SOW-OCMM3X.pdf

PERFORMANCE WORK STATEMENT

1. Mechanical Test Lab

9 August 2024

Requiring Activity: Defense Logistics Agency (DLA) Product Test Center (PTC) Division, Mechanical Lab, located at Defense Supply Center Columbus, Columbus, Ohio. Contracting Activity: DLA Contracting Services located at DSCC, Columbus, Ohio.

2. Introduction

This is a description of the Defense Logistics Agency (DLA) Product Test Center Division (PTC), Mechanical Lab, VTM, requirements for the procurement of an Optical Coordinate Measuring

Machine (OCMM). It is the intent here to clearly define all required performance characteristics.

In generating this statement, our objective is to end up with a OCMM which expands our overall testing capability of inspecting delicate parts, in both accuracy and efficiency. Because we want to maximize the ease of use some of the required features listed below will be specific. Our general objective is to minimize any impact to the DLA Product Test Center Division, Mechanical Lab, VTM, operations and our customers as a result of this procurement, especially with regards to test cycle time. This system will decrease time required to inspect delicate parts and remove any human errors possible with current measuring.

3. Background

This machine would increase Mechanical Product Test Center’s (MPTC) measuring efficiency and accuracy, help improve measuring turnaround time, and replace one (1) non-operating S-T Industries OCMM (S-T Industries is no longer in business and there is no support for these aging machine). Most importantly procurement of this machine will increase our current optical measuring capacity as currently the MPTC has one OCMM not operable with no manufacture support for repairs. Not procuring this piece of equipment would leave the MPTC with one (1) inoperable (and unrepairable)

OCMM.

4. Scope

Install and calibrate 1 Optical Coordinate Measuring Machine.

5. Applicable Directives

None

6. Performance Requirements

The Contractor will install, calibrate, and provide training on the new OCMM in the Mechanical Product Test Center listed in Section 9, Place of Performance.

7. Deliverables

One (1) Optical Coordinate Measuring Machine & One (1) Day of In Person Training.

9. Place of Performance

DSCC Columbus Building 9 Section 1 3990 East Broad Street Whitehall, OH 43213

Shipped receivable to Building 17

Marked for Building 9 section 1

Attn: Roger Fleer 614-692-8099

Work to be performed will take place at:

Building 9, Section 1

10. Travel (if applicable)

Contractor is responsible for all necessary travel to the Place of Performance listed in section 9.

11. Invoicing

Payment of invoices will be accomplished by payment through the Defense Finance and Accounting Service. Invoices will be submitted to the Wide Area Workflow (WAWF) system in accordance with Defense Federal Acquisition Regulation Supplement (DFARS) 252.232-7003 Electronic Submission of Payment Requests and Receiving Reports and DFARS 252.232- 7006 Wide Area Workflow Payment Instructions within 10 workdays after the conclusion of each training session.

12. WAWF Acceptance DODAAC#

MPTC is SL0702.

13. Point of Contacts

The Government Contract Officer:

Blair Hartley

(614) 692-6274 Blair.hartley@dla.mil

The Government Contract Officer Representative (COR):

Kyle Palmer Kyle.Palmer@dla.mil 614-692-8860

DLA Land and Maritime Product Test Center, T Office 3990 E. Broad St., Columbus, OH Bldg. 9, Section 1 William Myers 614-692-7074

The Government Technical Representative/Project Manager:

Name: Roger Fleer Phone Number:

(614) 692- 8099 Email Address:

roger.fleer@dla.mil mailto:Kyle.Palmer@dla.mil