N68335-15-R-0210_Questions_and_Answers_11-4-2015.docx

N68335-15-R-0210: Questions & Answers 30 October 2015

QUESTION 1:

We are having an issue identifying information regarding the running gear for the transportation cart. There is a reference to locations of some of the running gear but there is no information regarding a suggested source of supply for the axels/brake/wheels, steering knuckles etc.

ANSWER 1:

The entire front running gear can be procured under P/N 32882-2 from:

Cignys Saginaw Products Corporation 68 Williamson St Saginaw, MI 48601 Phone: (989) 753-1411 Web: Cignys.com

5 November 2015

QUESTION 2:

Per the drawing, the primer required is MIL-P-8585. May MIL-PRF-23377 be used as an alternate number primer?

ANSWER 2:

YES

QUESTION 3:

Per the drawing, the top coat required is MIL-E-7729. May MIL-PRF-85285 be used as an alternate top coat?

ANSWER 3:

YES

QUESTION 4:

Please provide ID PLATE DRAWING SS9016K0487.

ANSWER 4:

See attached for the requested SS9016 page.

QUESTION 5:

Please provide CABLE DRAWING SS9090D09626.

ANSWER 5:

See attached for the requested SS9090 spec. This was replaced by SS9091, which is an export controlled drawing. If you would like to receive drawing SS9091, please send your request to receive it with your approved DD2345 to Shannan Germond at shannan.germond@navy.mil.

QUESTION 6:

Which running gear should be used for the 65700-70018-044? Is a manufacturer allowed to make running gear of his own design - if accompanied by detailed drawings?

ANSWER 6:

The running gear that must be used is P/N 42750-4 from Cygnys Saginaw. The manufacturer shall not make their own design. Contact information is below:

Terry Nagy Estimating / Customer Support Cignys, Saginaw 68 Williamson St.

Saginaw, MI 48601 Ph: 989-753-1411 Ext. 1104 Fx: 989-753-4386 tnagy@cignys.com

QUESTION 7:

Can ASTM A-36 steel be used as an alternate to the1010 steel called out on the drawing?

ANSWER 7:

YES