N00033-12-R-2002_A0002.doc

SECTION SF 30 BLOCK 14 CONTINUATION PAGE

The following items are applicable to this modification:

A0002 A. Sections C and L of the solicitation are amended to reflect changes to the vessel draft requirements and the dimensions of the small boats to be carried aboard. Attachment C is replaced to reflect the change to the dimensions of the small boats to be carried aboard.

1. The maximum navigational draft of the vessel is increased to 25ft from 15ft.

2. The length of the small boats to be carried is decreased to 12.5m from 15m.

B. The response to Question 2 provided in Amendment 0001 is hereby rescinded and modified as shown below:

Q2.

The vessel specifications stipulated in Section C-2.4 requires a maximum draft of 15 ft. Will the Government accept a vessel that has a deeper laden draft but offers a significantly greater speed?

A2.

The maximum vessel draft is 25 ft, and Section C-2.4 is amended to reflect the higher maximum draft.

SUMMARY OF CHANGES

Additions and insertions to the sections shown below are in bold. Deletions are shown with a strikethrough.

SECTION C - DESCRIPTIONS AND SPECIFICATIONS

The following have been modified:

PERFORMANCE WORK STATEMENT

C-2.0

VESSEL REQUIREMENTS

C-2.4 Maximum Draft: 15ft25ft (navigational draft)

C-2.9 Deck Space Requirements. The Contractor shall provide a minimum of 3,600 square feet of open deck to accommodate the following GFE:

C-2.9.2 Equipment Stowage Space. The Government will provide eight (8) 20' x 8.7' x 8' (LWH) containers, four (4) 15m12.5m x 3m craft, and one (1) standard 108" x 88" (LXW) ISU box with a minimum of 5' wide walkways between container doors and around the craft. Access to all containers, box, and craft shall be from the deck level or internal storage area to accommodate eight (8) (20’ x 8.7’ x 8’) (LWH) containers. The Contractor shall provide power for the ISU and five (5) containers in the following circuit sizes and quantities: 110v, 60Hz, 10A and three (3) 110v, 60Hz, 20A, per container. The Contractor shall provide power for the remaining three (3) containers in the following circuit sizes and quantities: 60A service (220/110v, 3-phase, 60Hz).

C-2.13 Small Boat Launch, Recovery and Storage System. The Contractor shall provide redundant launch and recovery capabilities for four (4) 15m12.5m x 3m craft with a minimum of 2m draft. The launch and recovery systems shall be capable of lifting/supporting 30,000 pounds (includes boat, personnel and equipment) per small boat. The Contractor shall also provide:

- Two (2) 110v 30 A outlets near the launch and recovery system. Each outlet should be sealed to prevent salt water intrusion.

- A freshwater supply/hose near the launch and recovery system.

- The ability to launch or recover up to four (4) small boats in ten (10) minutes or less per boat.

- Small boat fueling capability at each stowage position.

- Capacity for 8,000 gallons MOGAS

- Storage for one (1) ISU 90 Mechanic Pallet 8’ x 9’ x 8’ (LWH) Small boat stowage locations require access to either the ship's crane or a smaller crane capable of 2,000 lb lift capacity or a 10' (w) x 18' (h) rolling overhead chain hoist 2,000 LB capacity (ability to pull engines inside).

SECTION L - INSTRUCTIONS, CONDITIONS AND NOTICES TO BIDDERS

The following have been modified:

SECTION L

L-7 GENERAL PROPOSAL REQUIREMENTS

L-7.1.2 Volume I should contain the following, with no pricing information:

Title Page, Cover Letter, Table of Contents The title page shall meet the requirements of FAR 52.215-1(c)(2). If the offeror wishes to restrict disclosure of information in its proposal, it may include the legend permitted by FAR 52.215-1(e). Although a cover letter is not required, offerors may submit one, and it should be placed after the title page. A table of contents shall be provided after the title page (and cover letter, if applicable), listing the chapters, sections, subsections, page numbers, etc.

Completed Specialtime Boxes Offerors shall provide Specialtime Boxes identifying the vessel and providing the Offeror’s DUNS, CAGE, and TIN. Offerors shall complete and provide Boxes 2, 3, 7 – 12, and 23 – 64 from Part B of this solicitation. Offerors shall include in their submission a fuel grade from the list of fuel grades in Section M-2.3 of the solicitation. Offerors shall include two dates in Box 24; (1) the earliest date on which the proposed vessel could commence performance as outlined in F-1.1, and (2) the estimated date on which the vessel will be ready for delivery as outlined in F-1.2.

Technical Proposal

Offerors shall fully describe the vessel proposed for this contract. Offerors must address how the vessel meets the minimum vessel requirements in the solicitation and attachments. Offerors shall submit detailed plan view ship drawings.

The technical proposal must demonstrate compliance with the following portions of Section C:

- Four (4) server racks (GFE)

- Two (2) desks (CFE)

The room shall have the following characteristics:

- Two (2) CAT-VI patch panels (CFE)

- (2) desks (CFE)

- Four (4) 30A circuits (CFE)

- Four (4) 20A circuits (CFE)

- Two (2) 110v 30 A outlets near the launch and recovery system. Each outlet should be sealed to prevent salt water intrusion.

- A freshwater supply/hose near the launch and recovery system.

- The ability to launch or recover up to four (4) small boats in ten (10) minutes or less per boat.

- Small boat fueling capability at each stowage position.

- Capacity for 8,000 gallons MOGAS

- Storage for one (1) ISU 90 Mechanic Pallet 8’ x 9’ x 8’ (LWH)

- Small boat stowage locations require access to either the ship's crane or a smaller crane capable of 2,000 lb lift capacity or a 10' (w) x 18' (h) rolling overhead chain hoist 2,000 LB capacity (ability to pull engines inside).

(End of Summary of Changes)