applies, but is not in and of itself sufficient, check "yes" and "SOW" and include both the standard language and additional contract-specific language in the SOW.

d. If standard contractual text or clause language is not desired, but there is related contract-specific language in the SOW, check "no" and "SOW."

Yes No SOW

1. AT level 1 training (general)

3. AT awareness training for U.S.-based contractor personnel traveling overseas

2. Access and general protection policy and procedures

2a. For contractor requiring Common Access Card (CAC)

2b. For contractor not eligible for CAC, but requires access to DOD facility or installation

4. iWATCH training

5. Army Training Certification Tracking System (ATCTS) registration for contractor employees who require access to government information systems

11. Contractor requiring performance or delivery in a foreign country

6. For contracts that require a formal OPSEC program

7. Requirement for OPSEC training

8. Information assurance/information technology training

9. Information assurance/information technology training certification

12. Handling/access to classified information

10. Contractor Authorized to Accompany the Force clause

13. Threat Awareness Reporting Program

Section III. Remarks:

AT Review Signature: I am ATO (Level II) certified and have reviewed the requirements package and understand my responsibilities in accordance with Army Regulation 525-13, Antiterrorism.

Reviewer Name Grade Telephone number Date (YYYYMMDD) Signature

Reviewer Name Grade Telephone number Date (YYYYMMDD) Signature

AT Review Signature: I am OPSEC (Level II) certified and have reviewed the requirements package, and it is in compliance with Army Regulation 530-1, Operations Security.

Requirements Package Title ______________________________________________________ Date: ___________________

Version 2, May 2019

Section IV. Standard Contract Provision/Contract Clause Applicability and/or Additional SOW Language.

1. AT Level I Training. This standard language is for contractor employees with an area of performance within as Army controlled installation, facility or area.

All contractor employees, including subcontractor employees, requiring access to Army installations, facilities, and controlled-access areas shall complete AT Level I awareness training within [insert number of calendar days] calendar days after the contract start date or effective date of incorporation of this requirement into the contract, whichever is applicable. The contractor shall submit certificates of completion for each affected contractor employee and subcontractor employee, to the COR or to the contracting officer, if a COR is not assigned, within [insert number of calendar days] calendar days after completion of training by all employees and subcontractor personnel. AT Level I awareness training is available at the following website: http://jko.jten.mil

2. Access and general protection/security policy and procedures. This standard language is for contractor employees with an area of performance within Army controlled installation, facility, or area. Contractor and all associated sub-contractors employees shall provide all information required for background checks to meet installation access requirements to be accomplished by installation Provost Marshal Office, Director of Emergency Services or Security Office. Contractor workforce must comply with all personal identity verification requirements (FAR clause 52.204-9, Personal Identity Verification of Contractor Personnel) as directed by DOD, HQDA and/or local policy. In addition to the changes otherwise authorized by the changes clause of this contract, should the Force Protection Condition (FPCON) at any individual facility or installation change, the Government may require changes in contractor security matters or processes.

2a. For contractors requiring Common Access Card (CAC). Before CAC issuance, the contractor employee requires, at a minimum, a favorably adjudicated National Agency Check with Inquiries (NACI) or an equivalent or higher investigation in accordance with Army Directive 2014-05. The contractor employee will be issued a CAC only if duties involve one of the following: (1) Both physical access to a DoD facility and access, via logon, to DoD networks on-site or remotely; (2) Remote access, via logon, to a DoD network using DoD-approved remote access procedures; or (3) Physical access to multiple DoD facilities or multiple non-DoD federally controlled facilities on behalf of the DoD on a recurring basis for a period of 6 months or more.

At the discretion of the sponsoring activity, an initial CAC may be issued based on a favorable review of the FBI fingerprint check and a successfully scheduled NACI at the Office of Personnel Management.

2b. For contractors that do not require CAC, but require access to a DoD facility or installation. Contractor and all associated sub-contractors employees shall comply with adjudication standards and procedures using the National Crime Information Center Interstate Identification Index (NCIC-III) and Terrorist Screening Database (TSDB) (Army Directive 2014-05/AR 190-13), applicable installation, facility and area commander installation/facility access and local security policies and procedures (provided by government representative), or, at OCONUS locations, in accordance with status of forces agreements and other theater regulations.

3. AT Awareness Training for Contractor Personnel Traveling Overseas. This standard language required US based contractor employees and associated sub-contractor employees to make available and to receive government provided area of responsibility (AOR) specific AT awareness training as directed by AR 525-13. Specific AOR training content is directed by the combatant commander with the unit ATO being the local point of contact.

4. iWATCH Training. This standard language is for contractor employees with an area of performance within an Army controlled installation, facility or area. The contractor and all associated sub-contractors shall brief all employees on the local iWATCH program (training standards provided by the requiring activity ATO). This local developed training will be used to inform employees of the types of behavior to watch for and instruct employees to report suspicious activity to the COR. This training shall be completed within [insert number of calendar days] calendar days of contract award and within [insert number of calendar days] calendar days of new employees commencing performance with the results reported to the COR NLT [insert number of calendar days] calendar days after contract award.

5. Army Training Certification Tracking System (ATCTS) registration for contractor employees who require access to government information systems. All contractor employees with access to a government info system must be registered in the ATCTS (Army Training Certification Tracking System) at commencement of services, and must successfully complete the DOD Information Assurance Awareness prior to access to the IS and then annually thereafter.

6. For contracts that require a formal OPSEC program. The contractor shall develop an OPSEC Standing Operating Procedure (SOP)/Plan within 90 calendar days of contract award, to be reviewed and approved by the responsible Government OPSEC officer. This plan will include a process to identify critical information, where it is located, who is responsible for it, how to protect it and why it needs to be protected. The contractor shall implement OPSEC measures as ordered by the commander. In addition, the contractor shall have an identified certified Level II OPSEC coordinator per AR 530-1.

7. For contracts that require OPSEC Training. Per AR 530-1 Operations Security, the contractor employees must complete Level I OPSEC Awareness training. New employees must be trained within 30 calendar days of their reporting for duty and annually thereafter.

8. For information assurance (IA)/information technology (IT) training. All contractor employees and associated sub-contractor employees must complete the DoD IA awareness training before issuance of network access and annually thereafter. All contractor employees working IA/IT functions must comply with DoD and Army training requirements in DoDD 8570.01, DoD 8570.01-M and AR 25-2 within six months of appointment to IA/IT functions.

9. For information assurance (IA)/information technology (IT) certification. Per DoD 8570.01-M , DFARS 252.239.7001 and AR 25-2, the contractor employees supporting IA/IT functions shall be appropriately certified upon contract award. The baseline certification as stipulated in DoD 8570.01-M must be completed upon contract award.

10. For contractors authorized to accompany the force. DFARS Clause 252.225-7040, Contractor Personnel Authorized to Accompany U.S. Armed Forces Deployed Outside the United States. The clause shall be used in solicitations and contracts that authorize contractor personnel to accompany US Armed Forces deployed outside the US in contingency operations; humanitarian or peacekeeping operations; or other military operations or exercises, when designated by the combatant commander. The clause discusses the following AT/OPSEC related topics: required compliance with laws and regulations, pre-deployment requirements, required training (per combatant command guidance), and personnel data required.

11. For Contract Requiring Performance or Delivery in a Foreign Country. DFARS Clause 252.225-7043, Antiterrorism/Force Protection for Defense Contractors Outside the US. The clause shall be used in solicitations and contracts that require performance or delivery in a foreign country. This clause applies to both contingencies and non-contingency support. The key AT requirement is for non-local national contractor personnel to comply with theater clearance requirements and allows the combatant commander to exercise oversight to ensure the contractor’s compliance with combatant commander and subordinate task force commander policies and directives.

12. For contracts that require handling or access to classified information. Contractor shall comply with FAR 52.204-2, Security Requirements. This clause involves access to information classified “Confidential,” “Secret,” or “Top Secret” and requires contractors to comply with— (1) The Security Agreement (DD Form 441), including the National Industrial Security Program Operating Manual (DoD 5220.22-M); (2) any revisions to DOD 5220.22- M, notice of which has been furnished to the contractor.

13. Threat Awareness Reporting Program. For all contractors with security clearances. Per AR 381-12 Threat Awareness and Reporting Program (TARP), contractor employees must receive annual TARP training by a CI agent or other trainer as specified in 2-4b.

Purpose of cover sheet: