Questions

Question regarding Solicitation HSCG38-12-Q-200079

(1) Table top - should it be grated such as subway grating, or expanded metal, or bar stock welded so that your parts would actually rest on the edge.

The table top should be expanded metal grating with a rubber removable mat to protect parts.

(2) The side height - between 15 and 20 inches, is this from table top down or is this from table top up? If this is table top down the side all the way around, then should there be a lip around the table top so that parts may not fall from edge of table?

The side height from top of table to top of side removable panel needs to be between 15 and 20 inches without any lip.

(3) Material that table should be made from, example low carbon steel, stainless, or aluminum?

Table should be made out of low carbon steel

(4) Power supply for motor---- 230 volt I understand; but shall this be hard wired in to a disconnect, or shall it have a twist lock male plug on end of SOOW cord. How long does cord need to be? Or will you direct hook up to panel on table?

The motor should have a disconnect mounted on the motor or be part of the motor housing. Cord and wall plug are not required (Government will provide).

(5) Casters shall be 2 rigid and 2 swivel I would imagine?

Yes, casters shall be swivel on one end and rigid on the other.

(6) Naturally we will do a drawing before all work is started do we need to send to you first for approval before bidding or will this take place after we quote?

All information should be submitted with your quotation before the closing date and time.

You quotation will be evaluated in accordance with the solicitation after the closing date and time.